Philips QC 5390 User Manual [zh]

Register your product and get support at

www.philips.com/welcome

QC5390

23/01/2013

4222.002.8369.1

1

ENGLISH

Introduction

Congratulations on your purchase and welcome

to Philips! To fully benet from the support that

Philips offers, register your product at
www.philips.com/welcome.

General description (Fig. 1)

1 Cutting element
2 On/off button
3 Zoom wheel
4 Handle
5 Charging light
6 Socket for appliance plug
7 Small comb
8 Large comb
9 Barber comb (QC5390/80 only)
10 Scissors (QC5390/80 only)
11 Adapter
12 Appliance plug
13 Pouch (QC5390/80 only)
14 Cleaning brush

Important

Read this user manual carefully before you use
the appliance and save it for future reference.

Danger

2 3 4

- Make sure the adapter does not get wet (Fig. 2).

Warning

- Check if the voltage indicated on the adapter
corresponds to the local mains voltage before
you connect the appliance.

- The adapter contains a transformer. Do not cut

5 6 7

off the adapter to replace it with another plug,
as this causes a hazardous situation.

- This appliance is not intended for use by
persons (including children) with reduced

42

39

physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction

8 9 10

concerning use of the appliance by a person
responsible for their safety.

- This appliance is not intended for use by
children. Children should be super vised
to ensure that they do not play with the
appliance.

11 12 13

- Always check the appliance before you use it.
Do not use the appliance if it is damaged,
as this may cause injury.

Caution

- Use, charge and store the appliance at a
temperature between 5°C and 35°C.

- If the adapter is damaged, always have it
replaced with one of the original type in order
to avoid a hazard.

- If the appliance is subjected to a major change
in temperature, pressure or humidity, let the
appliance acclimatise for 30 minutes before
you use it.

- Do not use the appliance if any of its parts is
damaged or broken, as this may cause injury.

Compliance with standards

- This Philips appliance complies with all

standards regarding electromagnetic elds

(EMF). If handled properly and according to the
instructions in this user manual, the appliance

is safe to use based on scientic evidence

available today.

Preparing for use

Note: You can also use the appliance directly from
the mains when the battery is empty.

Charging

Charge the appliance for at least 1 hour before

you use it for the rst time and after a long period

of non-use.
When the appliance is fully charged, it has a
cordless operating time of up to 60 minutes.
When the charging light lights up orange, the
battery is running low (approx. 10 minutes of
operating time left) and you need to recharge
the appliance.

1 Make sure the appliance is switched off.

2 Insert the appliance plug into the socket of

the appliance and put the adapter in the wall
socket (Fig. 3).

, The charging light starts ashing green to

indicate that the appliance is charging.

, When the batteries are fully charged, the

charging light lights up green continuously.
After 30 minutes the charging light goes out
to save energy.

Using the appliance
Clipping with comb

The appliance comes with 2 combs for different
hair lengths.
The hair length settings are indicated in millimetres
on the comb. The settings correspond to the
remaining hair length after clipping.

- Only use the adapter supplied to charge
the appliance.

1 Select the comb you want to use.

The small comb cuts the hair to a length of 3mm
to 22mm.
The large comb cuts the hair to a length of 23mm
to 42mm.

2 Slide the comb straight into the guiding

grooves on both sides of the handle
(‘click’) (Fig. 4).

3 To set the comb to the desired setting, turn

te zoom wheel to the desired hair length
setting (Fig. 5).

, The display on front of the appliance shows

the selected hair length in millimetres after
cutting.

, After 8 seconds, the display goes out to save

energy. To activate the display again, turn the
zoom wheel or press the on/off button.

Tip: Write down the hair length settings you selected
to create a certain hairstyle as a reminder for future
clipping sessions.

4 Press the on/off button to switch on the

appliance (Fig. 6).

5 Move the appliance through the hair slowly.

Tips

- To clip most effectively, move the appliance
against the hair growth direction.

- Since all hair does not grow in the same
direction, you need to move the appliance
in different directions (upwards, downwards
and across).

- Make sure that the at part of the comb is
always fully in contact with the scalp to obtain
an even result (Fig. 7).

- Make overlapping passes over the head to
ensure that you cut all the hair that needs to
be cut.

6 Regularly remove cut hair from the comb.

If a lot of hair has accumulated in the comb,
remove the comb from the appliance and blow
and/or shake the hair out of it.

Contouring without comb

You can use the appliance without comb to clip
hair very close to the skin (0.5mm) or to contour
the neckline and the area around the ears.

Be careful when you clip without comb because
the cutting element removes every hair it touches.

1 Pull the comb off the appliance.

2 Before you start to contour the hairline

around the ears, comb the hair ends over
the ears.

3 Press the on/off button to switch on the

appliance. (Fig. 6)

4 Tilt the appliance in such a way that only one

edge of the cutting element touches the hair
ends when you shape the contours around
the ears.

Only cut the hair ends. The hairline should be close
to the ear.

5 To contour the neckline and sideburns,

turn the appliance and make downward
strokes (Fig. 8).

Move the appliance slowly and smoothly. Follow
the natural hairline.

Cleaning

Clean the appliance every time you have used it
with the cleaning brush and with warm water
(max. 40°C).

Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids such
as petrol, acetone or ethereal oils to clean the
appliance.

Note: The appliance does not need any lubrication.

1 Switch off the appliance and disconnect

it from the mains.

2 Remove the comb from the appliance and

clean it with the cleaning brush.

3 Brush the outside of the cutting element.

4 Push the centre top end of the cutting

element upwards with your thumb until
it opens (Fig. 9).

5 Use the cleaning brush to remove the

cut hair (Fig. 10).

6 Clean the appliance under a warm running

tap. (Fig. 11)

Replacement

If the adapter is damaged, always have it replaced
with one of the original type in order to avoid
a hazard.
Only replace a damaged or worn comb with an
original Philips replacement comb.
Philips replacement parts (cutting element, combs,
handle and adapter) are available from your Philips
dealer and authorised Philips service centres.

If you have any difculties obtaining replacement

parts for the appliance, contact the Philips

Consumer Care Centre in your country. You nd

its phone number in the worldwide guarantee

leaet.

Environment

- Do not throw away the appliance with the
normal household waste at the end of its life,

but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve
the environment (Fig. 12).

- The built-in rechargeable batteries contain
substances that may pollute the environment.
Always remove the batteries before you

discard and hand in the appliance at an ofcial

collection point. Dispose of the batteries at

an ofcial collection point for batteries. If you

have trouble removing the batteries, you can
also take the appliance to a Philips service
centre. The staff of this centre will remove the
batteries for you and will dispose of them in an
environmentally safe way. (Fig. 13)

Removing the rechargeable batteries

Only remove the rechargeable batteries when
they are completely empty.

Be careful, the battery strips and housing parts
are very sharp.

1 Disconnect the appliance from the mains and

let the appliance run until the motor stops.

2 Check if there are any screws in the back or

front of the appliance. If so, remove them.

3 Remove the back and/or front panel of the

appliance with a screwdriver. If necessary, also
remove additional screws and/or parts until
you see the printed circuit board with the
rechargeable batteries.

4 If necessary, cut the wires to separate the

printed circuit board and the rechargeable
batteries from the appliance.

Guarantee and service

If you need service or information or if you have
a problem, please visit the Philips website at
www.philips.com/support or contact the
Philips Consumer Care Centre in your country.

You nd its phone number in the worldwide
guarantee leaet. If there is no Consumer Care

Centre in your country, go to your local Philips dealer.

Guarantee restrictions

Cutting units are not covered by the terms of the
international guarantee because they are subject
to wear.

简体中文

简介

感谢您的惠顾，欢迎光临飞利浦！
为了您能充分享受飞利浦提供的支持，请在
www.philips.com/welcome 上注册您的产品。

基本说明 (图 1)

1 修剪部件
2 开/关按钮
3 缩放轮
4 手柄
5 充电指示灯
6 产品插座接口
7 小号梳齿
8 大号梳齿
9 理发梳（仅限于 QC5390/80）
10 剪刀（仅限于 QC5390/80）
11 适配器
12 产品插头
13 收纳袋（仅限于 QC5390/80）
14 清洁刷

注意事项

使用本产品之前，请仔细阅读本使用说明书，
并妥善保管以备日后参考。

危险

- 确保电源适配器干燥。 (图 2)

警告

- 在将本产品连接电源前，务必检查当地的
电压是否与电源适配器所标电压一致。

- 电源适配器内含有一个变压器。切勿自行
更换插头，否则将导致严重后果。

- 肢体不健全、精神有障碍及缺乏相关经验
和知识的人（包括儿童）必须在监护人的
监督及指导下使用。

- 小孩不宜使用该产品。应照看好儿童，
确保他们不玩耍本产品。

- 使用前，请务必检查产品。如果产品损
坏，请勿再使用产品，否则可能对人体造
成伤害。

注意

- 为产品充电，须用随产品提供的电源适配
器。

- 必须在 5 摄氏度至 35 摄氏度之间的温度
下使用、存放和为本产品充电。

- 电源软线不能更换，如果软线损坏，此器
具（电源适配器）应废弃。如果电源软线
已损坏，则必须用原装型号进行更换，以
免发生危险。

- 如果产品的使用温度、气压或湿度方面改
变较大，应在使用之前让产品适应 30 分
钟。