ll rights reserved. No part of this publication may by reproduced, stored in a
CONFIGURATION SETUP
retrieval system or transmitted, in any form or by any means, electronics,
mechanical, photocopying, or otherwise without the prior permission of Philips
Dimensions (WxLxH) : 19.4 x 17.1 x 3.2 cm
Weight : 0.86 kg / 1.89 lb
Power supply : DC 9V 2.2A
Power consumption : 30W
Operating temp. range : 0 - 50°C (32 ~ 122°F)
Laser wavelength: 650nm
Video system : NTSC / PAL / AUTO
Frequency response : 20Hz ~ 20KHz ± 1dB
Signal/noise ratio
Audio distortion + noise
Channel separation:
Dynamic range
Output
Audio out (analog audio) Output level: 2V ± 10%
Load impedance:
Video out Output level:
Load impedance:
Current consumption
DC-IN SUPPLY (9.0V)
Battery Charging Current 1.2A typ.
BATT. SUPPLY (7.2V)
Power Off 0A
Playback with TFT on <1.2A typ.
Playback without TFT on <600mA
Battery playtime >2.5hrs
Headphone out (headphone output load 2x16 ohm)
Maximum output power :
Frequency response :20Hz - 20kHz
SNR (A-wght) :80dB typ.
THD (1kHz) :<1%
Left-Right Channel
Separation :
Left-Right Channel
Balance :
7.6 x 6.77 x 1.3 inches
≥85dB
≤ 80(1KHz)
≥85dB
≥80dB
10KΩ
1Vp - p ± 20%
75Ω
>10Mw
32dB typ.
1dB
Supported disc type
DVD video discs:
Video CD:
Audio CD :
In addition, this unit can play DVD+R & DVD+RW and CD-R &
CD-RW that contains audio titles or MP3 or JPEG files.
You cannot play disc other than the above listed.
(CVD, CD-ROM, CD-Extra, CD-G and CD-I discs cannot be
played on this DVD player)
Software upgrades
For the best performance of your DVD Portable. Check
www.philips.com/support for latest software
upgrades available.
To check the software version of your DVD Portable.
1. Press the SETUP key to enter the setup menu.
2. Press RETURN and then press 1, 2 and 3 on the
remote control.
3. The display will show the software version as the
date of which the software was built on the bottom
of the screen. E.g. 050303
Procedure on how to upgrade the software of the DVD
Portable
1. Download the latest software from the Philips
support site.
2. Unzipped the files and then burn it onto a CD ROM
then playback the CD ROM on the DVD Portable.
Pixel specification
<= 3 (max. 0 bright dots and 3 dark dots)
2.0 SAFTETY INSTRUCTIONS
WARNING
GB
All ICs and many other semi-conductors are
susceptible to electrostatic discharges (ESD).
Careless handling during repair can reduce life
drastically.
When repairing, make sure that you are
connected with the same potential as the mass
of the set via a wrist wrap with resistance.
Keep components and tools also at this
potential.
F
ATTENTION
Tous les IC et beaucoup d’autres
semi-conducteurs sont sensibles aux
décharges statiques (ESD).
Leur longévité pourrait être considérablement
écourtée par le fait qu’aucune précaution n’est
prise à leur manipulation.
Lors de réparations, s’assurer de bien être relié
au même potentiel que la masse de l’appareil et
enfiler le bracelet serti d’une résistance de
sécurité.
Veiller à ce que les composants ainsi que les
outils que l’on utilise soient également à ce
potentiel.
Alle ICs und viele andere Halbleiter sind
empfindlich gegenüber elektrostatischen
Entladungen (ESD).
Unsorgfältige Behandlung im Reparaturfall kan
die Lebensdauer drastisch reduzieren.
Veranlassen Sie, dass Sie im Reparaturfall über
ein Pulsarmband mit Widerstand verbunden
sind mit dem gleichen Potential wie die Masse
des Gerätes.
Bauteile und Hilfsmittel auch auf dieses gleiche
Potential halten.
D
WARNUNG
ESD
WAARSCHUWING
NL
Alle IC’s en vele andere halfgeleiders zijn
gevoelig voor electrostatische ontladingen
(ESD).
Onzorgvuldig behandelen tijdens reparatie kan
de levensduur drastisch doen verminderen.
Zorg ervoor dat u tijdens reparatie via een
polsband met weerstand verbonden bent met
hetzelfde potentiaal als de massa van het
apparaat.
Houd componenten en hulpmiddelen ook op
ditzelfde potentiaal.
I
AVVERTIMENTO
Tutti IC e parecchi semi-conduttori sono
sensibili alle scariche statiche (ESD).
La loro longevità potrebbe essere fortemente
ridatta in caso di non osservazione della più
grande cauzione alla loro manipolazione.
Durante le riparazioni occorre quindi essere
collegato allo stesso potenziale che quello della
massa dell’apparecchio tramite un braccialetto
a resistenza.
Assicurarsi che i componenti e anche gli utensili
con quali si lavora siano anche a questo
potenziale.
GB
Safety regulations require that the set be restored to its original
condition and that parts which are identical with those specified,
be used.
NL
Veiligheidsbepalingen vereisen, dat het apparaat bij reparatie in
zijn oorspronkelijke toestand wordt teruggebracht en dat onderdelen,
identiek aan de gespecificeerde, worden toegepast.
F
Les normes de sécurité exigent que l’appareil soit remis à l’état
d’origine et que soient utiliséés les piéces de rechange identiques
à celles spécifiées.
D
Bei jeder Reparatur sind die geltenden Sicherheitsvorschriften zu
beachten. Der Original zustand des Geräts darf nicht verändert werden;
für Reparaturen sind Original-Ersatzteile zu verwenden.
I
Le norme di sicurezza esigono che l’apparecchio venga rimesso
nelle condizioni originali e che siano utilizzati i pezzi di ricambio
identici a quelli specificati.
“Pour votre sécurité, ces documents
doivent être utilisés par des spécialistes agréés, seuls habilités à réparer
votre appareil en panne”.
CLASS 1
LASER PRODUCT
GB
Warning !
Invisible laser radiation when open.
Avoid direct exposure to beam.
S
Varning !
Osynlig laserstrålning när apparaten är öppnad och spärren
är urkopplad. Betrakta ej strålen.
Varoitus !
SF
Avatussa laitteessa ja suojalukituksen ohitettaessa olet alttiina
näkymättömälle laserisäteilylle. Älä katso säteeseen!
3122 110 03420
"After servicing and before returning set to customer perform a
leakage current measurement test from all exposed metal parts to
earth ground to assure no shock hazard exist. The leakage current
must not exceed 0.5mA."
DK Advarse !
Usynlig laserstråling ved åbning når sikkerhedsafbrydere er
ude af funktion. Undgå udsaettelse for stråling.
Plug the AC line cord directly into a 120V AC outlet (do
not use an isolation transformer for this check). Use an
AC voltmeter, having 5000 per volt or more sensitivity.
Connect a 1500 10W resistor,paralleled by a 0.15uF
150V AC capacitor between a knomn good earth ground
(water pipe, conduit, etc.) and all exposed metal parts of
cabinet (antennas, handle bracket, metal cabinet
screwheads, metal overlays, control shafts, etc.).
READING SHOULD NOT EXCEED 0.3V
DVD VIDEO PLAYER
Measure the AC voltage across the 1500 resistor.
The test must be conducted with the AC switch on and
then repeated with the AC switch off. The AC voltage
indicated by the meter may not exceed 0.3V.A reading
exceeding 0.3V indicates that a dangerous potential
exists, the fault must be located and corrected.
Repeat the above test with the DVD VIDEO PLAYER
power plug reversed.
NEVER RETURN A DVD VIDEO PLAYER TO THE
CUSTOMER WITHOUT TAKING NECESSARY
CORRECTIVE ACTION.
AC VOLTMETER
(5000 per volt
or more sensitivity)
Good earth ground
1500
10W
such as a water pipe,
conduit, etc.
AC OUTLET
0.15uF 150V AC
Test all exposed metal.
Voltmeter Hook-up for Leakage Current Check
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
3.0 INSTRUCTIONS FOR USE
1
MENU
Displays MENU page
2
OSD
On Screen Display on / off
3
,,,
Up / down / left / right cursor
OK
Confirms selection
4
Pause playback
Starts / resumes playback
Press twice to stop playback
/
For previous ( ) or next ( )
chapters, tracks or titles
/
Search backward ( ) or search
forward ( )
5
MONITOR
Selection display
To adjust the brightness with
To adjust the color with
To adjust the screen of 16:9
or 4:3 with
6
AV IN/OUT
A/V out
A/V in (AUX)
7
POWER/CHG
Power and charging indicator
IR
Remote sensor
8
OPEN
Opens disc door to insert or
remove disc
9
ON.POWER.OFF
Switches the player on / off
10
11
12
13
14
15
VOLUME
Volume control
PHONES 1 & 2
Headphones jack
AV OUT
Audio/video output jack
AV IN
Audio/video input jack
COAXIAL
Digital Audio output jack
DC IN 9V
Power supply socket
DVD PLAYER LAYOUT
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Remote Control
1 ,,,
Up / down / left / right cursor
OK
Confirms selection
VOLUME
2
Volume control
/
3
For previous ( ) or next ( )
chapters, tracks or titles
Pause playback
Starts / resumes playback
Press twice to stop playback
/
Search backward ( ) or search
forward ( )
7 0 - 9
Numeric keypad
8 MUTE
Muting play volume
REPEAT
Repeats chapter / title / disc
9 RETURN
For VCD menu page
ANGLE
Selects DVD camera angle
SUBTITLE
10
Subtitle language selector
LANGUAGE
Language selector
11
MENU
Displays MENU page
4 OSD
On Screen Display on / off
Slow motion
5 AUDIO
Audio langauge selector
ZOOM
Enlarges video image
6 A > B
To repeat or loop a sequence
in a title
PLAY-MODE
Selects play order options
SETUP
12
Enters SETUP menu
INFRA RED PORT
13
BATTERY COMPARTMENT
14
4.0 MECHNICAL INSTRUCTIONS
1. Back View as Fig.1
Remove screws to remove base
Fig.1
2. Disconnect key control wire and 20 pins harness,
Remove screws to dismentle the plate,
Soldered short pattern for laser diode as Fig.2
20 pins harness
key control wire
4. Remove key board and other parts as Fig.5
Fig.5
5. Remove top cover as Fig.6
Fig.6
6. Disconnect speakers and IF board
Remove IF board as Fig.7.
Fig.2
Remove DVD driver and main board as Fig.3,4
3.
Disconnect DVD driver and main board
Fig.3
Remove DVD driver and main board
soldered
Fig.7
Remove TFT shield, HV board and
7.
LCD TFT as Fig.8,9.
Fig.8
Fig.4
Fig.9
5.0 TROUBLESHOOTING & SERVICE TIPS
Procedure to change regioncode
1. Power on player and open DVD Door.
2. Press <Set Up> at Remote Control. In <Set Up Menu> select <Preferences>.