Quick Start Guide
MCD290
What’s in the Box?
You should find these items upon opening the box.
Quick Start Guide
Composite Video Cable
MW antenna User Manual
Quick Start Guide
User Manual
1
Remote control with two
AA batteries
2
1
Connect the speaker cables.
2
Connect the MW antenna.
Tip
See the User Manual for other TV
connection options.
4
AC power cord
3
Connect the composite video cable to a TV.
4
Connect the power cords of the system and TV.
FM wire
antenna
2
3
3
MW loop
antenna
Speaker
(right)
Speaker
(left)
1
4
AC power cord
Setting up the TV
1
Press SOURCE (DISC on the remote) to select disc source.
2
Turn on the TV and set it to the correct Video In channel.
Setting the clock
1
In standby mode, press and hold CLOCK on the system.
2
When the hour digits flash, turn the VOLUME control on the front panel or press
VOLUME +/- on the remote to set the hours.
3
Press CLOCK again and the minute digits flash. Then turn the VOLUME control on the
front panel or press VOLUME +/- on the remote to set the minutes.
4
Press CLOCK again to confirm the time setting.
Setting system menu options
DISPLAY/ST
2 THEATHRE
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
Playing a disc
1
Press OPEN•CLOSE3 to open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜ Make sure the label side of the disc is facing up.
2
Playback will start automatically. If not press PLAY/PAUSEÉÅ.
3
To stop playback, press STOP 9.
Programming and tuning to radio stations
1
Press SOURCE (TUNER on the remote) to select tuner source.
2
Press PROGRAM for more than two seconds to program all available stations in order of
waveband.
3
Press PRESETí/ë until the desired preset station is displayed.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
2005 C Koninklijie Philips Electronics
N.V. All rights reserved.
http://www.philips.com
PDCC-JS/JW-0544
Loading...