Philips MCD288E 12 Quick Start Guide

Tips

– See the User Manual for other TV
connection options.
–For connecting to a Progressive Scan
TV, refer to the user manual for proper
connections and detailed setup.
–Never connect the AC power cord
before connection of the DIN cable to
avoid causing any damage to the set.

AC power

4

Speaker

(right)

1

Connect the speaker (subwoofer) cables.

2

Connect the FM antenna.

3

Connect the A/V cord to a TV.

4

Connect the power cords of the system and TV.

S-VIDEO

IN

AUDIO

TV IN

IN

VIDEO IN

3

1

S-VIDEO
IN

AUDIO

TV IN

IN

VIDEO IN

Speaker

(left)

4

AC power

1 1

2

FM antenna

Setting up the TV

1

Press SOURCE (DISC on the remote control) to select disc source.

2

Turn on the TV and set it to the correct Video In channel.

USB/AUX

DIM

Setting the clock

IMPORTANT!
– To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO POWER
3 seconds or more to switch to normal standby mode first before proceeding with the procedures
below.

2

on the set for

1

In standby mode, press and hold CLOCK on the system.

2

When the hour digits flash, press VOLUME-/+ (VOL+/- on the remote control) to set the
hours.

3

Press CLOCK again and the minute digits flash. Then press VOLUME-/+ (VOL+/- on the
remote) to set the minutes.

4

Press CLOCK again to confirm the time setting.

Setting DVD menu options

IMPORTANT!
If the progressive scan feature is activated but the connected TV does not support progressive
signals or the cables are not connected accordingly, see the user manual for proper progressive
scan setup or deactivate the progressive scan feature as below:

1) Turn off your TV progressive scan mode or turn on to interlaced mode.

2) Press SYSTEM MENU on the remote to exit the system menu and then DISC and “1” to exit
progressive scan.

DIVX (R) VOD

ANALOG AUDIO SETUP

DIGITAL AUDIO SETUP

3D

PICTURE SETTING

HDMI SETUP

Tip

See chapters "Preparations" and "System
Menu Options" in the User Manual for
detailed descriptions.

USB/AUX

DIM