Page 1
1
Quick Start Guide
2
User Manual
Quick Start Guide
MCD149
What’s in the Box?
You should find these items upon opening the box.
Composite Video Cable
15-pin D-Sub cable
AC power cord
FM antenna
Remove the plastic
protective sheet
Remote control with
battery
Quick Start Guide
User Manual
USB cable
Page 2
Tips
2;
DB15 CONNECTOR
TO MAIN UNIT
SPEAKERS 4
AC MAINS ~
1.000
A
AUDIO OUT
L
R
B
- See the User Manual for other TV
connection options.
- Never connect the AC power cord
before connection of the 15-pin D-Sub
cable to avoid causing any damage to
the set.
2
1
Connect the speaker (subwoofer) cables.
2
Connect the FM antenna.
3
Connect the composite video cable to a TV.
4
Connect the power supplies of the system and TV.
FM antenna
3
Speaker
(right)
1
1
4
AC power cord
Speaker
(left)
A To listen to the sound of this DVD Player
through your TV, use the audio cables (white/
red-not supplied) to connect LINE OUT
(L/R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the TV.
B To listen to the sound of your TV through
this DVD player, use a cinch cable (not
supplied) to connect AUX IN on the rear
panel of the DVD player to the
corresponding AUDIO OUT jacks on the TV.
Setting up the TV
1
Press SOURCE (DISC on the remote) to select disc source.
2
Turn on the TV and set it to the correct Video In channel.
Page 3
Setting the clock
2;
2;
ITALIAN
RUSSIAN
DIVX(R) VODDIVX(R) VOD
TV MODE
1
In standby mode, press and hold DISPLAY/CLOCK on the remote control.
2
When the hour digits flash, press VOLUME +/- on the front panel or VOL +/- on the
remote to set the hours.
3
Press DISPLAY/CLOCK again and the minute digits flash. Then press VOLUME +/- on
the front panel or VOL +/- on the remote to set the minutes.
4
Press DISPLAY/CLOCK again to confirm the time setting.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
Setting system menu options
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
Page 4
Playing a disc
1
Push OPEN•CLOSE 0 on the top of the system to open the disc door.
2
Insert a disc with the print side facing up and close the disc door.
3
Playback will start automatically. If not press ÉÅ.
4
To stop playback, press 9.
Programming and tuning to radio stations
1
Press SOURCE (TUNER on the remote) to select tuner source.
4
2
Press PROG/ANGLE for more than two seconds to program all
available stations in order of waveband.
3
Press í/ë until the desired preset station is displayed.
Playing a USB mass storage device
With the system, you can use USB flash memory (USB 2.0 or USB1.1),
USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this system).
1
Insert the USB device’s USB plug into the socket on the front panel of the main set.
2
Press SOURCE once or more (or USB on the remote control) to select USB.
3
Play the USB’s audio files as you do with the albums/tracks on a CD.
Tip
- In USB mode, the system
supports MP3/WMA only.
C Royal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
PDCC-LL/ZC-0737
Loading...