Register your product and get support at
www.philips.com/support
Short user manual
M550
M555
Important safety instructions
Warning
• The Electrical network is classified as hazardous. The
only way to power down the charger is to unplug the
power supply from the electrical outlet. Ensure that the
electrical outlet is always easily accessible.
• Refer to safety information before using the product.
• This product complies with European R&TTE directive
1999/5/EC
• Use only the power supply listed in the user instructions.
• Use only the batteries listed in the user instructions.
• Do not allow the product to come into contact with
liquids.
• Risk of explosion if battery is replaced by an incorrect
type.
• Dispose of used batteries according to the instructions.
• When the handset rings or when the handsfree is
activated, keep the handset away from your ear to
avoid hearing damage.
Overview
1
Earpiece
Loudspeaker
(back of the
handset)
Microphone
In call
Phonebook
Access the redial list.
Increase the volume.
Decrease the volume.
End calls.
Turn the speaker on/off.
Mute/unmute the microphone.
Enter a pause (press and hold).
Standby
Access the main menu.
Access the redial list.
Phonebook
Call log
Make and receive calls.
Make an intercom call (press and hold).
For multi-handset version only.
Switch the handset on or off (press and hold).
Lock the keypad (press and hold).
Make and receive calls.
In menu
Confirm / Select / Enter the option menu.
Cancel
Up / down
Exit menu.
In text input
Delete a character.
Delete all characters (press and hold).
Enter a space.
Switch upper/lower case (press and hold).
Display icons
Find handset
Display icons
The number of bars indicates the connection
status between the handset and base station.
The more bars are shown, the better the signal
strength is.
It remains steadily on when browsing answered
incoming calls in the call log.
It indicates an outgoing call in the redial list.
It flashes when there is a new missed call or when
browsing new missed calls. It remains steadily on
when browsing the missed calls in call log that are
already read.
It flashes when receiving incoming call. It
remains steadily on during a call.
The speaker is on.
The ringer is off.
Answering machine: it flashes when there is
a new message or when the memory is full.
It remains steadily on when the telephone
answering machine is turned on.
Voice messages indicator: flashes for new
messages, is steady for reviewed messages.
* This is network dependent
It displays when you scroll up/down a list or
increase and decrease the volume.
There are more digits on the right. Press to
read.
ECO+
The ECO+ mode is activated.
Connect
2
2
Multi-handset version only.
1
3
Get started
3
Configure your phone
1 The batteries are pre-installed in the handset. Pull the
battery tape off from the batter y door before charging.
2 When using your phone for the first time, you see a
welcome message (country dependent).
3 Set the countr y and language if prompted.
4 Set the date and time.
• If the time is in 12-hour format, press
select [am] or [pm] (country dependent).
/
key to
Charge your phone
Charge 8 hours
Charge your handset by docking it in either direction.
> 75%
50% - 75%
Flashing: low battery
Scrolling: charging in progress
25% - 50%
< 25%
4
Enjoy
Phonebook
Add record
1 Press > [Phonebook] > [Add new].
2 Follow on-screen instructions.
Call from the phonebook
1 Press
2 Select a record and press
Direct access memory
You have 2 direct access memories (Keys 1 and 2).
To dial the saved phone number automatically, press
and hold on the keys in standby mode.
Depending on your country, keys 1 and 2 are
preset to [1_voicemail] (voice mail number) and
[2_info svc] (information service number) of your
network operator respectively (network dependent).
.
.
Call log
Call from the call log
1 Press
2 Select a record and press
View record
Press
Save record
1 Press
2 Follow on-screen instructions.
Delete record
1 Press
2 Follow on-screen instructions.
.
.
> > [View].
> > [Save number].
> > [Delete].
Redial list
Call from the redial list
1 Press .
2 Select a record and press .
Save record
1 Press
2 Follow on-screen instructions.
Delete record
1 Press
2 Follow on-screen instructions.
> > > [Save number].
> > > [Delete].
Telephone answering machine
(for M555 only)
Record an announcement
1 Press > [Answ. Machine] >
[Announcement].
2 Follow on-screen instructions.
Listen to the incoming messages
Press
press to confirm.
Delete an incoming messages
1 When you listen to the message, press
2 Select [Delete], then press to confirm
> [Answ. Machine] > [Play], then
to
enter the options menu.
.
egister additional handsets
You can register up to 3 additional handsets to the
base station.
1 Press > [Services] > [Register].
2 Press and hold on the base station for 5
seconds.
3 Enter the system PIN (0000).
4 Press to confirm the PIN.
»
Registration is complete in less than 2 minutes.
ECO+ mode
It eliminates radiation in standby mode (causes 2
seconds ring delay, 50% shorter standby time).
1 Press > [Phone setup] > [ECO+ mode].
2 Follow on-screen instructions.
Technical data
Battery
• Philips: 2 x AAA NiMH 1.2V Rechargeable
Use only the supplied batteries.
Adapter Base Charger
Philips S003EB06000302 S003IB0600040
Input: 100-240Vac
Output: (i) 6Vdc 0.3A
Phonebook with 100 entries
Call log with 50 entries
Talk time: 16 hours
Standby time: 250 hours
• You can install a DSL (digital subscriber line) lter to
prevent noise and caller ID problems caused by the
DSL interference.
• You can nd the Declaration of Conformity on
www.p4c.philips.com.
550mAh batteries
50/60Hz 0.2A
(ii) 6Vdc 0.2A
Note
100-240Vac
50/60Hz 0.15A
6Vdc 0.4A
Frequently asked questions
No signal bar is displayed on the screen.
• The handset is out of range. Move it closer to the
base station.
• If the handset displays [Register your handset],
register your handset. (See the section on Register
the hands).
If I fail to pair (register) the additional handsets to
the base station, what do I do?
Your base memory is full. Access
> [Register your handset] to unregister the
unused handsets and try again.
I have chosen a wrong language which I cannot
read, what do I do?
1 Press
2 Press to access the main menu screen.
3 The following options will appear on the screen:
4 Select them to access the language options.
5 Select your own language.
My handset is in searching status, what do I do?
• Make sure that the base station has power supply.
• Register the handset to the base station.
• Move the handset closer to the base station.
I cannot change the settings of my voice mail, what
do I do?
The voice mail service is managed by your service
provider but not the phone itself. Contact your
service provider to change the settings.
to go back to the standby screen.
[Phone setup] > [Language]
[Réglages] > [Langue]
[Telefon-Setup] > [Sprache]
[Config. telef.] > [Lingua]
> [Services]
No display
• Make sure the batteries are charged.
• Make sure there are power and phone
connections.
The handset on the charger does not charge.
• Make sure the batteries are inserted correctly.
• Make sure the handset is placed properly on the
charger. The handset event LED flashes for a few
seconds when charging.
• Make sure the docking tone setting is turned on.
When the handset is placed correctly on the
charger, you can hear a docking tone.
• The charging contacts are dirty. Disconnect the
power supply first and clean the contacts with a
damp cloth.
• Batteries are defective. Purchase new ones with
the same specifications.
Bad audio (crackles, echo, etc.)
• The handset is nearly out of range. Move it closer
to the base station.
• The phone receives interference from the nearby
electrical appliances. Move the base station away
from them.
• The phone is at a location with thick walls. Move
the base away from them.
The handset does not ring.
Make sure the handset ringtone is turned on.
The caller ID does not display.
• The service is not activated. Check with your
service provider.
• The caller’s information is withheld or unavailable.
www.philips.com/support
For information, refer to the extended user
documentation online.
This symbol on a product means that the product
is covered by European Directive 2012/19/EU.
2015 © Gibson Innovations Limited.
All rights reserved.
This product has been manufactured by, and is sold
under the responsibility of Gibson Innovations Ltd.,
and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license from Koninklijke Philips N.V.
0168
UMS_M550-555
05_EN_V3.0
WK15324
Loading...