1
Connect
A
Placement
Proper speakers system placement is important to
ensure optimum sound performance.
A Place the center speaker above or close to the TV.
B Place the subwoofer on the floor, at least one metre
away from the TV.
C Place the front speakers at equal disctances from the
TV.
D Place the rear speakers at normal listening ear level.
2
Set up
B
Connect the radio antennas
Keep the antennas away from the electronic devices to
prevent unwanted interference.
FM 75
MW
FM/AM ANTENNA
TO AV SUBWOOFER
HDMI OUT
~
MAINS
R
L
A
B
C
A Connect the FM antenna to the FM jack. Extend the
wire and fix its end to the wall.
B Unfold the AM/MW loop antenna and fix the claw
into the slot.
C Push the tabs and insert the wires into the AM/MW
jacks.
C
Connect the speakers to AV
subwoofer
Connect the various colored plugs from the speakers to
the same colored jacks at the rear of the AV subwoofer.
AV subwoofer (rear)
REAR
LEFT
REAR
RIGHT
FRONT
LEFT
FRONT
RIGHT
CENTER
A
Finding the viewing channel
A Press STANDBY ON on the DVD system.
B Press SOURCE on the DVD system until “DISC”
appears on the display panel.
C Turn on the TV. Use the TV’s remote control to
select the correct viewing channel for the DVD
system.
You should see the blue DVD background on the
TV.
Note To search for the correct viewing channel,
press the Channel Down button on the TV’s remote
control repeatedly (or AV, SELECT,
°
button) until
you see the blue DVD background.
B
Select the display language on the
screen
A Press SETUP.
The { General Setup Page } appears.
General Setup Page
Disc Lock
Display Dim
Program
OSD Language
Screen Saver
DivX(R) VOD Code
English
Espanõl
Brazil Por
B Press T to select { OSD Language } and press X.
C Use TS keys to select a language in the menu and
press OK to confirm.
D Press SETUP to exit.
Note The language set here is only for the menus
that are shown on the TV while operating this DVD
system, not for the DVD disc menu.
There are various setup options (Audio Setup, Video
Setup, Preference Setup) available on this DVD system.
Refer to the user manual for more information.
E
Connect the DVD system to TV
FM 75
MW
FM/MW ANTENNA
TO AV SUBWOOFER
HDMI OUT
~
MAINS
R
L
Pb
A Use the supplied composite video cable to connect
the CVBS jack on this DVD system to the VIDEO IN
jack on your TV.
B Plug in the power cables from the DVD system, AV
subwoofer and TV to the AC power outlets.
Note It is important to connect the DVD system
directly to your TV.
DVD System (rear)
Television ( rear)
F
Connect the audio from TV to DVD
system (optional)
To hear the TV audio through this home theater system,
use the red and white audio cables (not supplied) to
connect the TV IN (R/L) jacks on this DVD system to
the AUDIO output jacks on your TV.
FM 75
MW
FM/MW ANTENNA
TO SUBWOOFER
HDMI OUT
~
MAINS
R
L
AUDIO
OUT
AUDIO IN
Note Press TV on the remote control to get the
sound output from the speakers system when watching
the TV program.
DVD System (rear)
Television ( rear)
To off-air
antenna or
set-top box
D
Connect the AV subwoofer to DVD
system
Use the supplied inter-connect cable to connect TO AV
SUBWOOFER jack and TO DVD SYSTEM jack. Tighten
the screws at the sides to secure the connection.
FM 75
MW
FM/MW ANTENNA
TO AV SUBWOOFER
HDMI OUT
~
MAINS
R
L
TO AV SUBWOOFER
DVD System (rear)
AV subwoofer (rear)
DVD System (rear)
3
Enjoy
DVD HOME THEATER SYSTEM HTS4750
Quick Start Guide
Connect
Set up
Enjoy
1
2
3
What’s in the box?
DVD system
Remote Control
and 2 batteries
User Manual
Composite video
cable
Start disc playback
A Insert a disc into the disc slot with the disc label
facing up.
B Playback will start automatically.
C If the disc menu appears, use TS keys to select an
option in the menu and press PLAY X to start
playback.
D Press STOP x to stop playback.
E Press EJECT Z to remove the disc.
Note When you press PLAY button again, the
playback will resume from its last stopped point. To
start playback from the beginning, you have to press
STOP button two times to cancel the resume mode,
then press PLAY button.
Playback from the USB
A Insert your USB device into the USB port and wait
for the message to appear on the screen.
B Press DISC/USB to access the contents on your
USB device.
C Press OK to start playback.
D To stop playback, press DISC/USB again to switch
to ‘DISC’ mode. You can unplug your USB device
now.
Playback from the portable
audio/HDD player
A Use the supplied MP3 direct cable to connect the
headphone output jack on your portable audio/
HDD player to the MP3 DIRECT jack.
B Press MP3 DIRECT on the remote control.
C Press PLAY on your portable audio/HDD player to
start playback.
Note You can only control the playback features
using your portable audio/HDD player.
Troubleshooting
For more troubleshooting tips, see the user manual.
No picture.
• Press DISC/USB button on the remote control.
• Check the connection to the TV and ensure the plugs are rmly in place.
No sound.
• Check the speaker connections and settings.
• Check the audio connections and press SOURCE button to select the correct input source.
• The center and rear speakers operate only in multi-channel surround mode. Press SURR button to select
multi-channel surround output.
The DVD system does not work.
• Disconnect the power cord from the power outlet for a few minutes. Reconnect the power cord and try again.
1 center, 2 front, 2 rear speakers
and AV subwoofer
FM wire antenna
AM/MW loop
antenna
MP3 direct cable for
portable audio player
Inter-connect
cable
2 Power cables
Need help?
User Manual
See the user manual that cames with your Philips DVD System
Online
Go to www.philips.com/support
2005 C Koninklijke Philips N.V.
All rights reserved.
12 NC 3139 246 21361
www.philips.com