Mini blender
HR 2860
Philips Domestic Appliances and Personal Care
Service Manual
PRODUCT INFORMATION :
The applinace has been equipped with a built-in safety
lock, that prevents it from functioning, if the accessories
have been assembled incorrectly, or have not been
assembled at all.
TECHNICAL DATA :
Motor : universal, radio / TV interference
suppressed
Power consumption : 220 Watt max.
Voltage & frequency : 220 V, 50 Hz
Cordset : 150 cm, double insulated
with moulded on plug
Speed setting : 1 speed
Blender capacity : total jar capacity 0.5 L,
0.4 L effective
Mills capacity : total mill capacity 0.2L,
0.1L effective
Speeds unloaded : blender drive shaft 24750 rpm (max)
Weight in fancy box : 1.48 kg
Dimensions fancy box : 220 mm x 120 mm x 280 mm
(l x w x h)
SERVICE INFORMATION :
The blender coupling (item 5) on the motor shaft has been
provided with a customary left-handed thread.
The blender coupling can be detached by means of a
screwdriver. Block the rotor shaft (after removing the bottom
- item 17) by sticking a screwdriver into the slot of the rotor
shaft and remove the blender coupling by turnig it right sides.
Automatic resettable cut-out (part of item 9)
This appliance is equipped with an automatic thermal cut-off
system. This system will automatically cut off the
supply to the appliance in case of overheating.
If your appliance suddenly stops running:
- Pull the mains plug out of the socket.
- Let the appliance cool down for 30 minutes.
- Put the mains plug into the socket.
- Switch the appliance on again.
power
This product meets the requirements regarding interference suppression on radio and TV.
Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification
After the product has been repaired, it should
function properly and has to meet the safety
requirements as offi cially laid down at this
moment.
4322 277 00981
02/06
Partslist
Pos. Description Service Code
1 Blender cap 9965 000 14352
2 Jar lid 9965 000 14353
3 Jar assy 9965 000 14354
5 Blender coupling 9965 000 14355
6 Housing upper part 9965 000 14356
7 Motor rubber 9965 000 14357
8 Insulation fi lm 9965 000 14358
9 Motor 9965 000 14359
10 Safety switch lever 9965 000 14360
11 Switch spring 9965 000 14361
12 Switch assy 9965 000 14362
13 Housing lower part 9965 000 14363
14 On / Off knob 9965 000 14364
15 Capacitor 9965 000 01057
16 Insulation tubing 9965 000 14365
17 Bottom 9965 000 14366
Pos. Description Service Code
20 Wet mill assy 9965 000 14367
21 Dry mill assy 9965 000 14368
22 Container 9965 000 14369
23 Cover 9965 000 14370
30 Cordset China 9965 000 14371
30 Cordset Hong Kong 9965 000 14372
31 Wire connector for 2 wires 9965 000 01056
32 Cable tie 9965 000 14373
A Screw