Page 1
ENGLISH 4
HQT502
3
Page 2
Important
◗ Make sure that the appliance does not get
wet.
◗ This appliance is only designed for trimming
the human beard.
◗ Keep the appliance out of the reach of
children.
ENGLISH4
Page 3
Preparing for use
C
1 Open the battery holder.Place two
batteries (make sure the + and - poles are
pointing in the right direction).Close the
battery holder again.
Use R6/1.5 Volt batteries.We recommend Philips
Powerlife batteries because of their long life.
When the batteries are empty,do not throw
them away with the normal household waste, but
hand them in at an official collection point.
ENGLISH 5
2
1
Page 4
Trimming
Always comb the beard and/or moustache with a
fine comb before you start trimming.
Do not move the trimmer too fast.Make smooth
and gentle movements.
Trimming with comb attachment
C
1 Slide the adjustment comb to the desired
trimming length setting (see table).
The setting will appear in the window in the
centre of the comb attachment.
ENGLISH6
4
Page 5
B
If you are trimming for the first time, start by using
the maximum trimming length setting: setting 4.
2 Switch the appliance on.
C
3 To trim in the most effective way,move
the trimmer against the direction of hair
growth.Make sure the flat surface of the
comb always stays in contact with the skin.
C
4 If a lot of hair has accumulated in the
comb,remove the comb attachment by
adjusting it to setting 4 and then pulling it
off the appliance.
ENGLISH 7
Page 6
resulting beard length
1.5 mm
3.0 mm
5.0 mm
7.0 mm
setting
1
2
3
4
ENGLISH8
C
5 Blow and/or shake the hair out of the
comb.Readjust the comb to the seleted
setting.
Trimming length setting table
◗ Using setting 1 will result in a unique 'stubble
look'.
4
Page 7
ENGLISH 9
Trimming without comb attachment
Full beards and single hairs
C
1 Remove the comb attachment by adjusting
it to setting 4 and then pulling it off the
appliance.
Never pull at the flexible top of the comb
attachment.Always pull at the bottom part.
2 Switch the appliance on.
C
3 Make well-controlled movements.Touch
the hair lightly with the trimmer.
Page 8
Cleaning
Do not use abrasives,scourers or liquids such as
alcohol,petrol or acetone to clean the appliance.
1 Make sure the appliance is switched off.
2 Remove the comb attachment.
C
3 Open the cutting unit by pushing it
backwards (1).
4 Clean the cutting unit and the inside of the
appliance with the brush supplied (2).
ENGLISH10
1
2
Page 9
ENGLISH 11
C
5 Close the cutting unit by pushing it back
onto the appliance until you hear a click.
Replacing the cutting unit
A worn or damaged cutting unit should only be
replaced with an original Philishave cutting unit,
available from authorised Philips service centres.
1 Open the cutting unit.
CLICK
Page 10
ENGLISH12
2 Remove the old cutting unit by pulling it
upwards.
C
3 Place the two lugs of the new cutting unit
into the guiding slots.
4 Push the cutting unit back onto the
appliance until you hear a click.
Page 11
ENGLISH 13
Service & information
If you need information or if you have a problem,
please visit the Philips Web site at
www.philips.com or contact the Philips Customer
Care Centre in your country (you will find its
phone number in the worldwide guarantee
leaflet).If there is no Customer Care Centre in
your country,turn to your local Philips dealer or
contact the Service Department of Philips
Domestic Appliances and Personal Care BV.
Page 12
4203 000 49021
Loading...