Philips HQ136, HQ132, HQ130 User Manual

HQ136 HQ132 HQ130

1	2
3	4

5

6

7

8

9

10

11

12

13

14

15

16

17

English

Introduction

Congratulations on your purchase and welcome to

Philips!To fully benefit from the support that Philips offers, register your product at www.philips.com/ welcome.

Important

Read this user manual carefully before you use the appliance and save it for future reference.

Warning

-- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

-- Children should be supervised to ensure that they do not play with the appliance.

Caution

-- Keep the appliance dry (Fig. 1).

-- Use and store the appliance at a temperature between 15°C and 35°C.

-- Remove the batteries from the appliance if you are not going to use it for a month or more.

Compliance with standards

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today.

Preparing for use Inserting batteries

The appliance runs on two R6 AA 1.5-volt batteries. Preferably use Philips alkaline batteries.

Make sure that your hands are dry when you insert the batteries.

1Remove the lid of the battery compartment (Fig. 2)

2Place two batteries in the battery compartment (Fig. 3).

Note: Make sure the + and - indications on the batteries match the indications in the battery compartment.

Note:The shaver does not work if the batteries have been placed incorrectly.

3Put the lid of the battery compartment back onto the appliance. First insert the top part of the lid (1) and then press down the bottom part (2) until you hear a click (Fig. 4).

How to avoid damage due to battery leakage

-- Do not expose the appliance to temperatures higher than 35°C.

-- Remove the batteries if you are not going to use the appliance for a month or more.

-- Do not leave empty batteries in the appliance.

Shaving time

Two new batteries offer a shaving time of 60 minutes.

Using the appliance Shaving

Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Shaving on a dry face gives the best results.

1Push the on/off slide upwards to switch on the shaver (Fig. 5).

2Move the shaving heads over your skin. Make both straight and circular movements (Fig. 6).

3Push the on/off slide downwards to switch off the shaver.

4Put the protection cap on the shaver after use to prevent damage to the shaving heads (Fig. 7).

Cleaning and maintenance

Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance.

Regular cleaning guarantees better shaving performance.

For easy and optimal cleaning, Philips Shaving Head Cleaning Spray (type no. HQ110) is available. Ask your Philips dealer for information.

Note: Philips Shaving Head Cleaning Spray may not be available in all countries. Contact the Consumer Care Centre in your country about the availability in your country.

You can also clean the shaver in the following way:

Every week: shaving unit and hair chamber

1Switch off the shaver.

2Clean the top of the appliance with the cleaning brush (Fig. 8).

3Press the release button (1) and remove the shaving unit (2) (Fig. 9).

4Clean the inside of the hair chamber with the cleaning brush (Fig. 10).

5Clean the inside of the shaving unit with the cleaning brush (Fig. 11).

6Put the shaving unit back onto the shaver.

Every two months: shaving heads

1Switch off the shaver.

2Press the release button (1) and remove the shaving unit (2) (Fig. 9).

3To remove the retaining frame, push the sides of the central spring towards each other

(1).Then lift the retaining frame out of the shaving unit (2) (Fig. 12).

4Slide the shaving heads out of the retaining frame (Fig. 13).

Do not mix up the cutters and the guards.

This is essential since each cutter has been ground with its corresponding guard for optimal performance. If you accidentally mix up the sets, it

could take several weeks before optimal shaving performance is restored.

5Clean the cutter with the short-bristled side of the cleaning brush (Fig. 14).

Brush carefully in the direction of the arrow.

6Clean the guard with the cleaning brush (Fig. 15).

7Slide the shaving heads back into the retaining frame and put the retaining frame back into the shaving unit (Fig. 16).

8Put the shaving unit back onto the shaver.

Extra thorough cleaning

For extra thorough cleaning, put the shaving heads in a degreasing liquid (e.g. alcohol) every six months.To remove the shaving heads, follow steps 1 to 4 described above. After cleaning, lubricate the central point on the inside of the guards with a drop of sewing machine oil to prevent wear of the shaving heads.

Replacement

Replace the shaving heads every 2 years or if they are damaged or worn. Replace them with HQ4 Ç Philips shaving heads only.

1Switch off the shaver.

2Press the release button (1) and remove the shaving unit (2) (Fig. 9).

3To remove the retaining frame, push the sides of the central spring towards each other

(1).Then lift the retaining frame out of the shaving unit (2) (Fig. 12).

4Slide the shaving heads out of the retaining frame and replace them with new ones (Fig. 13).

5Put the retaining frame back into the shaving unit.

6Put the shaving unit back onto the shaver.

Accessories

The following accessories are available: -- HQ4 Ç Philips shaving heads.

-- HQ110 Philips Shaving Head Cleaning Spray (not available in China).

Environment

-- Batteries contain substances that may pollute the environment. Do not throw away empty batteries with the normal household waste, but dispose of them at an official collection point for batteries. Always remove the batteries before you discard and hand in the appliance at an official collection point.

-- Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment (Fig. 17).

Guarantee & service

If you need service or information or if you have a problem, please visit the Philips website at www. philips.com or contact the Philips Consumer Care

Centre in your country (you find its phone number

2	4222.002.5009.4