Philips HP2710 User Manual

FEATURES

FULL TWO YEAR WARRANTY

Philips Electronics North America Corporation warrants each new Philips Product, Model HP2710 (except foil and trimmers), against defects in materials or workmanship for a period of two years from the date of purchase, and agrees to repair or replace any defective product without charge.

IMPORTANT: This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable care, the affixing of any attachment not provided with the product or loss of parts or subjecting the product to any but the specified batteries.* Use of unauthorized replacement parts will void this warranty.

PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT PAY FOR WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED REPAIR SERVICE AND WILL NOT REIMBURSE THE CONSUMER FOR DAMAGE RESULTING FROM WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED REPAIR SERVICE.

NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.

In order to obtain warranty service, simply take or ship the product postage prepaid to the nearest Authorized Norelco Service Location. It is suggested that for your protection you return shipments of product by insured mail, insurance prepaid. Damage occurring during shipment is not covered by this warranty.

NOTE: No other warranty, written or oral, is authorized by Philips Electronics North America Corporation.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion and limitations may not apply to you.

*Read enclosed instructions carefully. Manufactured for:

Norelco Consumer Products Company A Division of Philips Electronics North America Corporation 1010 Washington Blvd. Stamford, CT 06912-0015

MADE IN AUSTRIA.

Norelco is a Registered Trademark of Philips Electronics North America Corporation.

Total Body is a Trademark of Philips Electronics North America Corporation.

PHILIPS and Philips Shield are Registered Trademarks of Koninklijke Philips Electronics N.V.

HP2710 Cordless

Wet • Dry Razor

60-Day Money-Back Guarantee

If you are not fully satisfied with your Philips Lady Shave Razor,

Philips will refund you the full purchase price.

The razor must be shipped prepaid by insured mail, insurance

prepaid, and have the sales receipt, indicating purchase price

and the date of purchase, enclosed. The razor must be post-

marked no later than 60 days

after the date of purchase. Philips

reserves the right to verify the purchase price of the razor and limit

refunds not to exceed suggested retail price. Send dated sales

receipt, your complete name and address as indicated below, and

the razor, prepaid to:

Norelco Consumer Products Company

A Division of

Philips Electronics North America Corporation

P.O. Box 1116

Skokie, IL 60076

Please allow 4-6 weeks for delivery of check.

Please Print!

NAME:

ADDRESS:

CITY:

STATE: ZIP:

TELEPHONE NO.: ( )

REASON FOR RETURNING:

Area Code

Give your new Razor a chance!

Like many new products, your Philips Lady Shave

may take a little getting used to. If you are using a

battery razor for the first time, or if you’ve been using

a different brand, your skin may need time to adapt.

Give yourself a little time to practice and determine

the best stroking motions for the best shave.

Use it exclusively for 3 to 4 weeks, or a bit longer

for sensitive skin. If you alternate shaving

or other hair removal methods during this

adjustment period, it may make it more difficult

to adapt to the Philips shaving system.

At first you may not get as close a shave as you

expect, or your skin may become slightly irritated.

This is normal as your skin adjusts. After this adjust-

ment period, you’ll find that you can remove hair with-

out irritating your skin, for a close, smooth shave.

The Philips Lady Shave Razor... the choice for close,

smooth shaving results.

IMPORTANT

leak, remove them carefully. Do not allow bare skin to touch leaking fluid.

8. Do not attempt to recharge alkaline, heavy duty, or regular batteries in a nickel-cadmium battery charger.

9. Dispose of used batteries properly. Do not wrap in metal or aluminum foil. Wrap in newspaper before discarding. Do not incinerate. Batteries may explode if overheated. It is suggested that you contact local town/ city officials to determine proper battery redemption site(s) in your area.

10. Razor is water-safe and can be used in the bath or shower. Do not submerge in water for extended period of time.

SAVE THESE INSTRUCTIONS

When using a battery-operated appliance, basic precautions should always be followed, including the following: Read All Instructions

Before Using This Appliance.

1. Close supervision is necessary when this razor is used by, on, or near children or invalids.

2. Use this razor for its intended household use as described in this manual. Do not use attachments not recommended by Philips Electronics North America Corporation.

3. Never operate this razor if it is not working properly or if it has been dropped or damaged. Return the razor to an Authorized Norelco Service Location for examination and repair.

4. Never drop or insert any object into any opening.

5. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.

6. Always check foil before use. Do not

use this razor with a damaged or broken foil or trimmer, as injury may occur.

7. If razor will not be used on a regular basis, remove batteries to prevent possible damage due to chemical leakage. If batteries do

IMPORTANT SAFETY INSTRUCTIONS

Removable Angled

Shaving Head

Total Body Shaving

System:

Two Trimmers for

longer hairs

Fully Submersible

Cordless-Operates on 2

“AA” 1.5V alkaline or

carbon zinc batteries

(not included)

Protective Cap for

Shaving Head

Cleaning Brush

Foil for legs and

underarms

Easy Slide On/Off

Switch

If you need help, answers or service, please call us at 1-800-243-7884 Or visit our Website at www.philipsonline.com

1. Prepare underarms and other sensitive areas for wet or dry shaving (see BEFORE USING YOUR NE W PHILIPS RAZOR section).

2. Turn Razor on.

3. Lift your arm until skin under arm stretches slightly.

■ For shaving other sensi-

tive areas, stretch skin taut with your fingers.

4. Hold Razor so that Shaving Head is in full contact with the skin. Shave with gentle strokes, using light pressure (Fig. 6).

■ Pressing too hard may

■ Before using, check foil

for wear or damage. If foil shows signs of wear or damage, do not use shaver as injury may occur. Do not use until foil has been replaced.

■ For wet shaving, you

may wish to prepare your skin with soap or shaving cream before shaving.

■ For dry shaving, be cer-

tain that your skin is clean. If you have sensitive skin, you may wish to apply talcum powder before and/or after shaving.

■ When shaving your

legs, underarms or bikini line, it is not necessary to press hard to get a close shave. Pressing too hard may cause skin irritation, and razor will not function properly. In addition, do not use

deodorant or alcohol based lotions immediately before or after shaving. You may, however, want to use talcum powder.

■ Clean Razor regularly

following MAINTENANCE instructions.

■ Do not submerge Razor

in water for extended periods of time.

■ To keep Razor water-

resistant, keep the rubber sealing ring in battery compartment clean and dry. Occasionally you may want to apply a thin coating of petroleum jelly to ring to keep it from drying out.

1. BEFORE USING YOUR NEW PHILIPS RAZOR

After each use, Razor should be quickly cleaned by rinsing under running water or dipping and shaking gently in water.

■ Never immerse Razor in

water while battery compartment is open.

IMPORTANT: DO NOT keep Razor submerged in water for a long period of time.

■ For assistance or the

Authorized Norelco Service Location nearest you, call toll free:

■ Or visit our Website at

www.philipsonline.com.

Authorized Norelco Service Location information is available 24 hours a day, 7 days a week.

6. PRODUCT ASSISTANCE

OIL

■ Your new Philips Razor

requires 2 “AA” 1.5 volt alkaline or carbon zinc batteries.

■ Be sure hands and

Razor are dry before inserting or replacing batteries.

1. Be certain Razor is in Off position.

2. Hold Razor upside down and remove Battery Compartment cover by

grasping cover on both sides. Slide cover away from Razor body (Fig. 1).

3. Insert batteries as shown, making sure the (+) and (-) markings on ends of batteries match those on inside of compartment (Fig. 2).

4. Replace Battery Compartment cover by sliding cover back onto Razor body (Fig. 3).

2. INSTALLING OR CHANGING BATTERIES

1. Prepare legs for wet or dry shaving (see BEFORE

USING YOUR NEW PHILIPS RAZOR).

2. Turn Razor on (Fig. 4).

3. Hold Razor so that Shaving Head is in full contact with your skin. Shave with smooth,

steady strokes, against the direction of hair growth (Fig. 5).

■ Pressing too hard may

cause skin irritation.

■ Practice is best for opti-

mum results.

4. Turn Razor Off.

3. SHAVING LEGS

cause skin irritation, and Razor will not function properly.

5. Do not use deodorant or alcohol based lotions immediately before or after shaving. You may, however, want to use talcum powder.

6. Turn Razor Off (Fig. 7).

4. SHAVING UNDERARMS

4. SHAVING UNDERARMS (CONT.)

IMPORTANT

■ It is recommended that

you replace your shaving foil once a year.

■ Switch Razor Off before

cleaning.

■ Never clean, remove, or

replace Shaving Head while motor is on.

■ Do not apply pressure

or touch Shaving Head with hard objects as this may dent or damage foil or trimmers. If damage occurs, replace foil.

■ Check foil regularly.

■ Replace foil once a year.

5. MAINTENANCE/CLEANING INSTRUCTIONS A. AFTER EACH USE B. ONCE A MONTH-

CLEANING SHAVING HEAD

IMPORTANT: DO NOT

apply pressure to Shaving Foil.

1. To remove Foil Guard, simultaneously press in small buttons on both sides of Razor on Angled Shaving Head while pulling head up and out (Fig. 9). Rinse under water to remove hairs (Fig. 10).

■ Hold Shaving Foil by

plastic housing only -

Shaving Foil is very delicate and should not be handled. If foil becomes worn or damaged, replace it.

2. Remove Cutter Block as shown (Fig. 11). Hairs can be removed from Cutter Block by using a soft brush, by lightly blowing out hairs, or running under water (Fig. 12).

NOTE: Avoid using brush on Cutter Block as this may cause damage.

■ Body of Razor and

Shaving Head, including Shaving Foil, may be rinsed under running water to remove hairs (Fig. 13).

3. Be sure all parts are dry before reassembling.

NOTE: Razor will not operate if batteries are inserted incorrectly.

■ If Razor will not be used

on a regular basis, remove batteries.

■ Never use a razor with a

damaged or broken foil.

■ For best shaving perfor-

mance, it is suggested to lightly oil Shaving Head regularly by spreading a drop of mineral oil over the foil and trimmers (Fig. 8). If this does not improve the performance of your razor, it may be time to change foil.

■ If Razor will not be used

on a regular basis, remove batteries.

■ Do not use cloth or

towel to dry Shaving Foil or Cutter Block; allow to air dry.

4. Replace Cutter Block and Shaving Foil by gently pressing back into position on Shaving Head.

■ Hold Razor Head by

plastic housing only.

NOTE: Use cold or lukewarm water. Never use cleaners such as alcohol or nail polish remover.

1-800-243-7884