Philips Heartstart MRx, Heartstart XL+ Defibrillator Installation Manual

Philips Heartstart MRx and Heartstart XL+ Defibrillator – Flush Wall Mount Kit

Item #

Description

Qty

1

Wall Mount

1

2

Channel Cover (includes instructions)

1 3 1/8'' Hex Wrench

1

1

The purpose of this guide is to:

Installation Guide

1. Describe installation of the Mounting Assembly (page 2).

2. Describe mounting of defibrillator on the Mounting Assembly (page 2).

Parts Reference

The following parts and hardware are included with this installation kit (see photo for part; hardware not shown):

Tools Required

• 1/8'' hex wrench (provided)

DU-PH-0050-03 Rev D 3/27/12 GCX Corp. Page 1 of 3

Installing Mounting Assembly in Channel

Insert Slide

Set Screws (2)

Plunger/Latch Open

Latch Closed

1. Insert channel slide (rear of Mounting Assembly) in Channel. Slide Mount to
desired position in channel and tighten two (2) set screws (right) with 1/8'' hex
wrench provided.

Mounting the Heartstart MRx

1. Pull Plunger and open the Bed Hook Latch (below left).

2. Hook the bed hook (rear of Heartstart MRx) over the Mounting Bar (below center).

3. Close the Bed Hook Latch over the bed hook, ensuring that the Plunger snaps snaps into clearance hole (below right).

DU-PH-0050-03 Rev D 3/27/12 GCX Corp. Page 2 of 3