Service
Service
Service
UV-A Solarium
HB 541/A
HB 542/A
|
Service Manual 4822 729 21606 is |
Domestic Appliances and Personal Care |
herewith cancelled. |
Service Manual
PRODUCT INFORMATION
HB541 |
: |
8 x TL100W/Cleo |
HB542 |
: |
10 x TL100W/Cleo |
Input power HB 541 |
: |
approx. 920W |
HB 542 |
: |
approx. 1150W |
Starter |
: |
S12 |
Ballast |
: |
100W/230V |
Timer |
: |
60 mins Eaton |
Radiation area |
: |
174 x 56 cm |
Radiation distance |
: |
20 cm |
Height adjustment |
: |
between 66-96 cm |
Protecting goggles |
: |
HB072 - 4822 690 80147 |
Output UVX36 meter |
: |
HB541 >3.8 mW/cm2 at 20 cm |
|
: |
HB542 >4.6 mW/cm2 at 20 cm |
HINTS FOR REPAIRS
-By interchanging it can be found out whether starters, lamps or ballasts are defective.
If they are not, the internal wiring is to be checked, especially that on the tube holders.
-The snap-on connections of the wiring can be unlocked with a paper clip.
-The quick blackening of a tube-end points to a defective starter or a wiring fault.
-Disassembly of radiation part
Remove end cover (item 10).
Remove cover (item 9) and acrylic plate (item 11). For removal of ballast or fan the pop rivets must be drilled out.
New parts have to be fixed with pop rivets 4.8 mm or blind-rivetting nuts M3 (no service items).
SAP coding 8843 541 99999
SAP coding 8843 542 99999
S a 
|
M |
La |
HB 541 8x |
|
HB 542 10x |
||
|
|
|
|
a1 |
b1 |
|
L |
-Disassembly of gasspring (item 15)
Put solarium in highest position. Fasten ornamental screw (item 16)
Now turn the stand and the radiation unit through so far that the legs of the stand and the radiation unit rest on the floor.
Remove the nut inside the stand tube. Remove the ornamental screw and unlock the plastic guide block.
Separate the inner and outer stand part. Remove the ornamental prop and the spring clip at the inner side of the stand and lift the pin out. The gasspring can be taken out now.
Note: a new gasspring comes with plastic guide block, spring clip and ornamental prop.
Disassembly of hinge (item 13)
Remove the ornamental prop, spring clip and plastic ring.
Polish the shaft with abrasive paper to make the removal of guide blocks easier.
On assembly see to it that the cams of the spring clip rest in the groove on the shaft.
Published by Philips Domestic Appliances and Personal Care Printed in The Netherlands © Copyright reserved Subject to modification
4322 277 00365 00/08
Loading...