Steam Iron
GC1515
Philips Domestic Appliances and Personal Care
Service Manual
PRODUCT INFORMATION
Features
- Dynaglide soleplate coating
- Spray feature
- Self clean function
- Steam output (15 grams/min)
- Water tank capacity 170 ml
Safety Information
- This product meets the requirements regarding
interference suppression on radio and TV.
- After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.
TECHNICAL INFORMATION
Voltage : 220 ~ 240 V
Frequency : 50 ~ 60 Hz
Power consumption : 1200 ~ 1440 W
Dimension (F-box) : 272 x 112 x 140 mm
Weight : 1100 grams
Self Clean
When the self clean button is pushed, a sudden fl ow of water
is released from the tank into the soleplate. This thermal
shock will cause water scale particles to come loose from the
steam chamber. These particles are then fl ushed out through
the steam vents by the water.
3
Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification
03/03
DISASSEMBLY ADVICE
PARTS LIST
GC1515
CORD SET 5
PUMP 2
PILOT LIGHT COVER 9
PILOT LIGHT 10
remove DOSING UNIT 1
remove SPRAY KNOB 3
remove screw A (2x)
remove screw B (1x)
remove INLAY 4
remove screw C (2x) (cord clamp)
TANK SET 11
remove DIAL 7
Pos Service code Description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
4239 021 17260
4239 020 90560
4239 026 14290
4239 015 35790
4239 000 06800
4239 026 14300
4239 021 17250
4239 014 53790
4239 026 00880
4239 020 92720
4239 021 17240
4239 026 00850
4239 015 70150
4239 026 12360
4239 021 17230
4239 015 52140
4239 015 54210
Dosing assembly
Pump
Spray knob
Inlay (spray feature)
Cord set
Swivel
Dial
Rattle spring
Pilot light cover
Pilot light
Tank set (spray feature)
Cover
Isolation stud
Thermostat bush
Soleplate assembly
Cover seal
Tank top seal
N
remove screw D (2x)
INPUT
COVER 12
SOLEPLATE 15
L
ISOLATION STUD 13
E
remove screw E (3x)
REPAIR INSTRUCTIONS
- In case of any defect in the thermostat, the complete soleplate has to be replaced.
- No information about the type number and voltage has been stamped into the type
plate spare part. When replacing the type plate, engrave at least type number and
voltage into the type plate with a tool.
RESISTOR
HEATING
UNIT
LAMP
FUSE
THERMOSTAT
2-3