Philips FW350C/22 User Manual

Mini HiFi System

FW350C

Untitled-12 6/15/00, 3:33 PM1

1

3139 116 18651

Important notes for users in the U.K.
Mains plug

FrançaisEnglish

This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this
type of plug proceed as follows:

1 Remove fuse cover and fuse.

Español

2 Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type.
3 Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an

Deutsch ∂ППЛУИО¿PortuguêsSuomiDanskSvenskaItalianoNederlands

appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug
without a fuse is used, the fuse at the distribution board should not be greater
than 5 Amp.

Note: The severed plug must be disposed of to avoid a possible shock hazard
should it be inserted into a 13 Amp socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured with the following code: blue = neutral
(N), brown = live (L).
As these colours may not correspond with the colour markings identifying the
terminals in your plug, proceed as follows:

• Connect the blue wire to the terminal marked N or coloured black.

• Connect the brown wire to the terminal marked L or coloured red.

• Do not connect either wire to the earth terminal in the plug, marked E (or e) or
coloured green (or green and yellow).

Before replacing the plug cover, make certain that the cord grip is clamped over
the sheath of the lead - not simply over the two wires.

Copyright in the U.K.

Recording and playback of material may require consent. See Copyright Act 1956
and The Performer’s Protection Acts 1958 to 1972.

Italia

DICHIARAZIONE DI CONFORMITA’

Si dichiara che l’apparecchio FW350C Philips
risponde alle prescrizioni dell’art. 2 comma 1 del
D.M. 28 Agosto 1995
n. 548.

Fatto a Eindhoven , il 30/3/1999

Philips Consumer Electronics

5616 JB Eindhoven, The Netherlands

Philips, Glaslaan 2

Norge

Typeskilt finnes på apparatens underside.

Observer:

Den innebygde netdelen er derfor ikke frakoplet
nettet så lenge apparatet er tilsluttet
nettkontakten.

For å redusere faren for brann eller elektrisk
støt, skal apparatet ikke utsettes for regn eller
fuktighet.

Nettbryteren er sekundert innkoplet.

2

Untitled-12 6/15/00, 3:33 PM2

3139 116 18651

INDEX

CLASS 1

LASER PRODUCT

English .....................................5

Français .................................23

Español ..................................43

Deutsch ..................................63

Nederlands............................83

Italiano .................................103

Svenska ...............................123

Dansk ...................................143

Suomi ...................................163

Português ............................183

∂ППЛУИО¿

............................ 203

EnglishFrançais

Español

NederlandsItalianoSvenskaDanskSuomiPortuguês∂ППЛУИО¿ Deutsch

Untitled-12 6/15/00, 3:33 PM3

3

3139 116 18651

English

4

Untitled-12 6/15/00, 3:33 PM4

3139 116 18652

CONTENTS GENERAL INFORMATION SAFETY INFORMATION

General Information .......................... 5

Safety Information ............................. 5

Preparation ................................... 6 - 7

Controls ......................................... 8 - 9

Operating The System ............ 10 - 11

CD ............................................... 12 - 14

Tuner .......................................... 14 - 16

Tape............................................ 16 - 17

Aux .....................................................17

Recording .................................. 18 - 19

Clock .................................................. 19

Timer .......................................... 19 - 20

Maintenance .................................... 20

Specifications .................................. 21

Troubleshooting ...............................22

General Information

• The type plate (which contains the
serial number) is located at the rear
of the system.

• Recording is permissible if
copyright or other rights of third
parties are not infringed.

• This product complies with the
radio interference requirements of
the European Community.

Environmental Information

All unnecessary packaging material has
been omitted. We have done our utmost to
make the packaging easily separable into
three mono-materials: cardboard (box),
polystyrene foam (buffer) and polythene
(bags, protective foam sheet).

Your system consists of materials which
can be recycled and reused if disassembled
by a specialized company. Please observe
the local regulations regarding the disposal
of packaging materials, exhausted
batteries and old equipment.

Accessories

– Remote control
– Batteries (2 x AA size) for remote control
– AM loop antenna
– FM wire antenna
– AC power cord

(Supplied)

Safety Information

• Before operating the system, check that
the operating voltage indicated on the
typeplate (or the voltage indication
beside the voltage selector) of your
system is identical with the voltage of
your local power supply. If not, please
consult your dealer. The type plate is
located at the rear of your system.

• When the system is switched on, do not
move it around.

• Place the system on a solid base (e.g. a
cabinet).

• Place the system in a location with
adequate ventilation to prevent internal
heat build-up in your system.

• Do not expose the system to excessive
moisture, rain, sand or heat sources.

• Under no circumstances should you
repair the system yourself, as this will
invalidate the warranty!

• If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lens of the CD unit
inside the system. Should this occur, the
CD player will not operate normally.
Leave the power on for about one hour
with no disc in the system until normal
playback is possible.

• Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you unplug
the AC power cord and plug it in again
after a few seconds.

• To disconnect the system from the
power supply completely, remove
the AC power plug from the wall
socket.

English

Untitled-12 6/15/00, 3:33 PM5

5

3139 116 18652

PREPARATION

English

Rear Connections

B

LR

AUX IN

FRONT

A

FM AERIAL

75Ω

+

R

–
–

L

+

AM AERIAL

AC

MAINS

~

E

6

Untitled-12 6/15/00, 3:33 PM6

C

AUDIO OUT

D

3139 116 18652

PREPARATION

A AM Loop Antenna

Connection

Connect the supplied loop antenna to the
AM AERIAL terminal. Place the AM loop
antenna far away from the system and
adjust its position for the best reception.

B FM Wire Antenna

Connection

Connect the supplied FM wire antenna to
the FM 75 Ω terminal. Adjust the position
of the FM antenna for the best reception.

Outdoor Antenna

For better FM stereo reception connect an
outdoor FM antenna to the FM AERIAL 75
Ω terminal using a 75 Ω coaxial wire.

C Speaker Connections

• Connect the right speaker to Front
terminal R, with the red wire to + and
the black wire to -.

• Connect the left speaker to Front
terminal L, with the red wire to + and
the black wire to -.

• Clip the
stripped
portion of
the
speaker
wire as
shown.

12 mm

unlock

D Connecting other

equipment to your system

You can connect the audio left and right
OUT terminals of a TV, VCR, Laser Disc or
DVD player to the AUX IN terminals at the
rear of the system.

E AC Power Supply

After all other connections have been
made, connect the AC power cord to the
system and to the wall outlet.

Inserting batteries into the
Remote Control

• Insert the batteries (Type R06 or AA)
into the remote control as shown in the
battery compartment.

+

-

• To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
AA batteries.

lock

English

+

-

Untitled-12 6/15/00, 3:33 PM7

7

3139 116 18652