Philips FC8426 Service Manual

City Line Geneva Vacuum cleaner

FC8426
/02
/A

Philips Domestic Appliances and Personal Care

Service Manual

PRODUCT INFORMATION

- Colour: Anthracite

- Electronically controlled motor speed

- Built-in cord winder

- Dustbag-full indicator in dust cover

- This product meets the requirements regarding
interference suppression on radio and TV.

- After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.

TECHNICAL INFORMATION

- Maximum air displacement : 34 l/sec.

- Maximum vacuum water column : 260 cm

- Power consumption (IEC) 225V : 1500 W

- Dust storage capacity : 2 l

- Cord length (depends on version) : 6 m

- Filter system : 5 filters

- Dimensions of cleaner : 382 x 292 x 218 mm

- Dimensions of packaging : 510 x 305 x 330 mm

- Net weight : 4.5 Kg

- Gross weight : 8,0 Kg

- Noise : 79 dB

DISASSEMBLY- AND RE-ASSEMBLY ADVISE

- First lift and remove the knob and printed knob base and

then loosen mounting screws A.

AA

A

- Lift the motor housing (item 26) out of the lower housing

and take out the cord winder unit.

- To disassemble the cord winder, use TORX screwdriver no.
T10, which is one of a set consisting of T20; T15; T10;
T9; T8; T7 and T6 (code number 4822 395 50145).

OPTIONAL (accessories)

- FC8021 S-paper dustbags 8838 021 00000

- FC8032 Exhaust AFS micro filter 4822 015 70056

- HR6997 Sydney cotton dustbag 8836 997 01010

Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification

03/08

REPAIR INSTRUCTION

- The spare parts have been standardized as much as possible.

- Cotton dustbags are used in countries where paper dustbags
are unobtainable.

- If the reel half spring unit is replaced, shaft F must be
lubricated with silicone grease. Do not apply any silicone
grease to or spill any grease on terminals (36) or conductors
(35).

- Item 34 is provided with a long cord-winder spring, but
both long and short cords can be used in combination with
this spring. (L = 9.3 m)

- Depending on the length of the original cord, the spare
cord may have to be shortened.

- The cord winder spring must be tensioned to the maximum
level and then be rewound approx. 1.5 turn.

- The RPM can be adjusted by means of the potentiometer
mounted on the PCB (item 25). The RPM is correctly
adjusted if the motor starts automatically and continues to
run smoothly with the ON/OFF position and the
adjustable potentiometer in minimum position.

- If the function of the electronic control unit (item 25) is
not required, the Triac must be short-circuited in the
manner shown in the circuit diagram.

- When the vacuum cleaner is used to suck up fine dust, the
pores of the dustbag may become clogged, causing the
passage of air through the dustbag to become obstructed.
As a result, the dustbag-full indicator will indicate that the
dustbag needs to be replaced, even though the dustbag is
not full at all.

FC8426/02/A

ELECTRICAL DIAGRAM

MOTOR
POWER

MODULE

Brown

Blue

Black

Black

CORD WINDER

Triac

M

Short-circuit

2-6