Philips FC8404/01 User Manual [zh]

City Line

2

3

1 2 3 4

5 6 7 8

9 10 11 12

13 14 15 16

17 18 19 20

1

2

4

ENGLISH 6

10

14

CITY LINE

Important

Read these instructions for use carefully before using the appliance and save them for future
reference.

◗ Check if the voltage indicated on the appliance corresponds to the local mains voltage before

you connect the appliance.

◗ Do not use the appliance if the plug, the cord or the appliance itself is damaged.
◗ If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by

Philips or similarly qualified persons in order to avoid a hazard.

◗ Keep the appliance out of the reach of children.
◗ Never suck up water or any other liquid. Never suck up flammable substances and do not

suck up ashes until they are cold.

◗ Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum

cleaner is switched on and the hose is connected to the vacuum cleaner.

◗ When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become

clogged, causing the passage of air through the dustbag to become obstructed.As a result, the
dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the
dustbag is not full at all (see chapter 'Replacing the dustbag').

◗ Never use the appliance without the Motor Protection Filter.This could damage the motor

and shorten the life of the appliance.

◗ Only use Philips s-bag` double-layer paper dustbags.

Preparing for use

Connecting accessories

Hose

1 To connect the hose to the appliance, push it into the appliance and turn it clockwise (fig. 1).

2 To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the

appliance.

Tu b e

Conical coupling (specific types only)

1 To connect the tube to the handgrip, insert the narrow section into the wider section while

turning it a little (fig. 2).

2 To disconnect the tube, pull while turning it a little.

Use the same methods to connect the accessories to or to disconnect them from the tube or
handgrip.

Button coupling (specific types only)

1 Connect the tube to the handgrip ('click') (fig. 3).

2 To disconnect the tube from the handgrip, push the lock button and pull the tube out of the

handgrip (fig. 4).

Use the same methods to connect the accessories to or to disconnect them from the tube or
handgrip.

Telescopic tube (specific types only)

1 Adjust the tube to the length you find most comfortable during vacuum cleaning (fig. 5).

ENGLISH6