Philips FC8348/01, FC8347/01, FC8344/01 User Manual [zh]

Download

FC8348, FC8347, FC8344

Chun Ju

ENGLISH 6

FC8348, FC8347, FC8344

General description

1 On/off button 2 Rear wheel 3 Storage slot for tube clip 4 Swivel wheel 5 Type plate 6 Handgrip 7 Hose connector 8 Hose connection opening 9 Dustbag

10. Motor Parotection Filter

11. Dust cover

12. 'Dustbag full' indicator

13. Cord rewind button

14. Suction power control (FC8347, FC8348)

15. Plug

16. Crevice tool

17. Exhaust Filter

18. Filter holder

19. Grille

20. Handgrip

21. Small nozzle (FC8348)

22. Combi nozzle

23.Tubes with clip

24. Handgrip of hose with suction power slide

Important

Read these instructions for use carefully before using the appliance and save them for future reference.

◗ Check if the voltage indicated on the appliance corresponds to the local mains voltage before

you connect the appliance.

◗ Do not use the appliance if the plug, the cord or the appliance itself is damaged. ◗ If the mains cord of this appliance is damaged, it must be replaced by Philips, a service centre

authorised by Philips or similarly qualified persons in order to avoid a hazard.

◗ Keep the appliance out of the reach of children. ◗ Never suck up water or any other liquid. Never suck up flammable substances and do not

suck up ashes until they are cold.

◗ Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum

cleaner is switched on and the hose is connected to the vacuum cleaner.

◗ When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become

clogged, causing the passage of air through the dustbag to become obstructed.As a result,the dustbag-full indicator will indicate that the dustbag needs to be replaced. Even though the dustbag may not be full, it must be replaced.

◗ Never use the appliance without the Motor Protection Filter.This could damage the motor

and shorten the life of the appliance.

◗ Only use Philips double-layer paper dustbags or the reusable dustbag provided.

ENGLISH6

Preparing for use

Hose

1 To connect the hose, push it into the appliance and turn it clockwise (fig. 1).

To disconnect the hose, turn it anticlockwise and pull it out of the appliance.

Tubes

1 Connect the tubes to each other and to the handgrip by inserting the narrow section into

the wider section while turning it a little.The tube with the clip is the lower tube (fig. 2).

You can connect the accessories in the same way. Disconnect the accessories and tubes by pulling them and turning them a little.

Combi nozzle

The combi nozzle can be used on either carpets (with the brush strips folded in) or hard floors (with the brush strips folded out):

1 Push the rocker switch on top of the combi nozzle with your foot to make the brush strips

for cleaning hard floors come out of the nozzle housing (fig. 3).

2 Push the rocker switch on the other side to make the brush strips disappear into the housing

(fig. 4).

Crevice tool and small nozzle (specific types only)

The crevice tool can be used to clean hard-to-reach places.

◗ To use the crevice tool,pull it out of the storage compartment at the rear of the vacuum

cleaner (fig. 5).

The small nozzle can be used for vacuum cleaning small areas, e.g. the seats of chairs and sofas.

Using the appliance

Vacuum cleaning

1 Pull the cord out of the appliance and put the mains plug in the wall socket.

2 Switch the appliance on by pushing the on/off button on top of the appliance with your foot.

◗ You can carry the vacuum cleaner by the handle on top of the appliance (fig. 6).

Adjusting suction power

You can adjust the suction power by means of:

◗ the slide on the handgrip, or (fig. 7). ◗ the electronic suction power control (specific types only) (fig. 8).

Storage

1 Switch the appliance off and remove the mains plug from the wall socket.

2 Rewind the mains cord by pressing the cord rewind button.

ENGLISH 7

3 Put the appliance in upright position and attach the lower tube to the appliance by means of

the clip (fig. 9).

Replacement

Replacing the dustbag

Replace the dustbag as soon as the 'dustbag full' indicator has changed colour permanently.

Always unplug the appliance before replacing the dustbag.

1 Open the cover (fig. 10).

2 Pull the dustbag holder towards you to unlock the dustbag (1) and lift the dustbag out of the

appliance (2) (fig. 11).

3 Put a new dustbag into the appliance. Position the opening of the dustbag directly opposite

the hose connection opening (1). Pull the front of the dustbag forwards until it locks into place in the holder (2) (fig. 12).

Reusable dustbags

If provided, you can use the reusable dustbag instead of paper dustbags.The reusable dustbag can be used and emptied repeatedly.

For removing and inserting the reusable dustbag, simply follow the instructions for replacing paper dustbags.

To empty the reusable dustbag:

1 Remove the clip by sliding it off the dustbag sideways (fig. 13).

2 Shake out the contents into a dustbin.

3 Close the dustbag by sliding the clip back onto the bottom edge of the dustbag.

Replacing filters

Always unplug the appliance before replacing the filters.

Motor Protection Filter

Replace the Motor Protection Filter when you insert the first of a new set of filters.

1 Open the cover and remove the dustbag (fig. 11).

2 Remove the filter holder by pulling it upwards at an angle (fig. 14).

3 Replace the filter and put the filter holder back into the appliance (fig. 15).

4 Put the dustbag back into the appliance (fig. 12).

Exhaust Filter

Replace the Exhaust Filter every 6 months.

1 Remove the grille at the back of the appliance (fig. 16).

2 Remove the filter holder (fig. 17).

3 Remove the old filter and place the new filter in the holder (fig. 18).

4 Put the filter holder back into the appliance with the filter facing the vacuum cleaner.

ENGLISH8

5 Put the grille back into the vacuum cleaner by first hooking the bottom edge into the

appliance and then pushing the grille towards the appliance until it locks into place with a click (fig. 19).

Ordering dustbags and filters

If you have any difficulties obtaining dustbags, filters or other accessories for this appliance, please contact the Philips Customer Care Centre in your country or consult the worldwide guarantee leaflet.

- Philips double-layer paper dustbags are available under type number FC8046.

- A new Motor Protection Filter and a new Exhaust Filter are provided free of charge with each new set of dustbags.

Guarantee & service

If you need information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Depar tment of Philips Domestic Appliances and Personal Care BV.

Troubleshooting

1 Insufficient suction power

◗ Check if the dustbag needs to be replaced. ◗ Check if the filters need to be replaced. ◗ Check if the slide on the handgrip is closed. ◗ Check if the electronic suction power control is in maximum position (specific types only). ◗ Check if the nozzle, tube or hose is blocked up.To remove the obstruction, disconnect the

blocked-up item and connect it (as far as possible) the other way around. Switch the vacuum cleaner on to force the air through the blocked-up item in opposite direction (fig. 20).

ENGLISH 9