Philips FC8338/01, FC8336/01, FC8334/01 User Manual [ko]

2
3
1 2 3 4
5 6 7 8
9 10 11
4
ENGLISH 6
9
SPECIALIST
Important
Only use Philips double-layer paper dustbags (FC 8046) or the cotton dustbag provided
(specific types only).
Check if the dustbag has been placed correctly. Never suck up water or any other liquid. Never suck up flammable substances and do not
suck up ashes until they are cold.
Only allow children to operate the vacuum cleaner under close supervision. Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum
cleaner is switched on and the hose is connected to the vacuum cleaner.
When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become
clogged, causing the passage of air through the dustbag to become obstructed.As a result, the dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the dustbag is not full at all.
Never use the appliance without the motor protection filter.This could damage the motor
and shorten the life of the appliance.
Connecting accessories
1 Connect the hose to the appliance by firmly pushing the side with the connector switch into
the appliance (fig. 1).
2 Connect the tube to the handgrip by inserting the narrow section into the wider section
while turning it a little (fig. 2).
The combi nozzle can be used on carpets (with the brush strip folded in) and on hard floors
(with the brush strip folded out).
3 Connect the combi nozzle to the tube.
4 To clean hard floors, push the appropriate rocker switch on top of the combi nozzle with
your foot to make the brush strip come out of the nozzle housing (fig. 3).
5 To clean carpets, push the appropriate rocker switch to make the brush strip disappear into
the combi nozzle housing.
6 Lift the handle on the vacuum cleaner to gain access to the accessory storage compartment.
7 The crevice nozzle can be connected to the tube or to the handgrip (fig. 4).
Using the appliance
Vacuum cleaning
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Switch the appliance on by pushing the on/off button on top of the appliance with your foot
(fig. 5).
Adjusting suction power
You can adjust the suction power while vacuum cleaning.
1 Adjust the suction power by means of the slide on the handgrip (fig. 6).
2 Adjust the suction power by means of the suction power control knob (specific types only).
ENGLISH6
Storage
1 Switch the appliance off.
2 Remove the mains plug from the wall socket.
3 Rewind the mains cord by pushing the cord rewind button with your foot (fig. 7).
4 Put the appliance in upright position and attach the lower tube to the appliance by means of
the clip (fig. 8).
Replacement
Dustbags
Replace the dustbag as soon as the dustbag-full indicator changes colour.
1 Switch the appliance off.
2 Open the cover.
3 Push the dustbag holder backwards (fig. 9).
4 Remove the full dustbag by pulling the lug on the dustbag front upwards.
Throw the full paper dustbag in the dustbin. The cotton dustbag can be emptied and re-used.
B
To empty the cotton dustbag:
- Hold the dustbag over a dustbin.
- Remove the clip by sliding it off the dustbag sideways.
- Shake out the contents.
5 Insert the dustbag into the dustbag compartment by sliding the plastic or cardboard front of
the dustbag into the grooves of the dustbag holder. Press the front down as far as possible.
6 Pull the dustbag holder forwards (you will hear a click).
You cannot close the cover if no dustbag has been inserted.
Filters
This appliance is equipped with a motor protection filter.
1 Replace the motor protection filter when you insert the first of a new set of dustbags (fig.
10).
2 Insert the filter into the appliance with the white side facing outwards.
The rear end of the vacuum cleaner is fitted with an exhaust filter that removes small
particles from the exhaust air.
3 Open the exhaust filter grille at the rear of the appliance (fig. 11).
4 Remove the filter holder, replace the filter and put the filter holder back into the appliance.
Make sure the white side of the filter is facing outwards.
The mains cord
If the mains cord of this appliance is damaged, it may only be replaced by Philips or service centre authorised by Philips, as repair requires special tools and/or parts.
ENGLISH 7
Ordering dustbags and filters
Philips double-layer dustbags are available under type number FC8046.
New motor protection and exhaust filters are provided free of charge with each new set of dustbags.
If you have any difficulties obtaining dustbags, filters or other accessories for this appliance, please contact the Philips Customer Care Centre in your country or consult the worldwide guarantee leaflet.
Guarantee & service
If you need information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.
Solving problems
The suction power of the appliance is insufficient:
1 Check if the dustbag needs to be replaced.
2 Turn the suction power control knob to a higher setting (specific types only).
3 Close the slide on the handgrip.
4 Check if the nozzle, tube or hose is blocked up.
To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible) the other way round. Switch the vacuum cleaner on to force the air through the blocked-up item in opposite direction.
ENGLISH8
9
,
.
◗ ◗
◗ ◗
◗ ◗
1 .
2 ,
.
3 .
4 .
5 .( )
6 .
7 .
1 .
2
1
.
2
(
10
1 .
2 .
3 .
4 ,
.
1 .
2 .
3 .
4 .
B
:
-
.
-
.
-
.
5 .
.
6 .
1
,
.
2 .
3
.
4
, .
.
11
,
.
2 FC8046 .
.
,
.( ) (02)709-1200,
(080)600-6600 (
).
,
( ) .
.* ( )
: (02)709-1200 * : (080)600-
6600 (
)
1 .
2 (
).
3 .
4 ,
.
,
, .
12
13
4222 003 30641
u
www.philips.com
Loading...