Philips DVP3356X-94, DVP3356, DVP3356X User Manual

www.philips.com/welcome

DVP3356

User manual

Contents

1 Important 4

Safety and important notice 4 Trademark Notice 5

2 Your DVD player 6

Features highlight 6 Product overview 7

3 Connect 9

Connect video cables 9 Connect audio cables 10 Route audio to other devices 10 Connect USB device 11 Connect to power outlet 11

6 Advanced features 23

Media copy 23 Create MP3  les 23

7 Adjust settings 25

General setup 25 Audio setup 26 Video setup 29 Preferences 30

8 Additional information 32

Update software 32 Care 32

9 Speci cation 33

10 Troubleshooting 34

Contents

4 Get started 12

Prepare the remote control 12 Find the correct viewing channel 13 Select menu display language 13 Turn on Progressive Scan 14

5 Play 15

Play from disc 15 Play video 16 Play music 19 Play photo 21 Play from USB device 22

11 Glossary 36

1 Important

Safety and important notice

Warning

•

Risk of overheating! Never install the DVD player in a con ned space. Always leave a space of at least four inches around the DVD player for ventilation. Ensure the curtains or other objects never cover the ventilation slots on the DVD player.

•

Never place the DVD player, remote control or batteries near naked  ames or other heat sources, including direct sunlight.

•

Only use this DVD player indoors. Keep this DVD player away from water, moisture and liquid- lled objects.

Never place this DVD player on other electrical

•

equipment. Keep away from this DVD player during lightning

•

storms. Where the mains plug or an appliance coupler is

•

used as the disconnect device, the disconnect device shall remain readily operable.

•

Visible and invisible laser radiation when open. Avoid exposure to beam.

About Progressive Scan

Consumers should note that not all high de nition television sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of 525 or 625 progressive scan picture problems, it is recommended that the user switch the connection to the ‘standard de nition’ output. If there are questions regarding our TV set compatibility with this model 525p and 625p DVD player, please contact our customer service center.

Recycle notice

This electronic equipment contains a large number of materials that can be recycled or reused if disassembled by a specialized company. If you are disposing of an old machine, please take it to a recycling center. Please observe the local regulations regarding disposal of packaging materials, exhausted batteries and old equipment.

This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Trademark Notice

Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.

Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft Corporation in the United States and/ or other countries.

Important

DivX, DivX Certi ed, and associated logos are trademarks of DivX, Inc. and are used under license.

Plays DivX audio tracks.

The USB-IF Logos are trademarks of Universal Serial Bus Implementers Forum, Inc.

video with menus, subtitles and

2 Your DVD

ALL

player

Congratulations on your purchase, and welcome to Philips! To fully bene t from the support that Philips offers, register your product at www.philips.com/welcome.

This DVD player brings audio and video to life. Just plays practically any disc format, including the digital photos with absolutely no compromise to picture quality.

Features highlight

Create MP3  les

Convert your favorite audio tracks from an audio CD into MP3 format. The created MP3  les are saved in your USB  ash drive.

Region codes

Your DVD player plays discs with the following region codes.

DVD region code Countries

India

Screen  t

View the movie in full screen on any TV with this DVD player.

Progressive scan component video

Pushes the limits of standard resolution and provides a more  lm-like image display that is more pleasing for viewing DVDs on a TV display.

Hi speed USB 2.0 link

Simply plug your USB  ash drive into the USB jack to play your MP3/WMA/JPEG/DivX  les to enjoy the music play in superb sound quality.

Media copy

You can transfer data  les such as MP3, WMA and JPEG from disc to USB  ash drive.

Product overview

Remote control

Main unit

a 2 (Standby-on)

Turn on the DVD player or switch to • standby mode.

b Disc compartment

c Display panel

31 2

Your DVD player

d Z (Open/Close)

Open or close the disc compartment.•

e u (Play/Pause)

Start, pause or resume disc play.•

f (USB) jack

Connect a USB  ash drive.•

a 2 (Standby-On)

Turn on the DVD player or switch to • standby mode.

b Z (Open/Close)

Open or close the disc compartment.•

c DISC MENU

Access or exit the disc menu.•

Switch to disc mode.•

For VCD/SVCD, turn PBC (Playback • Control) on or off in PBC mode.

d v V b B (Navigation buttons)

m AUDIO/CREATE MP3

Navigate through the menus.• Search fast-forward (• B) or fast-

backward (b). Press repeatedly to change the search speed.

Search slow-forward (• v) or slowbackward (V). Press repeatedly to change the search speed.

e 2 BACK

Return to the previous display menu.•

For DVD, navigate to the title menu.•

For VCD version 2.0 or SVCD with • PBC turned on, return to the menu.

f í/ë (Previous/Next)

Skip to the previous or next title, • chapter, or track.

Press and hold for fast-backward or • fast-forward search.

Select an audio language/channel.•

Access the menu to create MP3.•

n x (Stop)

Stop disc play.•

o u (Play/Pause)

Start, pause or resume disc play.•

p INFO

For disc, display the current status or • disc information.

For slideshows, display a thumbnail view • of photo  les.

q OK

Con rm an entry or selection.•

r SETUP

Access or exit the setup menu.•

g (USB)

Switch to USB mode and display the • content.

h Numeric buttons

Select an item to play.•

i SUBTITLE

Select DVD or DivX subtitle language.•

Access the menu to USB copy or USB • delete.

j , ZOOM

Fit the picture format to the TV screen.•

Zoom in or out of the picture.•

k VOLUME

Display the current volume level and • use (b) or (B) navigation buttons to set the volume level between 0 ~ 20.

l REPEAT/ REPEAT A-B

Toggle between various repeat modes.•

Mark the section for repeat play, or • turn off repeat mode.

3 Connect

Note

Make the following basic connections to use the DVD player.

Basic connections:

Video cables• Audio cables•

Optional connections:

Audio to other devices:•

Multi channel receiver•

Digital ampli er/receiver•

Analog stereo system•

Note

Refer to the type plate at the rear or bottom of the • product for identi cation and supply ratings.

•

Before you make or change any connections, ensure that all the devices are disconnected from the power outlet.

Tip

Different types of connectors may be used to • connect this product to your TV, depending on availability and your needs. A comprehensive interactive guide to help you connect your product is available at www.connectivityguide.philips.com.

You must connect this DVD player directly to a TV.•

Option 1: Connect to component video jacks

COMPONENT VIDEO OUT

COMPONENT

VIDEO IN

1 Connect the component video cables (not

supplied) to the Y Pb Pr jacks on this DVD player and the component video input jacks on the TV.

If a progressive scan TV is used, you • may turn on the progressive scan mode (see chapter ‘Turn on Progressive Scan’ for details).

Tip

The component video input jacks on the TV may be • labeled as Y Pb/Cb Pr/Cr or YUV.

This type of connection provides good picture

•

quality.

Connect

Connect video cables

Connect this DVD player to the TV to view disc play.

Select the best video connection that the TV can support.

Option 1:• Connect to component video jacks (for a standard TV or Progressive Scan TV). Option 2:• Connect to video (CVBS) jack (for a standard TV).

Option 2: Connect to video (CVBS) jack

VIDEO IN

1 Connect a composite video cable

(supplied) to the TV OUT jack on this DVD player and the video input jack on the TV.

Tip

Route audio to other devices

Route the sound from this DVD player to other devices to enhance audio play.

Connect to multi channel receiver

FRONT L

FRONT R

MULTICHANNEL

REAR L

REAR R

AUDIO IN

CENTER

SUBWOOFER

The video input jack on the TV may be labeled as • A/ V IN, VIDEO IN, COMPOSITE or BASEBAND.

This type of connection provides standard picture

•

quality.

Connect audio cables

Connect the audio from this DVD player to the TV to allow sound output through the TV.

AUDIO IN

FRONT L

FRONT R

FRONT L

FRONT R

REAR L

REAR R

CENTER

SUBWOOFER

1 Connect the audio cables (not supplied) to

the AUDIO OUT (FRONT L/R, REAR L/R, CENTER and SUBWOOFER) jacks

on this DVD player and the audio input jacks on the device.

Tip

You can optimize the audio output (see chapter • ‘Adjust settings’ - [ Audio Setup ] > [ Analog Output

]) for details.

1 Connect the audio cables (supplied) to the

AUDIO OUT FRONT L/R jacks on this

DVD player and the audio input jacks on the TV.

Connect to digital ampli er/receiver

DIGITAL IN

DIGITAL

OUT

COAXIAL

Connect USB device

Connect

1 Connect a coaxial cable (not supplied) to

the COAXIAL/DIGITAL OUT jack on this DVD player and the COAXIAL/DIGITAL input jack on the device.

Tip

You can optimize the audio output (see chapter • ‘Adjust settings’ - [ Audio Setup ] > [ Digital Audio

]) for details.

Connect to analog stereo system

AUDIO IN

FRONT L

1 Connect the USB  ash drive to the

(USB) jack on this DVD player.

Note

This DVD player can only play/view MP3, WMA, • DivX or JPEG  les that are stored on such devices.

Press

• to access the content and play the  les.

Connect to power outlet

Warning

Risk of product damage! Ensure that the power • supply voltage corresponds to the voltage printed on the back or the underside of the DVD player.

FRONT R

1 Connect the audio cables (supplied) to the

AUDIO OUT FRONT L/R jacks on this

DVD player and the audio input jacks on the device.

Tip

You can optimize the audio output (see chapter • ‘Adjust settings’ - [ Audio Setup ] > [ Analog Output

]) for details.

1 Connect the power cord to the power

outlet.



The DVD player is ready to be set up

for use.

4 Get started

Prepare the remote control

Navigate through the menu

1 Point the remote control directly at the

remote sensor on this DVD player and select the desired function.

1 Push to open the battery compartment

cover.

2 Insert two R03 or AAA type batteries with

correct polarity (+/-) as indicated.

3 Close the battery compartment.

Caution

Remove batteries if they are exhausted or if the • remote control is not to be used for a long time.

Do not mix batteries (old and new or carbon and

•

alkaline, etc.). Batteries contain chemical substances. They should

•

be disposed off properly.

2 Use the following buttons on the remote

control to navigate through the on-screen menus.

Button Action

v V

b B

Move up or down.

Move left or right.

Con rm a selection.

Enter numbers.

+ 28 hidden pages