Philips DVP3055V-05 User Manual

Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.

Connect the EURO AV1 AUDIO/VIDEO on the rear panel of this DVD/VCR to the SCART input on the TV using the SCART cable.

Connect your existing RF cable from the Antenna TV signal directly to the AERIAL jack on the rear of the DVD/VCR.

If you have a Cable Box (or Satellite Receiver), connect the OUT jack of the Cable Box/Satellite Receiver to the AERIAL jack on the DVD/VCR using an RF coaxial cable (not supplied).

Connect the supplied black RF cable to the DVD/VCR’s RF-OUT jack and to your TV’s ANTENNA IN jack.

The TV’s ANTENNA IN jack could be labelled 75-ohm, TV IN, or RF IN. Check your TV manual for details.

Connect the power cords of the DVD/VCR,TV, and Cable Box (if applicable) to a power outlet.

Turn on the TV power. Set the TV to a video channel. (See the accompanying DVD/VCR owner’s manual for details.)

Press STANDBY-ON/POWER 2 on the DVD/VCR or its remote to turn on the DVD/VCR. The first time you turn on the DVD/VCR, you should complete the VCR setup. See the other side of this Quick-Use Guide for details.

SgpSL/0508/05_1

DVP3055V

Cable box (optional)

CABLE

TV SIGNAL

OUT

RF CABLE

Antenna

SCART IN

AV IN

SUPER VIDEO

RETURN

TV/VIDEO

DVD VCR

OPEN/CLOSE

STOP

MARKER SEARCH INPUT RECORD

SUBTITLE AUDIO ANGLE ZOOM

REPEAT

PROGRAM

CLEAR

TITLE SHUFFLE CHILD LOCK

SPEED

PAUSE/STEP

PLAY

DISC SYSTEM

DISPLAY

123

456

789

A-B

Playing a Disc

1 With the TV and DVD/VCR on, press the DVD button to put the

DVD/VCR in DVD mode.

2 Press OPEN/CLOSE / to open the disc tray. Put a Disc in the tray with

the label facing up and the shiny side facing down. Press OPEN/CLOSE / again to close the tray.

3 Playback may start automatically. If not, press PLAY B.

If a DVD Disc menu appears, use the 4 3 1 2, OK, or Number buttons to select features or start playback. Follow the instructions in the menu.

4 To stop playing a Disc, press STOP 9.

Setting Up the VCR the First Time

1 Turn on the TV and set it to your external video

channel (SCART).

2 Press STANDBY-ON/POWER

to turn on the

DVD/VCR,then press VCR.

3 Press OK to start the automatic tuning process. The

TV station stored may vary according to the area you live in.

4 Press SYSTEM MENU to remove the menus from the

TV screen.

Remote Control

Setting

Before using the remote control:

• Press ‘DVD’ for DVD functions.

• Press ‘VCR’ for VCR functions.

Detailed playback features and additional functions are described in the

accompanying owner’s manual.

Region Codes

DVDs must be labeled for ALL regions or for Region 2 in order to play on this DVD system.

No picture?

Check the AV (Audio/Video) mode on your TV.

* Usually this channel is between the lowest and highest channels and may be called FRONT,

A/V IN, or VIDEO.

* Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly

until you see the Video In channel. * Or, your TV remote control may have a button or switch that chooses different video modes. * See your TV manual for more details.

ALL