Philips DS1155-37 User Manual

Always there to help you

Question?

Contact

Philips

Question?

Contact

Philips

Register your product and get support at

www.philips.com/welcome

DS1155

User manual

Contents

1 Important 2

Safety 2

2 Your Docking Speaker 4

Introduction 4
What's in the box 4
Overview of the main unit 4

3 Get started 5

Connect power 5
Adjust time 5
Turn on 5

4 Play 6

Play from iPod/iPhone 6
Charge your mobile phone 6
Adjust volume 7
Adjust brightness 7

5 Product information 8

Specications 8

6 Troubleshooting 9

7 Notice 10

Disposal of your old product 10

1EN

1 Important

Safety

Important Safety Instructions

a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings.

Install in accordance with the
manufacturer's instructions.

h Do not install near any heat sources such

as radiators, heat registers, stoves, or

other apparatus (including ampliers) that

produce heat.

i Protect the power cord from being

walked on or pinched, particularly at
plugs, convenience receptacles, and the
point where they exit from the apparatus.

j Only use attachments/accessories

specied by the manufacturer.

k Use only with the cart, stand, tripod,

bracket, or table specied by the

manufacturer or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination to
avoid injury from tip-over.

l Unplug this apparatus during lightning

storms or when unused for long periods
of time.

m Refer all servicing to qualied service

personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.

n Apparatus shall not be exposed to

dripping or splashing.

o Do not place any sources of danger on

the apparatus (e.g. liquid lled objects,
lighted candles).

p This product may contain lead and

mercury. Disposal of these materials
may be regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
Alliance: www.eiae.org.

q Where the plug of the Direct Plugin

Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.

2 EN

Warning

•

Never remove the casing of this apparatus.

• Never lubricate any part of this apparatus.

• Never place this apparatus on other electrical

equipment.

• Keep this apparatus away from direct sunlight, naked

amesorheat.

• Make sure that you always have easy access to the

power cord, plug, or adaptor to disconnect the
apparatus from the power.

3EN

2 Your Docking

Speaker

Congratulations on your purchase, and

welcometoPhilips!Tofullybenetfromthe

support that Philips offers, register your product
at www.philips.com/welcome.

Introduction

With this docking speaker, you can:

• set time;

• enjoy audio from your iPod/iPhone.

Overview of the main unit

a

b

c

d

g

f

e

What's in the box

Check and identify the contents of your
package:

• Main unit

• 1 x AC adaptor

• Short user manual

a Dock for iPod/iPhone
b

• Adjust brightness of bottom light.

c CLOCK

• Adjust brightness of the display.

• Press and hold to set the clock.

d

• Charge your mobile phone through a
USB cable.

e DC IN

• Connect AC power.

f Display
g

/

• Adjust volume.

4 EN

3 Get started

Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________

Connect power

Caution

Risk of product damage! Make sure that the power

•

supply voltage corresponds to the voltage printed on
the back of the unit.

• Risk of electric shock! When you unplug the AC

adaptor, always pull the plug from the socket. Never
pull the cord.

• Before connecting the AC adaptor, make sure that you

have completed all other connections.

Adjust time

1

In standby mode, press and hold CLOCK
to enter the clock setting mode.

» [24H] or [12H] hour format is

displayed.

2 Press +/- to select [24H] or [12H] hour

format, and then press CLOCK.

» The hour digits are displayed and begin

to blink.

3 Press +/- to set hour, and then press

CLOCK.

» The minute digits are displayed and

begin to blink.

4 Repeat step 3 to set minute.

Turn on

In standby mode, the docking speaker turns on
automatically when it detects an audio signal
from docked iPod/iPhone.

Switch to standby mode

The unit switches to standby mode if there is
no audio signal from docked iPod/iPhone over
15 minutes.

5EN

4 Play

Listen to the iPod/iPhone

Note

Make sure that the iPod/iPhone is loaded correctly.

•

Play from iPod/iPhone

You can enjoy audio from iPod/iPhone through
this docking speaker.

Compatible iPod/iPhone

The docking speaker supports the following
iPod/iPhone models.
Made for:

• iPhone 5

• iPod nano (7th generation)

• iPod touch (5th generation)

Load the iPod/iPhone

Insert your iPod/iPhone into the dock.

» The docking speaker synchronizes time

from the docked iPod/iPhone.

Start to play music from your iPod/iPhone.

» Music streams from the docking

speaker automatically.

Charge the iPod/iPhone

The docked iPod/iPhone begins to charge
automatically after connected to power.

Charge your mobile phone

You can charge your mobile phone through the
USB socket in this device with a USB cable (not
supplied)

To remove the iPod/iPhone:

• Pull your iPod/iPhone out of the dock.

6 EN

Adjust volume

During play, press +/- repeatedly to increase or
decrease the volume.

Adjust brightness

• Press CLOCK repeatedly to select
different levels of display brightness.

• Press
levels of bottom light brightness.

repeatedly to select different

7EN

5 Product

information

Note

Product information is subject to change without prior

•

notice.

Specications

Amplier

Rated Output Power 2 x 3 W RMS
Signal to Noise Ratio 77 dBA

General information

AC power
adaptor

Operation Power
Consumption

Charging (USB) ≤500mA

Dimensions: Main
Unit (W x H x D) 177 x 177 x 100 mm

Weight: Main Unit 0.88 kg

Model: S018KU0590240
(Philips)
Input: 100-240 V, 50/60
Hz, 500 mA;
Output: 5.9 V

18 W

2400 mA;

8 EN

6 Troubleshooting

Warning

•

Never remove the casing of this device.

To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.

No power

• Make sure that the AC power plug of the
unit is connected properly.

• Make sure that there is power at the AC
outlet.

No sound or poor sound

• Adjust the volume of your docking speaker.

• Adjust the volume of your iPod/iPhone or
external audio device.

No response from the unit

• Disconnect and reconnect the AC power
plug, and then turn on the docking speaker
again.

9EN

7 Notice

Disposal of your old product

Anychangesormodicationsmadetothis

device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.

Notice for the USA
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:

• Relocate the receiving antenna.

• Increase the separation between

equipment and receiver.

• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.

• Consult the dealer or an experienced
radio/TV technician for help.

This Class B digital apparatus complies with
Canadian ICES-003.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:

• This device may not cause harmful
interference, and

• This device must accept any interference
received, including interference that may
cause undesired operation.

Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products and batteries.
The correct disposal of these products helps
prevent potentially negative consequences on
the environment and human health.
Please visit www.recycle.philips.com for
additional information on a recycling center in
your area.

Environmental information

All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.

The making of unauthorized copies of copy­protected material, including computer

programs,les,broadcastsandsound

recordings, may be an infringement of
copyrights and constitute a criminal offence.
This equipment should not be used for such
purposes.

“Made for iPod” and “Made for iPhone”
mean that an electronic accessory has been

10 EN

designedtoconnectspecicallytoiPodor
iPhonerespectively,andhasbeencertiedby

the developer to meet Apple performance
standards. Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note that
the use of this accessory with iPod or iPhone
may affect wireless performance.
iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.

Note

The type plate is located on the bottom of the

•

apparatus.

11EN

Specifications are subject to change without notice
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.

DS1150_37_UM_V1.0