Philips B200G Installation And Operating Instructions Manual
Philips Lighting Company
Philips Lighting Company
WARNING – Shut off AC power to branch circuits to which units will be connected. All wiring should be per
N.E.C. Articles 501-4(b) and local codes.
To maintain warranty, equipment with batteries must be installed or placed on charge within prescribed period
after shipment.
B200G Industrial Duty Emergency Unit
(With IntelliCharge)
Installation and Operating Instructions
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
All servicing should be performed by qualified personnel only.
Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by
unauthorized personnel.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended use.
Do not use outdoors.
Do not let supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Do not mount near open flames or sparks.
The battery supplied with this equipment is a sealed maintenance free lead calcium battery. Do not attempt to
service this battery.
SAVE THESE INSTRUCTIONS
CAUTION: To avoid electrical overload, total connected lamp load (factory and field installed) should not
exceed output rating.
200 Franklin Square Drive
Somerset, NJ 08873
Phone: 855-486-2216
www.philips.com/luminaires
281 Hillmount Road
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
Page 2 of 7
Philips Lighting Company
Philips Lighting Company
200 Franklin Square Drive
Somerset, NJ 08873
Phone: 855-486-2216
www.philips.com/luminaires
281 Hillmount Road
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
Page 3 of 7
Philips Lighting Company
Philips Lighting Company
INSTALLATION INSTRUCTIONS
The B200G is intended for surface mounting only and is suitable for 120VAC or 277VAC, 60 Hz operation.
1. Remove keyway knockouts (2) if cabinet is to be mounted to the wall.
2. Remove hole plugs as needed for installing the lamp heads. (Figure 1)
Figure 1
3. Install lamp heads to cover per instructions provided with lamp heads.
4. Connect lamp head leads, one grey lead to one terminal on the lamp head, a white lead to the other
terminal. (Figure 4)
5. Remove appropriate knockout located on sides of cabinet to accept AC service.
6. Mount cabinet directly to wall or use optional mounting plate MBB. (Figure 2)
Figure 2
7. Max Mounting Height: 12W Halogen=7.5 ft., 7W/MR16/LED=30 ft., 15W LED AR111=31ft.
8. Install batteries in battery chamber. DO NOT LIFT BATTERY BY TERMINALS. (Figure 3)
9. Connect Battery leads to the batteries. (Figure 4). Warning: The unit will be damaged if the batteries
are connected improperly.
200 Franklin Square Drive
Somerset, NJ 08873
Phone: 855-486-2216
www.philips.com/luminaires
281 Hillmount Road
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
Loading...