Philips AJ3232, AJ3232B 79 Short User Manual

Short User Manual

Specications are subject to change without notice.
2015 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of Gibson
Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license from Koninklijke Philips N.V.

AJ3232_79_SUM_V1.0

AJ3232

Question?

Contact

Philips

Question?

Contact

Philips

www.philips.com/support

Register your product and get support at

Always there to help you

1 Important

Safety

Know these safety symbols

This ‘bolt of lightning’ indicates uninsulated material within your unit
may cause an electrical shock. For the safety of everyone in your
household, please do not remove product covering.
The ‘exclamation point’ calls attention to features for which you
should read the enclosed literature closely to prevent operating and
maintenance problems.

WARNING: To reduce the risk of re or electric shock, this

apparatus should not be exposed to rain or moisture and objects

lled with liquids, such as vases, should not be placed on this

apparatus.
CAUTION: To prevent electric shock, match wide blade of plug to
wide slot, fully insert.

Warning

• Never remove the casing of this radio.

• Never lubricate any part of this radio.

• Never place this radio on other electrical equipment.

• Keep this radio away from direct sunlight, naked ames or heat.

• Make sure that you always have easy access to the power cord, plug or

adapter to disconnect the radio from the power.

• Read these instructions.

• Follow all instructions.

• Do not use this product near water.

• Clean only with dry cloth.

• Do not block any ventilation openings. Install in accordance

with the manufacturer’s instructions.

• Only use attachments or accessories specied by the

manufacturer.

• Unplug this product during lightning storms or when unused

for long periods of time.

• Refer all servicing to qualied service per sonnel. Servicing is

required when the product has been damaged in any way,
such as liquid has been spilled or objects have fallen into the

product, the product has been exposed to rain or moisture,
does not operate normally, or has been dropped.

• Battery usage CAUTION – To prevent battery leakage which

may result in bodily injury, property damage, or damage to
the product:

• Install all batteries correctly, + and - as marked on the

product.

• Do not mix batteries (old and new or carbon and

alkaline, etc.).

• Remove batteries when the product is not used for a

long time.

• Batteries shall not be exposed to excessive heat such as

sunshine, re or the like.

• The product shall not be exposed to dripping or splashing.

• Do not place any sources of danger on the product (e.g.

liquid lled objects, lighted candles).

• Where the MAINS plug or an appliance coupler is used as

the disconnect device, the disconnect device shall remain
readily operable.

Note

• The type plate is located on the bottom of the product.

2 Notice

Any changes or modications made to this device that are not

expressly approved by Gibson Innovations may void the user’s

authority to operate the equipment.

Disposal of your old product

Your product is designed and manufactured with high quality

materials and components, which can be recycled and reused.

This symbol on a product means that the product is covered by
European Directive 2012/19/EU. Inform yourself about the local
separate collection system for electrical and electronic products.
Follow local rules and never dispose of the product with normal
household waste. Correct disposal of old products helps prevent

negative consequences for the environment and human health.

Environmental information

All unnecessary packaging has been omitted. We have tried to
make the packaging easy to separate into three materials: cardboard
(box), polystyrene foam (buffer) and polyethylene (bags, protective
foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted

batteries and old equipment.

2xAAA

Note: The batteries (not supplied) can only back up clock and alarm

settings when AC power is disconnected.

Note: Make sure that the product is in standby mode.

Set clock

• Press to select FM or MW radio.

• Press and hold for 2 seconds to switch to standby mode.

AJ3232_79_SUM_V1.0.indd 1 6/1/2015 10:35:56 AM

Specications

Amplier

Rated Output Power 0.4 W RMS

Tuner

Tuning Range FM: 87.5-108 MHz;

MW: 531-1602 KHz

Tuning Grid FM: 50 KHz;

MW: 9 KHz

Number of presets FM: 20;

MW: 20

General information

AC power 240 V ~, 50 Hz

Operation Power
Consumption

8 W

Standby Power Consumption <1 W

Dimensions:

- Main Unit (W x H x D) 190 x 94 x 62 mm

Weight: - Main Unit 0.55 kg

Press SLEEP repeatedly to select a time period (in minutes).

» The product switches to standby mode automatically

after the preset period.

» When [OFF] is displayed, the sleep timer is deactivated.

Tip: For better reception, fully extend and adjust the

position of the antenna.

Prepare radio antenna

Select FM/MW radio

Tune to FM/MW radio stations

Store FM/MW radio stations automatically

1 Select FM or MW radio.
2 Tune to a radio station.
3 Press and hold PRESET for two seconds.

» The preset number begins to blink.

4 Press - TUNING + to select a number.
5 Press PRESET again to conrm.
6 Repeat steps 2 to 5 to store other stations.

Note:

• You can store a maximum of 20 FM radio

stations and 20 MW radio stations.

• To overwrite a pre-stored radio station, store

another one with its sequence number.

Store FM/MW radio stations manually

X20

Select a preset radio station

To download the full user manual,
visit www.philips.com/support.

Note:

• You can only set the alarm in standby mode.

• Make sure that you have set the clock correctly.

Set alarm

Press AL1 or AL2 reepeatedly to activate or deactivate
the alarm timer.

» If the alarm timer is activated, the alarm indicator

for the radio or buzzer is displayed.

» If the alarm timer is deactivated, the alarm indicator

disappears.

• To stop the alarm, press the corresponding AL1

or AL2.

» The alarm repeats ringing for the next day.

Note: When the alarm sounds, volume increases
gradually to the maximum alarm volume. You cannot
adjust the alarm volume manually.

When the alarm sounds, press SNOOZE.

» The alarm snoozes and repeats ringing nine minutes later.

AJ3232_79_SUM_V1.0.indd 2 6/1/2015 10:35:58 AM