AJ3136
AJ3136Clock Radio
AJ3136
AJ3136Clock Radio
1
2
3
8
9
7
6
4
0
!
@
#
$
5
1
AJ3136
AJ3136Clock Radio
1
2
3
8
9
7
6
4
0
!
@
#
$
5
2
ALARM :
ALARM :
ALARM :
PM
PM
ALARM :
PM
PM
English
CONTROLS
(see 1)
1 ALARM RESET / SLEEP
- stops active alarm for 24 hours
- activates the radio for sleep function, and to select the sleep time
2 ALARM ON / OFF : switches alarm ON and OFF
3 RADIO ON / OFF - switches radio ON and OFF
4 Pigtail aerial - antenna for FM reception
5 Socket for AC/DC 7.5V adapter
6 SET AL / TIME- sets the clock and alarm time
7 MIN + : - adjusts the minutes for clock and alarm times
8 HOUR + : adjusts the hours for clock and alarm times
9 Battery door - opens to store a 4 x R6/UM3/AA batteries (not included)
0 RESET - press if the set / display does not react to operation of any button
! VOLUME - adjusts the sound level
@ TUNING - tunes to radio stations
# REPEATALARM•BRIGHTNESS CONTROL
- switches off the alarm for a 5 minute period
- changes display illumination brightness
- stops SLEEP function
$ Display - shows clock and alarm times and status
POWER SUPPLY
Batteries
(not included)
1
Open battery door and insert four batteries (preferably PHILIPS POWER LIFE or
alkaline), type R6, UM3 or AA as indicated in the compartment.
2
Remove the batteries from the set if they are exhausted or not be used for a
long time.
•
When the batteries are turning low, appears in the display. The radio and
backlight will not function, but the display and power saving buzzer will continue to operate.
•
When replacing batteries, the clock time and alarm setting will be stored by
the self-powered back-up for 1 minute (see 'Self-Powered Back-Up').
•
Make sure the radio is switched off to save battery energy.
Batteries contain chemical substances, so they should be disposed of
properly.
AC/DC adapter
1
Connect the AC/DC to the set's DC socket and to the wall socket.
™
indicates the set is now adapter operated.
•
Make sure your adapter is properly connected to save battery energy!
2
Always disconnect the AC/DC adapter if you are not using the set.
™
indicator goes out.
NOTE: To avoid damage to the set, use only the adapter supplied!
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your clock and alarm settings to be
stored for up to 1 minute when there is a power interruption e.g. AC power failure or
when changing batteries.
The complete clock radio and backlight illumination will be switched off. As soon as the
power supply returns the display will indicate the correct time.
• If power supply returns after 1 minute, the demo mode appears and you will need to
re-enter the clock and alarm setting.
BATTERY LOW MODE
If you have inserted batteries, the battery low indicator lights up when:
battery power is low.
•
During the battery low mode, both Radio/Sleep, sound effects, backlight will not
function.
Operation of any alarm mode (Radio/Buzzer/Submarine/Frog) automatically changes to
a slow buzzer beep frequency.
If the
RADIO ON / OFF, ALARM RESET / SLEEP
•
REPEAT ALARM•BRIGHTNESS CONTROLbutton is pressed, the battery
or
low indicator will flash for 5 seconds and then remains non-blinking.
GENERAL FEATURES
Reset
Should you receive external interference e.g. static electricity from carpets, thunderstorms, etc. Which affects the display and electronic functions of your set, RESET
allows you to clear all previous settings and start up again.
• Use a ballpoint pen to press RESET , found inside battery compartment.
Demo mode
When the set is first connected to a power supply or has been reset, ‘PHILIPS’ will
scroll continuously across the demonstration display.
•
Press SET AL / TIME to exit the demo mode, before you set the times or
RADIO ON / OFF
press
or
ALARM RESET / SLEEP
to switch on the Radio.
Illumination brightness
Press REPEAT ALARM•BRIGHTNESS CONTROLonce or more.
•
The brightness of the display will change in this sequence:
bright➟Medium➟dim
•
The brightness of the display will change in this sequence:
off ➟bright (5 seconds)➟OFF
(for AC adapter on)
(for batteries)
Note:
When the alarm or SLEEP function is active, the brightness cannot be adjusted
SETTING THE CLOCK AND ALARM TIMES
The time is displayed using the 24-hour clock.
Setting the clock time
1.
Press SET AL / TIME twice within a second to enter
the clock time setting mode.
™
The clock time display flashes and you will hear a
short beep.
2.
Hold down or press HOUR + or MIN + repeatedly to
set and adjust the hours and minutes respectively.
Release HOUR + or MIN + when you have reached the
correct setting.
3.
After both the hours and minutes are set, press SET AL / TIME to confirm the
setting.
™ You will hear two short beeps.
R
E
R
U
O
H
PM
Setting the alarm time
1.
Press SET AL / TIME once to enter the alarm time setting mode.
™ lights up and t
2.
Hold down or press HOUR +or MIN + repeatedly to set and adjust the hours
he alarm time display flashes. You will hear a short beep.
and minutes respectively. Release HOUR+or MIN + when you have reached
the correct setting.
3.
After both the hours and minutes are set, press SET AL / TIME to confirm the
setting.
™ You will hear two short beeps.
™ Display returns to clock time.
•
Time setting is also automatically confirmed after 10 seconds after you set the time.
•
It is not possible to adjust the alarm time during an alarm call or the repeat
alarm mode.
RADIO (FM only)
1
Press
RADIO ON / OFF
™
Display shows ON shortly.
2
Adjust TUNING to find your radio station
3
Adjust the sound using VOLUME
4
Press
RADIO ON / OFF
To improve reception:
• Extend and position the pigtail fully to obtain optimum reception.
once to switch on the radio.
.
.
to switch off.
P
E
A
T
A
L
A
R
M
•
B
R
I
G
H
T
N
E
S
S
C
O
N
T
R
O
L
PM
M
I
N
USING THE ALARM
General (see 2)
If you wish to use the alarm, first set the alarm time before selecting your choice
of alarm mode. By rotating the set in 4 different position, you can choose Radio
(FM) / Buzzer / Submarine / Frog to wake you up.
As you rotate the set, AJ3136 interacts in the following way. You will :
™ hear a special whirring sound effect
™ see the backlight blink briefly.
The hour and minute display will also adjust to match the new rotated position.
TIP :
•
If you wish to deactivate or activate the whirring sound, press and hold on the
HOUR + and RADIO ON / OFF buttons simultaneously.
•
When the batteries on AJ3136 are low, the battery low icon blinks. No
blacklight and sound effects are possible.
Setting the alarm
1.
Press ALARM ON / OFF once to switch on the alarm.
™ lights up.
2.
Rotate the set with the symbol of the alarm mode, which you wish to be woke
up, facing on the top.
When reach alarm setting time, Radio, Buzzer, Submarine or Frog will switch on
for about 30 minutes and the alarm indicator flashes.
• For Buzzer option only, your gentle wake alarm increases its beep tone frequency
within seconds.
Switching off the alarm
24HR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain the
same alarm setting for the following day:
•
Press ALARM RESET / SLEEP.
™
You will hear a sound “Ding Dong” confirming 24 hour reset activation.
REPEAT ALARM
This will repeat your alarm call at 5 minute intervals.
•
During the alarm call, press REPEAT ALARM•BRIGHTNESS CONTROL
™
The alarm indicator flashes during repeat alarm.
•
Repeat if desired.
CANCELING THE ALARM COMPLETELY
•
During alarm activated or repeat alarm mode, press ALARM ON / OFF once.
Alarm will be switched off completely.
™
The alarm indicator disappears.
SLEEP
About Sleep
This set has a built-in sleep timer, which enables the radio to be automatically
switched off after a set period of time. There are four sleep time options.
Setting and switching off sleep
1
Press
ALARM RESET / SLEEP
2
Within 1 second, press ALARM RESET / SLEEP again once or more to select your
sleep time.
The sleep time options:
•
SL : 30, SL : 20, SL : 10 and OFF.
™
The Sleep indicator lights up.
3
To cancel sleep, press either:
ALARM RESET / SLEEP once or more until disappears from the display.
–
– REPEAT ALARM•BRIGHTNESS CONTROL
to switch on the radio
MAINTENANCE
•
If you do not intend to use set for a long time, remove the batteries.
•
Do not expose the set to humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
•
To clean your set, use a soft damp cloth or chamois leather. Do not use cleaning products, which contain benzene, thinner, etc. as these may harm the
housing.
ENVIROMENTAL INFORMATION
We have reduced the packaging to its minimum using only paper and cardboard.
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe local regulations to dispose of
packing materials, exhausted batteries and old equipment.
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
guarantee
will invalidate the
electric shock!
No sound
Volume not adjusted
–
• Adjust the VOLUME
No display backlight / display malfunction/ radio and alarm do not
function
–
Set is in Power Low mode
• Connect AC/DC adapter or insert fresh batteries
. Do not open the set as there is a risk of
Display error / no reaction to any controls
–
Electrostatic discharge / Electrical interference: set too close to TV, VCR or computer
•
Press the RESET hole inside battery compartment of the set with a
ballpoint pen. Or disconnect set from AC/DC adaptor and batteries for 5 minutes, then re-plug.
Intermittent crackling sound during FM reception
–
Weak signal
•
Extend and position the pigtail aerial
The alarm does not function
–
Alarm time/ mode not set
• See SETTING THE ALARM TIME
–
Volume too low for radio
• Increase the volume
RADIO not tuned to a radio station
–
• Tune to a station
Rattling sound. Is something loose ?
No. You will hear a slight rattling sound if you shake the set. This is perfectly normal
as the AJ3136 uses a special contact device inside the set to detect rotation.
This product complies with the radio interference requirements of the
European Union.
The model and serial number are located inside the battery
compartment.
Printed in China
Meet Philips at the Internet
http://www.philips.com
AJ3136
AJ3136Clock Radio
Deutsch
Nederlands
Italiano
English
Français
Español
AJ 3136
Loading...