Philips AJ3120-79 User Manual
Clock Radio
User manual
AJ3120
1!2 4 5 6 783
@
#
A
L
ARM
88
92
96
100
104
108
FM
MW
K
iloh
ertz
Megahertz
5
30
6
30
8
00
10
00
13
0
0
16
0
0
Kilohertz
Megahertz
FM
MW
•
•
•
S
L
EEP
OFF
•••
AL
A
R
M
R
ES
ET
S
ET
T
IM
E
S
E
T
A
L
A
R
M
CLOCK
V
O
L
U
M
E
T
U
NIN
G
BAND
MW•FM
FM
AM
CL
OCK RADIO
SL
E
E
P
RADIO
OFF• ON
ALARM
OFF•RAD•BUZ •
09
English
CONTROLS
1 SLEEP -
activates the radio for sleep function
2 Clock control
- CLOCK :
to run on clock time
- SET ALARM :
sets the alarm time
- SET TIME :
sets the clock time
- HR/MIN :
adjusts the hours/ minutes for the clock and alarm times
3 ALARM RESET -
stops the active alarm for 24 hours
4
SLEEP OFF
/REPEAT ALARM
-
switches off the radio sleep function
-
switches off the active alarm for a 8-9 minute period
5 DISPLAY - show the clock/ alarm times and status of the set
6 VOLUME - adjusts the sound level
7 BAND - select FM/AM (MW or LW) waveband
8 TUNING - tunes to radio stations
9 RADIO
OFF•ON
-
switches the radio off/on
0 ALARM
–
OFF switches off the alarm
–
RAD activates the radio for alarm setting
–
BUZ activates the buzzer for alarm setting
! Battery door -
opens to store a 9 volt 6F22 type battery (not included) for
clock memory backup
@ Mains lead -
for AC mains supply
#
Pigtail aerial-improves FM reception
The type plate is located on the bottom of the set.
INSTALLATION
POWER SUPPLY
1
Check if the mains supply, as shown on the type plate located on the
bottom of the set, corresponds to your local mains supply. If it does not,
consult your dealer or service centre.
2
Connect the mains lead to the wall socket.
3
To disconnect the set from the mains supply completely, remove the plug from
the wall socket.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be stored
for up to a day when there is a power interruption e.g. mains failure. The
complete clock radio and display illumination will be switched off. As soon as the
mains supply returns, the display will indicate the correct time.
1
Remove the battery door to insert a 9 volt 6F22 type battery (not included) for
backup.
2
Replace the battery door.
NOTE:
If no backup battery is installed or the power interruption is prolonged, you
will need to set the clock and alarm times again.
Batteries contain chemical substances so should be disposed of
properly.
Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3W
CAUTION
Use of controls or adjustments or performance of procedures other than
herein may result in unsafe operation.
Loading...