Philio Technology PSR04 User Manual

PSR04 Smart Color Button

Full Color LED 1

Touch Button

Fig. 1 Assembling

Red LED

Full Color LED 2

This round device is a flexible and multi functions button switch. It is able to
switch the appliances on/off or activate the scenes and macros which are preset
already. The rotation sensor make it possible to adjust the percentage of dimmer
or thermostat. It can also work as a timer. The well designed wall bracket and
magnetic back let the switch can be fixed on the wall, PlusTM enabled device
and is fully compatible with any Z-WaveTM enabled network.

Note:
Please provide a 5 DVC voltage to wake the device up before the
first using.
The rotation function and timer functions work only when the
device is fitted upright or stick on the wall or the device will

only work as an on/off switch when fitted horizontal.

LED indicators

1. LED type and locations
There are two sets of LED embedded in the device.

A. Set 1: Two full color LED lights round the device.
B. Set 2: One red LED under the arrowhead on at the front side.

2. Low battery
The device will enter low battery mode when the battery power is under
20%. The red LED flashes three times every one minute.

3. NWI Auto Inclusion
The red LED will flash quickly for 30 seconds when device entering in NWI
mode.

4. Percentage adjustment mode
The full color LED will turn from green to red according to the percentage
from 0% to 100%. (shown in Fig 3.)

5. Timer mode

A. The red LED will flash once when device entering/exiting the timer

mode..

B. The full color LED will flash once every 10 seconds and the color will

depend on time table (shown in Fig 3.)

1

C. The full color LED will flash once with pink every 10 second when

countdown from 30.

D. The full color LED will flash with pink light every 1 second when

countdown from 5.

E. The red LED will flash 6 times with white when time’s up.

Z-Wave Network Setting Up

There is a touch button on the front side. The button carry out inclusion,
exclusion and reset to default.

1. Include: Pointing the arrowhead to area A first (shown in Fig. 2). Pressing
the button three times within 1.5 seconds. The red LED will light up for 1
second if succeed.

2. Exclude: Pointing the arrowhead to area A first (shown in Fig. 2). Pressing
the button three times within 1.5 seconds.

3. Reset to default: Pointing the arrowhead to area A first ((shown in Fig. 2)).
Pressing button four times within 2 seconds and hold at fourth. The red LED
will light for 3 seconds, release the button within 2 seconds while the LED
go out. The LED will flash for 1 second if reset succeed, or LED will flash
once

.

Build-in Buzzer

1. Turn light on: Beep once.

2. Turn light off: Long beep once.

3. Timer:

A. Beep once for setting up the timer.
B. Long beep once for stop counting down.
C. Beep once every ten seconds for countdown from thirty.
D. Beep once every per second for countdown from five. Four times

beep and repeat six times when time’s up.

D

C

B

A

Fig. 2 Control Area

2

Fig. 3 Timer Table