Pentair 2-SPEED RELAY installation Guide

2-SPEED RELAY INSTALLATION INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

WARNING

Before installing this product, read and follow all warning notices and instructions which are included. Failure to
follow safety warnings and instructions can result in severe injury, death, or property damage.
Call [phone] for additional free copies of these instructions.

Important Notice

Attention Installer.

This manual contains important information about the installation, operation and safe use of this
product. This information should be given to the owner/operator of this equipment.

1. Turn power off to Load Center.

2. Remove High Voltage Cover
Panel. Fold down Outdoor Control
Panel.

3. Assemble relay bracket below
filter pump relay, (2 screws).

4. Snap 2-speed relay into bracket.
Wire filter pump relay and
2-speed pump relay as
shown in Figure 1.

5. Plug 2-speed relay into 2-speed
socket on Personality PCB.

6. Install High Voltage Cover Panel.
Fold up Outdoor Control Panel.
Close Load Center door.
Turn on power.

7. Configure system.
(See Reverse side.)

Figure 1.

Pentair Water Pool and Spa, Inc.

1620 Hawkins Ave., Sanford, NC 27330 • [phone]
10951 West Los Angeles Ave., Moorpark, CA 93021 • [phone]

Rev. A 4-26-06 1 P/N 520210

SAVE THESE INSTRUCTIONS.

Pentair Water Pool and Spa, Inc.

1620 Hawkins Ave., Sanford, NC 27330 • [phone]
10951 West Los Angeles Ave., Moorpark, CA 93021 • [phone]

P/N 520210 2 Rev. A 4-26-06