Pelonis HR-0031 User Manual

OWNER’S MANUAL

ot when in use. To avoid burns, do not let bare skin touch hot surfaces.

Radiant

Heater

Model HR-0031

PLEASE READ AND SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:

1. Read all instructions before using this heater.

2. This heater is h
If provided, use handles when moving this heater. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from
the front of the heater and keep them away from the sides and rear.

3. Extreme caution is necessary when any heater is used by or near children or invalids
and whenever the heater is left operating and unattended.

4. Always unplug heater when not in use.

5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment, or
repair.

6. Do not use outdoors.

7. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into bathtub or other water container.

8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tripped over.

9. To disconnect heater, first turn controls to off, then remove plug from outlet.

10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.

11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.

12. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where
gasoline, paint, or flammable liquids are used or stored.

13. Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.

14. Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
No. 14 AWG minimum size and rated no less than 1875 watts.

15. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do
not plug the heater into a circuit that already has other appliances working.

16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC
outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn outlet.

17. The output of this heater may vary and its temperature may become intense enough to
burn exposed skin. Use of this heater is not recommended for persons with reduced
sensitivity to heat or an inability to react to avoid burns.

18.“SAVE THESE INSTRUCTIONS”

OPERATING INSTRUCTIONS

Control Panel Functions

C

IMPORTANT!

Your heater is equipped with a
polarized alternating current line
plug (a plug having one blade
wider than the other). This plug
will fit into the power outlet only
one way. This is a safety
feature. If you are unable to
insert the plug fully into the
outlet, try reversing the plug. If
the plug should still fail to fit,
contact your electrician to
replace your outlet. DO NOT
defeat the safety purpose of the

A B

Power and Setting Control Power Indicator Light

Caution Indicator Light

C

Place the heater on a firm level surface free from obstructions, and at least 3 ft. away from
any wall and any other objects such as furniture, curtains, plants or combustible material.

With the Power and Setting Control “ A” in the ” MIN” position, the Power Indicator Light

“ B” not illuminated, and the heater in “OFF”status, plug the heater into a grounded

120V outlet.

Turn the heater ”ON” by turning the Power and Setting Control “ A” clockwise to your
desired setting .The Power Indicator Light “ B” will illuminate. The power setting operates at

1500 Watts. Turn the heater ”OFF” by turning the Power Control to “MIN”.

B

A

Carry
Handle

ADDITIONAL FEATURES

This heater has additional features:

 Internal Safety Fuse - acts as back up protection to the Thermal Cut-Off Protection

System.

 Convenient Carry Handle – allows for easy transport from room to room.

TROUBLESHOOTING

If your heater fails to operate, please follow these instructions:

 Ensure that your circuit breaker or fuse is working properly.
 Be sure the heater is plugged in and that the electrical outlet is working properly.
 Check for any obstruction. If you find any obstruction, turn the heater “ OFF” . Unplug the

heater and wait a few minutes for it to cool down. Carefully remove the obstruction. Plug
the heater in and turn it on again by referring to the OPERATING INSTRUCTIONS.

NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE
WARRANTY INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR
REPAIR THE HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD
CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE
CONTACT US BY REFERRING TO THE SERVICE & SUPPORT INFORMATION ON THE
FOLLOWING PAGE.

CLEANING AND STORAGE

It is recommended that the heater be cleaned at least one time during the operating season in order
to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF AND
UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-season storage.

 Turn the heater “ OFF” , unplug it and wait for the heater to cool down.
 Use a dry cloth to clean only external surfaces of the heater.
 Do not use any cleaning agents or detergents.
 Never immerse the heater in water.

 Pack the heater in the original carton and store it in a cool and dry place.

The power and Setting Control “ A” can be use as a thermostat. Turn the “ A” to your desired
setting from “ MIN” to “ MAX” . Turning the “ A” clockwise will increase the “set” temperature;
turning the thermostat counterclockwise will decrease the “set” temperature.

When the room reaches a comfortable temperature, slowly turn the “ A” counter-clockwise
until the heater turns off. This is the point at which the thermostat setting equals the room
temperature. At this setting, the thermostat will automatically turn the heater on and off to
maintain this selected temperature.

CAUTION: This heater includes an Overheat Protection System that shuts the unit off if it
overheats due to abnormal conditions. At this time, the “C” Caution Indicator Light gets on. If
this occurs turn the heater “OFF”, unplug it, and inspect and remove any objects on or adjacent
to the heater. Allow it to cool for a few minutes, plug it back in, and resume normal operation.

SPECIFICATIONS

Model No.: HR-0311
Voltage: 120V, 60Hz
Current: Maximum continuous draw: 12.5 Amps.
Output: 5200 BTUs
Power: LOW = 900 Watts, HIGH = 1500 Watts

Tolerances on all specifications: Approximately +5%, -10%.