Pelican RT1-DC Installation Manual

Installation Guide

RT1-DC Remote Thermostat & Sensor

The RT1-DC Remote Thermostat is a battery operated wireless
thermostat. It is designed to be used as a slave to a master Pelican
Thermostat or Pelican Thermostat Control Module. For additional
assistance visit www.PelicanWireless.com to request support.

Wall Mounting

For best results, the Remote Thermostat should be mounted in a
location that doesn't receive direct sunlight and is away from entry
doors where sudden temperature changes may occur. It should be
mounted at a height which allows the display to be easily read,
usually between 48” and 60” above the floor.

The rear cover of the remote thermostat is mounted to the wall. To
separate the front cover from the rear cover, simply grasp the front
and back of the unit firmly and pull apart.

Attach the rear of the Remote Thermostat to the wall using the
included plastic anchors. Position the rear cover at the desired
location, then mark the locations of the mounting points on the wall.
Drill a 3/16” hole for each anchor. Insert the anchors into the wall and
attach the rear cover using the included screws. The thermostat can
also be mounted to an electrical box using the included machine
screws.

Batteries

The remote thermostat is powered by 2 “AA” standard cell batteries
(included). Insert the batteries into the two battery holders on the

07/15/2011

front section of the thermostat. Orient the batteries as shown on the
battery holders. When properly installed, the blue backlight will blink
twice rapidly and the display will show the current temperature. The
front section can then be re-attached by centering it over the rear
section and snapping it into place.

Setup

All setup functions of the remote thermostat are completed from the
Pelican Site Manager. This will be accessible when the remote
thermostat automatically establishes wireless communications to the
Internet through your Pelican Wireless Gateway.

The configuration settings can be found in the Pelican Site Manager
from the Admin → Remote Thermostat Config menu. New remote
thermostats can take up to 10 minutes to register on the Pelican Site
Manager.

07/15/2011