IJTFV-PA & IMV-PA
Pendant Mount Adapters
Installation Guide
C6694M
IP Surveillance
IJTFV-PA Mounting Adapter Contents
IMV-PA Mounting Adapter Contents
Dimensions
IJTFV-PA
Accessory Compatible Cameras
IMV-PA IMV Series Only
IJTFV-PA A: IJV Series
B: ITV Series
C: IFV Series
IMV-PA
2
AM-52E
AM-116
AM-117
AM-118
AM-52E
NPT pipe
AM-522
AM-118
NPT adaptor
Installing to SRXV-PP Pendant Pipe
1. Install Pendant Pipe according to QIG
included with SRXV-PP
2. Attach the pendant mounting adapter to
the pipe by rotating it clockwise until it is
tightly fastened.
3. Tighten the retention screw using the
included hex wrench.
English
WARNING:
1. Select a suitable location where the camera is free from accidental damage, tampering,
or harsh environmental conditions.
2. Locate a place for the installation where the camera can not be intentionally or
unintentionally interfered.
3. Select a solid and at mounting surface that can support the combined weight of the
camera and associated hardware. Vibration and temperature range should also be taken
into consideration.
3
4. Pull the cables through the pendant pipe, and install the waterproof cable gland. Install
the camera using the corresponding mounting holes.
5.5 ~ 6.4mm
NOTE:
Some cameras come with a side-routing cutout. Use the included side lid to seal
the cutout.
4
Installing to SRXV-WMP
1, Attach the mounting adapter to the bracket by rotating it clockwise until it is tightly
fastened.
English
1
Mounting adapter
2
3
Dome camera
2. Use a hex wrench to secure the mounting adaptor to the wall-mount bracket.
3. When cabling is done, proceed with initial setup such as enabling network access, focus
tuning, or zooming. When done, secure the outer dome cover.
Pelco, Inc.
625 W. Alluvial, Fresno, California 93711 United States
USA & Canada
International
www.pelco.com
Tel (800)289-9100 Fax (800) 289-9150
Tel +1 (559) 292-1981 Fax +1 (559) 348-1120
5
Loading...