Pelco FSV10D1S1ST, FSV10D1S1FC, FSV10D1M1ST User Manual

INSTALLATION AND OPERATION MANUAL

FSV10D1(M,S)1(ST,FC)

10-BIT DIGITAL VIDEO TRANSMITTER
WITH BIDIRECTIONAL RS422 OR COAXITRON®
UP-THE COAX DATA FOR PELCO™ DOME CAMERAS

The FSV10D1(M,S)1(ST,FC) series video transmitters and receivers support

simultaneous broadcast-quality video transmission of 10-bit digital video and

bidirectional RS422 data or Coaxitron® up-the-coax protocol, utilizing time-based

correction to achieve distances up to 69km (43mi), over one multimode or single mode

optical fiber. The transmitters are designed to plug directly into the Pelco Spectra® IV

dome, and connect with power, video input and two way data via the Pelco electrical

connector. See Figure 3 on Page 4 for in-dome installation instructions.

The receiver can be configured to communicate with the in-dome transmitter in RS422

or Coaxitron mode. See Figures 7 and 8 on Page 6 for configuration settings.

See Figures 1 – 8 for complete installation details.

Tech SupporT: [phone] InTernaTIonal: [phone]

C5632M / REV 11-06-12

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the
provided plug does not fit into your outlet consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the points where they exit
from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury from tip-over.

13. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped.

14. Apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases shall be placed on the
apparatus.

15. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.

16. Installation should be done only by qualified personnel and conform to all local codes.

17. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must
not be installed where exposed to rain and moisture.

18. Use only installation methods and materials capable of supporting four times the maximum specified load.

19. A CCC-approved power cord must be used to power this equipment when used in China.

20. CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not
perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

The product and/or manual may bear the following marks:

This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.

This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.

CAUTION:

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

Tech SupporT: [phone] InTernaTIonal: [phone] C5632M / REV 11-06-12

INSTALLATION AND OPERATION MANUAL FSV10D1(M,S)1(ST,FC)

FIGURE 1 – TRANSMITTER

Each model includes one optical fiber cable as follows:

• FSV10D1M1ST – 13 inch multimode ST cable

• FSV10D1S1ST – 13 inch single mode ST cable

• FSV10D1S1FC – 13 inch single mode FC cable

MULTIMODE OR

SINGLE MODE

OPTICAL FIBER

FIGURE 2 – TRANSMITTER

BOTTOMTOP

Tech SupporT: [phone] InTernaTIonal: [phone]

C5632M / REV 11-06-12