C3987M-A-EN (04/14)
FD2 RPLC LOWER DOME SMOKED
Indoor Dome Camera
Installation Instruction
A
Before attempting to install this product, please read these instructions carefully and save
this manual for future use.
FD2 series model names:
FD2-F3-6(X)
FD2-F4-6(X)
FD2-V10-6(X)
FD2-DV10-6(X)
FD2-IRV10-6(X)
FD2-DWV10-6(X)
1
Menu Settings
Important Safety Instruction
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Only use attachments/accessories specified by the manufacturer.
10. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When
a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
11. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
12. Apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases shall be
placed on the apparatus.
13. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
14. Installation should be done only by qualified per sonn el and c onform to all local codes.
15. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor
use only and it must not be installed where exposed to rain and moisture.
16. Use only installation meth od s and mater ial s capa ble of supp orting four ti mes the maximum specified load.
2
C3987M-A-EN (04/14)
Menu Settings
Important Safety Instruction
This symbol indicates that there are important operating and maintenance instructions in the
sensitive to Electrostatic Discharge (ESD). To avoid ESD damage to this
product, use ESD safe practices during installation. Before touching, adjusting or handling this
to ANSI/ESD S20.20-1999 or contact the Electrostatic Discharge Association (www.esda.org).
CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock
do not perform any servicing other that contained in the operating instructions unless you are qualified to do so.
Only use replacement parts recommended by Pelco.
The product and/or manual may bear the following marks:
This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this
unit.
CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN.
literature accompanying this unit
WARNING: This product is
product, correctly attach an ESD wrist strap to your wrist and appropriately discharge your body and
tools. For more information about ESD control and safe handling practices of electronics, please refer
3
C3987M-A-EN (04/14)
Menu Settings
Replacing & Installation
How to replace and install new dome bubble
1. Insert a coin or a flat tool to the side hole first.
2. Twist coin or flat tool to take the dome cover apart fr om the base.
3. Take out the original do m e cover upward.
4. Replace by the new do me cover and click downward to complete the installation.
4
C3987M-A-EN (04/14)
Troubleshooting Information
All rights reserve d.
Pelco Troubleshooting Contact Information
If the instructions provided fail to solve your problem, contact Pelco Product Support at 1-800-289-9100 (USA and Canada)
or +1-559-292-1981 (international) for assistance. Be sure to have the serial number av aila ble when calling.
Do not try to repair the unit yourself. Leave maintenance and repairs to qualified technical personnel only.
This equipment contains electrical or electronic components that must be recy cle d
properly to comply with Dir ective 2002/96/EC of the European Union regarding the
disposal of waste electric al and electronic equipment (WEEE). Contact your local
dealer for procedures for recycling this equipment.
REVISION HISTORY
Manual # Date Comments
C3987M 04/14 Original Version
Pelco, the Pelco logo, and ot her trademarks associated with Pelco products referred to in this publicat ion are trademarks of Pelco, Inc. or its a ffiliates. © Copy right 2014, Pelco, Inc.
ONVIF and the ONVIF logo a re trademarks of ONVIF Inc. All other product names and services are the property of the ir respective co mpanies.
Product specifications and availabi lity are subject to change without notice.
5
C3987M-A-EN (04/14)
6
Loading...