Pelco EC-3016ULPOE-R, EC-3016CLPOE-R, EC-3008ULPOE-R, EC-3008CLPOE-R, EC-3004URPOE-W Specsheet

PRODUCT SPECIFICATION

transmission and power

EC-3000C/U Series EthernetConnect™ Extender

1, 4, 8, OR 16 PORTS WITH TRUE POE TO 30 WATTS, LOCAL OR REMOTE

Product Features

• Transmits Individual Ethernet Data Channels with Power over

Ethernet Plus (PoE+) Power Injection and Pass-Through PoE+ over
Standard Cat5/Cat5e/Cat6 UTP Cable or Coaxial Cable

• Extends Ethernet up to 914 m (3,000 ft) at 10 Mbps or

610 m (2,000 ft) at 100 Mbps over Cat5/Cat5e/Cat6 UTP Cable

• Extends Ethernet up to 1,524 m (5,000 ft) at 10 Mbps or

549 m (1,800 ft) at 100 Mbps over Coaxial Cable

• Extended Temperature Operation from

• Extended Pass-Through PoE Meets the IEEE802.3at Standard for

Power over Ethernet

• Full 10/100 Mbps Bandwidth

• Supports Multicast, Unicast, and Jumbo Frame

• Symmetric Bandwidth Provides Consistent Upload and Download

with Virtually Zero Packet Loss over the Total Usable Distance

• Type Tested to RFC-2544 TCP/IP Network Bandwidth Packet

Transmission Standards

• User-Selectable Data Rate for Maximum Bandwidth and

Transmission Distance Utilization

• Complies with all Major IEEE Standards and RFC Network Protocols

for UDP, TCP/IP, HTTP/HTTPs

–40° to 75°C (–40° to 167°F)

• Tested and Certified by an Independent Laboratory for Full

Compliance with the Environmental Requirements (Ambient
Operating Temperature, Mechanical Shock, Vibration, Humidity with
Condensation, High-Line/Low-Line Voltage Conditions, and Transient
Voltage Protection) of NEMA TS-1/TS-2 and the Caltrans
Specification for Traffic Signal Control Equipment

• LED Status Indicators Confirm Operating Status

• Available in Small Unit Size, Interchangeable Stand Alone, or 1 RU

Rack Mounted-Models

• Designed and Manufactured in the USA

The EC-3000C Series is ideally suited for applications where the
existing coaxial cable needs to be leveraged for transmission of IP
signals. For UTP applications, the EC-3000U Series is an effective
Cat5/Cat5e/Cat6 UTP extender device beyond the 100 m (328 feet)
limit of traditional Ethernet. In addition, for system configurations
that have a single cable connected to the camera, the EC-3000C/U
Series can become a true PoE device and source PoE to the powered
device. This eliminates the need for midspans or PoE-enabled
Ethernet switches to provide a fully 802.3at compatible application.
Designed to be a cost-effective, advanced-use product, the
EC-3000C/U Series provides maximum flexibility in these
applications without any programming.

™

The EthernetConnect

EC-3000C/U Series is used to extend

Ethernet over copper (EoC). The EC-3000C Series extends up to 16
channels of 10/100 Mbps Ethernet with PoE+ power injection and
pass-through PoE+ over coaxial cable. The EC-3000U Series
extends up to 16 channels of 10/100 Mbps Ethernet with PoE+ power
injection and pass-through PoE+ over twisted pair cable (Cat5/
Cat5e/6 UTP). With the ability to connect directly to a PoE+ switch or
the ability to generate PoE+ power with a 48 V input to either the
local or remote ends, these units provide the ultimate flexibility for
extending a powered device (PD) over long distance copper.

A complete set includes both a local and a remote module. Remote
modules are small unit size in either a one- or four-channel
configuration. Local modules are also available in the small unit size
in one- or four-channel configuration as well as available in a 1 RU
rack size for larger channel counts. All application configurations
should be verified at the time of ordering to facilitate ease of
installation.

International Standards

Organization Registered Firm;

ISO 9001 Quality System

C3977 / NEW 3-10-14

TECHNICAL SPECIFICATIONS

IMPORTANT NOTE. PLEASE READ. The network implementations are shown as general representations only and are not intended to show detailed

network topologies. Your actual network will differ, requiring changes or perhaps additional network equipment to accommodate the systems as
illustrated. Please contact your local Pelco representative to discuss your specific requirements.

TYPICAL APPLICATIONS

Note: Coaxial applications use EC-3000C modules; UTP applications use EC-3000U modules.

PoE PASS-THROUGH MODE

REMOTE PoE INJECTION MODE

LOCAL PoE INJECTION MODE

MULTICHANNEL PoE APPLICATION

TECHNICAL SPECIFICATIONS

ELECTRICAL

Operating Voltage

Pass-Through Mode

1 CH N/A; Optional input voltage

12 to 32 VDC or 18 to 32 VAC

4 CH 12 VDC, 5W;

†

9 VDC

when in a USRACK or EURACK
8 CH 12 VDC, 10 W
16 CH 12 VDC, 20 W

Power Injection Mode

1 CH 48 to 56 VDC, 30 W
4 CH 48 to 56 VDC, 120 W
8 CH 48 to 56 VDC, 240 W
16 CH 48 to 56 VDC, 480 W

Current Protection Automatic resettable solid-state current

limiters
MTBF >100,000 hours
LED Indicators Operating power;

PoE power;

Ethernet link and activity;

extended link and activity

DATA

Data Interface 10/100Base-T Ethernet
Data Rate DIP switch selectable 10/100 Mbps;

RFC 2544 TCP/IP packet transmission
Standards

PoE+ IEEE802.3af/at
RFC 768 UDP, 2068 HTTP, 793 TCP, 791 IP,

Maximum Transmission Distances

Media COAX-RG59/U UTP, 4 Pair

Camera Data Rate

Source Power

Non-PoE
Camera*

Remote

Injection

PoE CLASS2

Camera (6.5 W)*

PoE CLASS3

Camera (13 W)*

(10 W in pass­through mode)

PoE CLASS4

Camera (25.5 W)*

(22 W in pass­through mode)

*Distance figures are based on a 50 V PSE PoE power source, and external

power supplies for the extenders. Distance figures are obtained using
in-house testing mirroring installations. Factors such as coaxial and copper
cable quality, the number of connectors and splices in the cable run, the
use of PoE, and environmental conditions encountered within the
installation might affect the actual transmission distance and should be

15 W30 W15 W30 W15 W30 W15 W30 W

*

259 m

(850 ft)

N/A

taken into consideration.

full data rate/full-duplex up to the maximum

rated distance

1783 TFTP, 894 IP over Ethernet

10 Mbps 100 Mbps 10 Mbps 100 Mbps

1,524 m

(5,000 ft)

1,524 m

(5,000 ft)

914 m

(3,000 ft)

(850 ft)

(335 ft)

259 m

102 m

259 m

(850 ft)

N/A

549 m

(1,800 ft)

549 m

(1,800 ft)

549 m

(1,800 ft)

(850 ft)

(335 ft)

914 m

(3,000 ft)

914 m

(3,000 ft)

914 m

(3,000 ft)

259 m

259 m

(850 ft)

(850 ft)

102 m

N/A N/A N/A N/A

259 m

259 m

(850 ft)

610 m

(2,000 ft)

610 m

(2,000 ft)

610 m

(2,000 ft)

259 m

(850 ft)

GENERAL

Dimensions

1 CH 8.4 x 6.4 x 2.8 cm

(3.3" D x 2.5" W x 1.1" H)

4 CH 15.5 D x 13.5 x 2.8 cm

(6.1" x 5.3" W x 1.1" H)

8 CH 15.5 x 48.26 x 4.45 cm

(6.1" D x 19" W x 1.75" H)

16 CH 15.5 x 48.26 x 4.45 cm

(6.1" D x 19" W x 1.75" H)

Operating Temperature –40° to 75°C (–40° to 167°F)
Storage Temperature –40° to 80°C (–40° to 176°F)
Relative Humidity 0% to 95%, noncondensing
Shipping Weight

1 CH <0.5 kg (1 lb)
4 CH <0.9 kg (2 lb)
8 CH <2.3 kg (5 lb)
16 CH <2.3 kg (5 lb)

CERTIFICATIONS/RATINGS

• CE, Class A

• FCC, Part 15, Class A

• UL/cUL Listed

•C-Tick

• Designed to meet NEMA TS-1/TS-2 and the Caltrans traffic signal control
equipment environmental standards

RECOMMENDED ACCESSORIES

ECPS-12VDC-0.5A

ECPS-12VDC-3A

FEXTPS-48V

ECPS-48VDC-5A

ECPS-48VDC-10A

USRACK

EURACK

RACK1B Single-width blank module for empty rack slots

†

Contact Pelco pre-sales support, or refer to the appropriate installation and
operation manual when configuring and specifying power for a deployment.

†

EthernetConnect 12 VDC, 0.5 A power supply
for non-pass-through mode applications

†

EthernetConnect 12 VDC, 3 A power supply
for non-PoE pass-through mode applications
on EC-3008CLPOE-R, EC-3008ULPOE-R,
EC-3016CLPOE-R, and EC-3016ULPOE-R

†

EthernetConnect 48 VDC, 1.36 A power
supply for power injection mode applications

†

EthernetConnect 48 VDC, 5 A power supply
for power injection mode applications

†

EthernetConnect 48 VDC, 10 A power supply
for power injection mode applications

†

Rack-mount chassis, 14-slot, 9 VDC, 6.5 A,
internal power supply, US power cord

†

Rack-mount chassis, 14-slot, 9 VDC, 6.5 A,
internal power supply, EU power cord

MECHANICAL

Connectors

Ethernet RJ-45
Extended Interface

Coaxial Female BNC
UTP RJ-45

Operating Power Powered by PoE or two-pin screw terminal

TECHNICAL SPECIFICATIONS

MODELS

EC-3000C SERIES (COAXIAL CABLE)

Local

EC-3001CLPOE-M EthernetConnect local single-port coaxial

extender with true PoE to 30 W, EoC using
coaxial cable, mini case, 12 VDC/48 VDC,
24 VAC

EC-3004CLPOE-W EthernetConnect local 4-port coaxial extender

with true PoE to 30 W, EoC using coaxial
cable, wall-mount

C-3008CLPOE-R EthernetConnect local 8-port coaxial extender

with true PoE to 30 W, EoC using coaxial
cable, 1 RU rack-mount

EC-3016CLPOE-R EthernetConnect local 16-port coaxial

extender with true PoE to 30 W, EoC using
coaxial cable, 1 RU rack-mount

Remote

EC-3001CRPOE-M EthernetConnect remote single-port coaxial

extender with true PoE to 30 W, EoC using
coaxial cable, mini case, 12 VDC/48 VDC,
24 VAC

EC-3004CRPOE-W EthernetConnect remote 4-port coaxial

extender with true PoE to 30 W, EoC using
coaxial cable, wall-mount

EC-3000U SERIES (UTP CABLE)

Local

EC-3001ULPOE-M EthernetConnect local single-port UTP

extender with true PoE to 30 W, EoC using
Cat5/Cat5e/Cat6 UTP, mini case,
12 VDC/48 VDC, 24 VAC

EC-3004ULPOE-W EthernetConnect local 4-port UTP extender

with true PoE to 30 W, EoC using Cat5/Cat5e/
Cat6 UTP, wall-mount

EC-3008ULPOE-R EthernetConnect local 8-port UTP extender

with true PoE to 30 W, EoC using Cat5/Cat5e/
Cat6 UTP, 1 RU rack-mount

EC-3016ULPOE-R EthernetConnect local 16-port UTP extender

with true PoE to 30 W, EoC using Cat5/Cat5e/
Cat6 UTP, 1 RU rack-mount

Remote

EC-3001URPOE-M EthernetConnect remote single-port UTP

extender with true PoE to 30 W, EoC using
Cat5/Cat5e/Cat6 UTP, mini case,
12 VDC/48 VDC, 24 VAC

EC-3004URPOE-W EthernetConnect remote 4-port UTP extender

with true PoE to 30 W, EoC using Cat5/Cat5e/
Cat6 UTP, wall-mount

FRONT AND REAR PANEL LAYOUTS (COAXIAL)

FRONT AND REAR PANEL LAYOUTS (UTP)

Pelco by Schneider Electric

3500 Pelco Way, Clovis, California 93612-5699 United States

USA & Canada Tel [phone] Fax [phone]
International Tel [phone] Fax [phone]
www.pelco.com www.pelco.com/community

Pelco, the Pelco logo, and other trad emarks associated with Pelco products referred

to in this publication are trademarks of Pelco, Inc. or its affiliate s. ONVIF and the

ONVIF logo are trademarks of ONVIF Inc. All other product names and

Product specifications and availability are subje ct to change without notice.

services are the property of their respective companies.

©Copyright 2014, Pelco, Inc. All righ ts reserved.