Pelco DA104DT Specsheet
PRODUCT SPECIFICATION
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS;
ALL OTHERS ARE INCHES.
1.75
(4.45)
5.50
(13.97)
ON
OFF
DA1O4DT DISTRIBUTION AMPLIFIER
VIDEO OUT VIDEO IN
F1 2ASB
AC INPU T
8.80
(22.35)
DA104DT Distribution Amplifier
VIDEO AMPLIFIER
Product Features
• 120 or 230 VAC Input Models Available
• Solid-State Electronics
• Desktop or Rack Mount
• Accepts Black-White or Color Video Inputs
• 4 Independent Video Outputs from a Single Video Input
The DA104DT distribution amplifier provides four independent
video outputs from a single video input. Solid-state circuitry
consisting of four identical video amplifiers in parallel provide four
equal 75-ohm loads, which allow the video outputs to be viewed
without distortion or loss of clarity.
communication & power
The DA104DT is a desktop unit. Up to three units can be rack
mounted in a single 1.75-inch by 19-inch (4.44 cm x 48.26 cm) rack
using the R300 rack mount kit, or two units can be mounted side-byside in one chassis using the DT200 dual desktop mount kit.
C605 / REVISED 10-00
International Standards
Organization Registered Firm;
ISO 9001 Quality System
TECHNICAL SPECIFICATIONS
MODELS
DA104DT Distribution amplifier (1 input, 4 outputs)
DA104DT/220 Same as DA104DT except 230 VAC operation
ELECTRICAL
Input Voltage 120 VAC, 50/60 Hz or 230 VAC
Power On/Off Rocker switch
Power Requirements 2.5 VA
Input Impedance 75 ohms
Output Impedance 75 ohms
Gain Unity
Frequency Response Flat within ±1 dB to 10 MHz
Maximum Signal Level 2 Vp-p
Connectors BNC
Fuse Protection 3 AG, .2 ASB
Power Cord 3-wire grounded, 18 AWG
GENERAL
Construction
Cover Steel, black polyester powder coat
Chassis Steel, zinc plated
Panel Aluminum, black polyester powder coat with
white silk-screen
Environment 32° to 120°F (0° to 49°C)
Humidity Tolerance 85%, non-condensing
Unit Weight 3 lb (1.35 kg)
Shipping Weight 4 lb (1.81 kg)
TYPICAL CONFIGURATION
CERTIFICATIONS/RATINGS
• CE, Class B (DA104DT/220)
• UL Listed (DA104DT)
• FCC, Class B (DA104DT)
• Meets NEMA Type 1 standards
OPTIONAL ACCESSORIES
DT200 Dual desktop mount kit; two units can be
R300 Rack mounting kit (1 RU) for up to three
mounted side-by-side in one desktop chassis.
modules. Blank filler panels provided for less
than three modules. (Factory racking available
for R300 rack kit only. Specify when ordering.)
Pelco Worldwide Headquarters:
3500 Pelco Way, Clovis, California 93612-5699 USA
USA & Canada Tel: (800) 289-9100 • FAX (800) 289-9150
International Tel: (559) 292-1981 • FAX (559) 348-1120
www.pelco.com
Peloc and the Pelco logo are registered tradmarks of Pelco.
Specifications subject to change without notice.
©Copyright 2000, Pelco. All rights reserved.
Loading...