Pelco C1421M-B User Manual

®

WD35 Series

Window Defroster Kit

Installation/

Operation Manual

C1421M-B (8/98)

1.0 WARNINGS Prior to installation and use of this product, the following WARNINGS should be

observed.

1. Installation and servicing should only be done by qualified service personnel
and conform to all local codes.

2. Only use replacement parts recommended by Pelco.

Please thoroughly familiarize yourself with the information

in this manual prior to installation and operation.

1.1 UNPACKING Unpack and inspect all parts carefully.
INSTRUCTIONS

The following items are supplied:

1Window defroster
1 C1421M-B Installation/Operation Manual

Be sure to save the shipping carton and any inserts. They are the safest materials in
which to make future shipments.

If an item appears to have been damaged in shipment, replace it properly in its carton
and contact the factory at 1-800-289-9100 or 1-559-292-1981 for a replacement.
(International customers fax [phone] for authorization and instructions.)

If an item needs to be returned to the factory for repair, consult the WARRANTY
AND RETURN section of this manual for instructions.

Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • www.pelco.com
In North America and Canada: Tel [phone] • FAX [phone]

International Customers: Tel [phone] or FAX [phone]

1.2 RECOMMENDED TOOLS Pelco does not supply basic tools needed for the installation process. The following

tools are recommended:

Phillips screwdriver
Flat screwdriver

2.0 DESCRIPTION The WD35 Series Defroster Kits are continuous duty defroster kits for use with the

EH3500 Series Enclosures.

2.1 MODELS WD35-1 Window defroster kit, 120 VAC, 3 watts

WD35-2 Window defroster kit, 24 VAC, 3 watts
WD35-3 Window defroster kit, 230 VAC, 3 watts

2.2 CERTIFICATIONS The products identified below have been tested and certified for agency compli-

ance as noted.

Agency Complance Certification

Model CE FCC UL CSA/cUL

WD35-2 X

WD35-3 X

3.0 INSTALLATION To install the WD35 Series Window Defroster Kit, perform the following steps (see

Figure 1):

1. Disconnect the enclosure from all sources of power and open the enclosure
lid.

2. Remove the camera and sled.

3. Loosen the screws in the bottom window bracket.

4. Remove the top window bracket.

NOTE:

Window defrosters manu­factured after July 1998 have a
metal plate affixed to the defroster.

NOTE:

When a window defroster
and blower are both used, the two
accessories will share the same
terminal locations on the PCB.

5. Position the window defroster with the metal plate against the inside face of
the window. Make sure the defroster wires are in the lower left corner of the
window.

6. Reinstall the top window bracket.

7. Tighten the bottom window bracket screws.

8. Route the defroster wires between the track rail and the body of the enclosure.
Attach the window defroster wires to the PCB terminal locations as shown in
Figure 2. Make sure the window defroster wires are not obstructing any other
accessories within the enclosure.

9. Reinstall the camera and sled.

10. Close the enclosure lid and reconnect power to the enclosure.

2 Pelco Manual C1421M-B (8/98)