Peerless Industries FLD-UNV User Manual
Installation and Assembly - Universal lockdown brackets for
Plasma and LCD Desktop Stands
Read instruction sheet before you start installation and assembly.
Before you start check the parts list to insure all of the parts shown are included.
Model: FLD-UNV (-S)
Parts List
Description Qty Part # Part #
A front lockdown bracket 2 124-1063 124-4063
B back lockdown bracket 2 124-1062 124-4062
C 10-16 x 3/4 penta pin screw 2 520-9258 520-9281
D M5 x 1" penta pin tool driver 1 520-9249 520-9249
E #8 x .5 phillips screw 4 500-101 1 500-1011
F #14 nylon cap cover 2 560-1 158 590-4190
G washer 12 540-9400 540-9400
H #8 x 3/4" phillips screw 4 500-1003 500-1003
Position TV stand to proper location and mark front
of the stand on the desktop.
NOTE: Stand may appear different then illustrated.
TV STAND
FLD-UNV FLD-UNV-S
A
B
C
D
F
G
E
H
Note: Some parts may appear slightly different than illustrated.
Remove screws that hold screen to the stand as
shown below.
BACK OF SCREEN
FRONT
TOP VIEW
Flip TV stand upside down and measure from the
front of the stand to the center of the screw as
shown in detail 1 to get dimension x. Add 1.035"
to get the mounting location of the front lockdown
bracket (A).
FRONT OF TV STAND
BOTTOM VIEW
1 of 3
DETAIL 1
x
FRONT OF TV ST AND
ISSUED: 07-05-05 SHEET #: 124-9422-2 05-07-08
For customer service call 1-800-729-0307 or 708-865-8870.Visit the Peerless Web Site at www.peerlessmounts.com
Position the front lockdown bracket (A) by adding 1.035" with measurement x in step 3 as shown in detail 2.
Attach to desktop using two #8 x 3/4" phillips screws (H).
NOTE: If feet on base are taller than 1/8", use washers (G) between bracket (A) and desktop to achieve
desired height as shown in detail 3.
DETAIL 2
H
1.035
(26)
++
+
A
H
A
DESKTOP
G
X
AT TACHMENT POINT
FRONT EDGE OF ST AND
Remove rubber feet or screws from one or two locations on back of stand depending on stand. Remove rubber feet
or screws from one or two locations on front of stand. Attach back lockdown bracket s (B) to stand with screws (E).
On front location(s) leave 3/16" gap between stand and screw (E).
IDEAL ALTERNATE
OR
B
FRONT OF
ST AND
B
A
G
B
FRONT OF
ST AND
DETAIL 3
BOTTOM VIEW
Flip TV stand right side up and slide into front lockdown bracket (A) so that screw in hole 1 locks securely
into slot of bracket.
TV STAND
DESKTOP
DESKTOP
BOTTOM VIEW
A
SIDE VIEW
2 of 3
For customer service call 1-800-729-0307 or 708-865-8870.Visit the Peerless Web Site at www.peerlessmounts.com
SIDE VIEW
ISSUED: 07-05-05 SHEET #: 124-9422-2 05-07-08
TV STAND
A
Loading...