Peerless Industries EXB-S, EXB, EXA-S, EXA-W, EXA User Manual
...
Installation and Assembly:
Projector Ceiling/Wall Mount
Model# Max UL Load Capacity
EXA, EXA-S, EXA-W, EXB, EXB-S, used with PRS projector mount 25 lb (11.3 kg)
EXB-W, EXC, EXC-S, EXC-W used with PRG projector mount 50 lb (22.7 kg)
This product is intended for use with UL
R
Installed to
Ceiling
Listed products and must be installed by a
qualified professional installer.
Shown with PRG
projector mount and
projector (not included)
Features:
• For use with PRG-UNV and PRS-UNV Projector Mounts
• EXA and EXB series for ceiling or wall mounting
• EXC models for ceiling mounting
• Integrated cable management
• V arious height adjustments for ideal viewing positions
Installed to Wall
(EXC models are not wall mountable
due to its extensive reach)
Shown with PRS
projector mount and
projector (not included)
1 of 11
Visit the Peerless Web Site at www.peerlessmounts.com
3215 W. North Ave. • Melrose Park, IL 60160 • (800) 865-2112 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmounts.com
ISSUED: 1-11-08 SHEET #: 055-9495-2 10-16-08
For customer care call 1-800-865-2112 or 708-865-8870.
Note: Read entire instruction sheet before you start installation and assembly .
WARNING
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-21 12.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
• Never exceed the Maximum UL Load Capacity . See page 1.
• If mounting to wood ceiling/wall studs, make sure that mounting screws are anchored into the center of the studs. Use
of an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly , but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product out doors could lead to product failure and personal injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative supporting surface, contact Peerless customer care at 1 800 865-21 12.
• This product was designed to be installed on the following ceiling/wall construction only;
CEILING/WALL CONSTRUCTION ADDITIONAL HARDWARE REQUIRED
x Wood Stud None
x Wood Joist None
x Solid Concrete None
x Cinder Block None
Metal Stud Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.
Brick Contact Customer Service
Other or unsure? Contact Customer Service
Tools Needed for Assembly
• stud finder ("edge to edge" stud finder is recommended)
• drill
• 1/4" bit for concrete and cinder block wall
• 5/32" bit for wood stud or joist
• level
• 8 mm open end wrench
Table of Contents
Parts List..........................................................................................................................................................................3, 4
Install Outer Channel to Ceiling Plate....................................................................................................................................4
Installation to Wood Joist Ceiling or Wood Stud Wall ...........................................................................................................5
Installation to Solid Concrete Ceiling or Concrete/Cinder Block Walls ..................................................................................6
Installing Inner Channel and Routing Cables .........................................................................................................................7
Installing Projector Mount ..................................................................................................................................................8-9
Installing Projector ................................................................................................................................................................9
Adjusting Mount Extension.................................................................................................................................................10
Install Cable Covers ............................................................................................................................................................10
Projector Alignment ............................................................................................................................................................11
2 of 11
Visit the Peerless Web Site at www.peerlessmounts.com
ISSUED: 1-11-08 SHEET #: 055-9495-2 10-16-08
For customer care call 1-800-865-2112 or 708-865-8870.
Before you begin, make sure all parts shown are included with your product.
Parts List
Description Qty.
A ceiling plate 1 055-1773 055-4773 055-2773 055-1773 055-4773 055-2773
B outer channel 1 SEE CHART SEE CHART SEE CHART SEE CHART SEE CHART SEE CHART
C inner channel 1 SEE CHART SEE CHART SEE CHART SEE CHART SEE CHART SEE CHART
D clamp plate 1 055-1771 055-4771 055-2771 055-1771 055-4771 055-2771
E vertical mounting plate 1 055-1876 055-4876 055-2876 055-1876 055-4876 055-2876
F horizontal mounting plate 1 055-1787 055-4787 055-2787 N/A N/A N/A
G M5 x 16 mm socket pin screw 2 520-1161 520-2161 520-2161 520-1161 520-2161 520-2161
H #14 x 2.5 wood screw 2 5S1-015-C03 5S1-015-C04 5S1-015-C04 5S1-015-C03 5S1-015-C04 5S1-015-C04
J Alligator® concrete anchor 2 590-0097 590-0097 590-0097 590-0097 590-0097 590-0097
K M6 x 12 mm socket pin screw 2 520-1050 520-2050 520-2050 520-1050 520-2050 520-2050
L M6 x 10 mm socket pin screw 4 520-1066 520-2066 520-2066 520-1066 520-2066 520-2066
M M5 x 10 mm socket pin screw 4 520-1063 520-2063 520-2063 520-1063 520-2063 520-2063
N serrated locknut 2 530-1027 530-2042 530-2042 530-1027 530-2042 530-2042
O flat washer 6 540-1078 540-2078 540-2078 540-1078 540-2078 540-2078
P 4 mm security allen wrench 1 560-9646 560-9646 560-9646 560-9646 560-9646 560-9646
Q cable cover 2 SEE CHART SEE CHART SEE CHART SEE CHART SEE CHART SEE CHART
EXA,
EXB
Part #
EXA-S,
EXB-S
Part #
EXA-W,
EXB-W
Part #
EXC
Part #
EXC-S
Part #
EXC-W
Part #
OUTER CHANNEL, INNER CHANNEL AND CABLE COVER
PART NUMBER CHART
extendable outer channel (B) inner channel (C) cable cover (Q)
Model# length part# part# part#
EXA 8.69" - 12.79" 055-1779 055-1778 055-1809-2
EXA-S 8.69" - 12.79" 055-4779 055-4778 055-4809-2
EXA-W 8.69" - 12.79" 055-2779 055-2778 055-2809-2
EXB 12.69" - 20.69" 055-1776 055-1775 055-1809-1
EXB-S 12.69" - 20.69" 055-4776 055-4775 055-4809-1
EXB-W 12.69" - 20.69" 055-2776 055-2775 055-2809-1
EXC 19.14" - 32.9" 055-1770 055-1769 055-1809
EXC-S 19.14" - 32.9" 055-4770 055-4769 055-4809
EXC-W 19.14" - 32.9" 055-2770 055-2769 055-2809
Visit the Peerless Web Site at www.peerlessmounts.com
3 of 11
ISSUED: 1-11-08 SHEET #: 055-9495-2 10-16-08
For customer care call 1-800-865-2112 or 708-865-8870.
Part List Continued
Parts may appear slightly different than illustrated.
A
B
C
H
E
F
G
KL MN
D
J
O
P
Install Outer Channel to Ceiling Plate
Attach outer channel (B) to ceiling plate (A) using
1
four M6 x 10 mm socket pin screws (L) as shown.
Tighten screws with security wrench (P).
Visit the Peerless Web Site at www.peerlessmounts.com
4 of 11
Q
L
A
B
ISSUED: 1-11-08 SHEET #: 055-9495-2 10-16-08
For customer care call 1-800-865-2112 or 708-865-8870.
Loading...