WARNING
ENG - This product is designed to be installed on wood stud, solid concrete or cinder block walls. Hardware is
included for wood stud, solid concrete and cinder block installation. Before installing make sure the supporting
surface will support the combined load of the equipment and hardware. Screws must be tightly secured. Do
not overtighten screws or damage can occur and product may fail. Never exceed the Maximum Load Capacity.
Always use an assistant or mechanical lifting equipment to safely lift and position equipment. Be careful not to
pinch fi ngers when operating the mount. For support please call customer care at 1-800-865-2112.
Tools Needed for Assembly.
ENG
ENG
Symbols
x3
Screws must get at least
ENG
ENG
WARNING
ENG
Do not overtighten screws.
#
ENG
Skip to step.
three full turns and fi t snug.
5/32"
(4mm)
5mm
(3/16")
5/16"
(8mm)
3/8"
(10mm)
To properly tighten screws: Tighten until screw
ENG
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
1
2
3
+1/2
4
2
2014-09-24 #:203-9450-1
ENG
Parts (Before beginning, make sure you have all parts shown below).
Parts List
A wall plate 1 201-T5946
B adapter bracket 2 200-T5946
C 4 mm allen wrench 1 560-1727
D concrete anchor 4 590-0320
E #14 x 2.5" wood screw 4 520-D1033
F M8 x 25mm 4 520-5027
G washer 4 540-D9406
H spacer 4 540-1059
ESF655P
Part #Description Qty
G
washer
(4)
H
spacer
(4)
A
wall plate
F
M8 x 25mm
1
(1)
(4)
(2)
B
adapter bracket
D
8mm concrete anchor
#14 x 2-1/2" wood screw
Wood stud wall. Concrete/Cinder block.
ENGENG
C
allen wrench
(4)
(4)
E
(1)
1a
1b
1a
WARNING
ENG - When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that
the wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".
3
2014-09-24 #:203-9450-1
1a-1
ENG
Use stud fi nder to locate and
mark stud center lines.
1a-2
ENG
Level wallplate. Mark mounting holes on stud
center lines.
4
2014-09-24 #:203-9450-1