
aution:
C
ny Changes or modifications not expressly approved by the party responsible for
A
compliance could void the user's authority to operate the equipment.
T
his device complies with part 15 of the FCC Rules. Oper ation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not oc cur in a partic ular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
eorient or relocate the receiving antenna.
—R
—I
ncrease the separation between the equipment and receiver.
onnect the equipment into an outlet on a circuit different from that to which the receiver is
—C
connected.
onsult the dealer or an experienced radio/TV technician for help.
—C

pecific Absorption Rate (SAR) information
S
S
AR tests are conducted using standard operating positions accepted by the FCC with the
phone transmitting at its highest certified power level in all tested frequency bands, although
the SAR is determined at the highest certified power level, the actual SAR level of the phone
while operating can be well below the maximum value, in general, the closer you are to a
wireless base station antenna, the lower the power output.
Before a new model phone is a available for sale to the public, it must be tested and certified to
the FCC that it does not exceed the exposure limit established by the FCC, Tests for each
phone are performed in positions and locations (e.g. at the ear and worn on the body) as
required by the FCC.
For body worn operation, this model phone has been tested and
guidelines when used w ith an accessory designated for t hi s pr odu ct or when used with an acces sory tha t
contains no metal and that positions the handset a minimum of 0.5cm from the body.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.
eets the FCC RF exposure
m