Paxton PROXIMITY LCD reader User Manual

11/01/2011

Ins-30091 PROXIMITY LCD reader

Technical Support

01273 811011 [e-mail]

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Suitability

Security-sensitive doors

Paxton

Wet environments

Mounted on metal surface

The full colour backlit LCD screen can be congured to display images
of the customer's choice. For example, an image using a company

name/logo could be used as the default display on each reader around
the site.

The reader comes with four preloaded images. These can be replaced
using a free uploader program available from our website via any

Net2Air USB bridge or a Net2Air USB dongle.

If you wish to update these images, you should ensure that you have a
suitable Net2Air device as one is NOT supplied with the reader.

Readers mounted together

Fitting

The LCD display is best positioned at eye level for
ease of reading.

It is mounted using the backplate and xings

provided and can be positioned to allow the display
of portrait or landscape images.

300 mm

between readers

Fix the mounting plate to the wall, noting the

position of the orientation arrow (see diagram).

Make a hole in the wall to take the reader cable and

feed this through. Ensure there will be sufcient

slack to allow the reader to slide over the mounting
plate during installation.

Present the reader to the mounting plate so that the slots pass over the side tabs in the plate.

Slide the reader down the plate until the retaining pin clicks into position.

A tool is provided with the reader to depress this pin should the reader ever need to be removed.

Image display

The unit comes with four preloaded images. These relate to the 3 LED's (Green, Amber and Red) on a
standard Paxton reader plus a default image.

Once a token has been read, the control unit establishes the access permissions of that user. Access is
granted or denied as appropriate with the designated image displayed. For example, if access is denied
the image assigned could show "Please return to Reception".

Page 1

R

R

Wiring

Connection to a control unit

reader port

Connection modules

Reader junction box (325-020)

This module can be used to provide a connection point

for the reader RJ45 plug. The terminals on the module

are then wired colour for colour to the controller.

Alternatively, the reader can be wired directly into the
screw terminals of the control unit by rst cutting off
the RJ45 plug and stripping back the wires in the cable.

Further information on how to purchase Installer Tools is available at:

http://paxton.info/841

Reader port module (325-030)

This module may be purchased separately to speed up
the installation and replacement of readers.

The reader port module is designed to convert the
standard reader ports on Switch2 and Net2 controllers

to accept one or two RJ45 connections. Pull off the

screw terminal block from the reader port and simply
replace it with this module.

Cable extensions

Readers can be extended using Belden CR9540 10-core overall screened cable to a maximum of 100 metres.

Page 2