14/11/2011
Ins-30042 - OEM Reader keypad kit
Suitability
Wet environments
Security-sensitive doors
Fitting
Exit button
(push to make)
+12V DC
*
Grey
White
Mounted on metal surface
Readers mounted together
Black
-
+
300mm
between readers
9-15V DC
(fuse rating 1A)
0V
12V DC release current rating
must be less than 1A.
* The diode current rating must be
equal to or greater than the current
required to drive the release.
User cards are NOT supplied with this unit. Please supply your own user cards.
Page 1
Please read the following notes before installing
Electrical shock can cause injury or death. Remove all power before making any
electrical connections, performing maintenance or repair.
Mains electrical connections should be made only by qualied personel in
accordance with local regulations.
Safety goggles should be worn while using power tools.
In this kit you will nd the following items. If you nd that any of the
parts are missing or damaged, please notify your supplier.
x1
1
2
4
7
8
*
0
3
5
6
9
x10
x1
x1
x1x1x4 x2
x2 x4 x2 x3
Other Items Required
Fail open or fail closed lock Push to make exit button
5.5 mm masonary drill bit 10 mm masonary drill bit
Electric drill Screwdrivers
Safety goggles Hammer
Page 2
Fitting the keypad
Step 1: Carefully mark out the mounting holes for the keypad and the hole of the cable feed.
Step 2: Drill the marked holes for the mounting points and the cable feed. When drilling the holes, ensure
that you are aware of any hidden cables or pipes. Once the holes have been drilled, t the supplied wall
plugs and feed the cable through the cable feed hole before securing the reader to the wall using the
screws supplied.
Step 3: Fit the keypad to the mounting plate and secure using the screw provided.
Fitting the power supply
Step 1: Mark the mounting points for the power supply. Drill the four holes, t the wall plugs and
screw the power supply to the wall.
Step 2: Run the black cable from the reader to the power supply. Attach the white striped wire to the
12V power supply terminal, and the plain black wire to the 0V power supply terminal. The cables can be
secured in place using the cable clips provided. Please ensure that the cable is not damaged when tting
the cable clips. Connect the power lead provided.
Step 3: Using the guides provided, make a gap for the cables on the power supply cover. Fit the cover,
feeding the cables through the gap. Do not connect the power supply to the mains until the lock is tted.
Once this is done, power the system up, and start programming the system.
Indoor use only
Page 3
Loading...