Paxar TC941XQR User Manual

Quick Reference

Switching Between Print Modes—Peel Mode or Non-peel Mode

1. Press the Pizza Hut® button on your keypad/terminal.

2. Press the Cheese button to display “NON-PEEL MODE” or “PEEL MODE” until the

print mode you want is displayed.

3. Press the Pizza Hut

4. The printer LED will blink red. Press the printer FEED button. The printer LED will

turn green, indicating the printer is ready. Default mode is non-peel.

Loading Labels for Hot-Hold (Peel) Labeling

Follow these instructions to print and peel labels from the backing paper one at a time.

button to save your choice.

1. Press the cover release levers towards

SSuuppppllyy HHoollddeerr GGuuiiddeess

you to release the cover and then lift it open.

2. Pull out the peel door located on the front of the printer to display the peel roller and the peel bar.

3. Remove a supply holder guide from one

4. Slide a roll of labels onto the supply

5. Place the supply holder guide back onto

PPeeeell DDoooorr

PPeeeell RRoolllleerr

PPeeeell BBaarr

Push the label core adapters into the ends of the supply and center the labels on the supply holder. The number 4 (on the supply holder) should be visible on either side of the supply holder guides.

6. Place the loaded supply holder in the slots in the label roll mount. Push the plastic line attached to the end of the supply holder out of the way.

7. Remove the first two labels from the

backing paper.

8. Feed the labels, printing side up, under the supply guides and over the platen roller.

end of the supply holder.

holder.

the end of the supply holder.

LLaabbeell RRoollll MMoouunntt

9. Feed the backing paper under the peel

roller and through the peel door opening.

PPeeeell RRoolllleerr

PPeeeell DDoooorr OOppeenniinngg

10. Push the peel door closed and close the cover

until it locks in place.

11. Press the FEED button. A label will peel off of the backing paper.

12. Remove the peeled label and another one prints.

Loading Labels for Dough and MRD (Non-Peel) Labels

Follow these instructions to print multiple labels on a continuous strip.

SSuuppppllyy HHoollddeerr GGuuiiddeess

1. Press the cover release levers towards the

front of the printer to release the cover, then lift it open.

2. Remove the supply holder guide from one end of the supply holder.

3. Slide a roll of labels onto the supply holder.

4. Place the supply holder guide back onto the end of the supply holder. Push the

label core adapters into the ends of the supply and center the labels on the supply holder. The number 4 (on the supply holder) should be visible on either side of the supply holder guides.

5. Insert the ends of the supply holder into the slots in the label roll mount. Push the plastic line attached to the end of the supply holder out of the way.

6. Feed the labels, printing side up, under the

supply guides and over the platen roller.

SSuuppppllyy GGuuiiddees

DDiiaal

7. Turn the dial to move the supply guides so

they barely touch the edges of the backing paper.

8. Close the cover until it locks in place.

PPllaatteenn RRoolllleer

9. Press the FEED button. The indicator light

should be GREEN.

IF YOU NEED HELP, CALL 1-888-666-9414. IF YOU NEED MORE PAPER LABELS, CALL ONE OF THE FOLLOWING:

PrimeSource: 800-397-4737 (order item #85221) Wasserstrom: 800-999-9277 (order item #374014) Unified Food Co-Op: 800-444-4144 (order item #374014)