PASCO ME-6821A User Manual

Instruction Sheet

Photogate Mounting Bracket

ME-6821A

012-05013D

Additional Equipment Required: Part Number

Projectile Launcher ME-6800,

ME-6801 or
ME-6823

(2) Photogate Heads ME-9498A

Additional Equipment
Recommended:

Shoot-the-Target Accessory ME-6805

Time-of-Flight Accessory

Part Number

ME-6810

Introduction

The PASCO Model ME-6821 Photogate Mounting Bracket is
designed for use as an accessory to the PASCO Projectile
Launcher. It attaches to the front of the launcher and holds
one or two photogates in parallel.

2. Align the bracket assembly with the front of the Projectile

Launcher and slide the alignment key down the groove of
the barrel.

NOTE: The flat side of the square nut must face the inside of the projectile
launcher groove as shown.

3. Slide the Photogate Mounting Bracket to th e des ired posi-

tion and tighten the thumbscrew to secure.

4. Unscrew the small rod clamp from the Photogate Head.

(Save the clamp and its 6-32 x 5/8" thumbscrew for later
use.)

5. Attach each Photogate Head to the Mounting Bracket

with one of the 6-32 x 3/4" thumbscrews included with
the bracket assembly .)

Experiments

Please refer to the experiment guide that comes with the appli­cable PASCO equipment for specific experiments.

Setup procedure

1. Loosen the thumbscrew of the Photogate Mounting

Bracket.

®

Photogate Mounting Bracket Technical Support

Technical Support

For assistance with any PASCO product, contact PASCO at:
Address: PASCO scientific

10101 Foothills Blvd.
Roseville, CA 95747-7100

Phone: [phone] (worldwide)

800-772-8700 (U.S)
Fax: [phone]
Web: www.pasco.com
Email: [e-mail]

Limited Wa r ranty

For a description of the product warranty, see the PASCO catalog.

Copyright

The PASCO scientific 012-05013D Photogate Mounting Bracket Instruc­tion Sheet is copyrighted with all rights reserved. Permission is granted to

non-profit educational institutions for reproduction of any part of this man­ual, providing the reproductions are used only in their laboratories and
classrooms, and are not sold for profit. Reproduction under any other cir­cumstances, without the written consent of PASCO scientific, is prohibited.

Trademarks

PASCO, PASCO scientific, DataStudio, PASPORT, and ScienceWorkshop
are trademarks or registered trademarks of PASCO scientific, in the
United States and/or in other countries. All other brands, products, or ser­vice names are or may be trademarks or service marks of, and are used to
identify, products or services of, their respective owners. For more infor­mation visit www.pasco.com/l egal.

2

®