Parrot S801 User Manual

STRUCTURE AND FUNCTION

1

English

SEE-THROUGH

WINDOW

WASTE BIN

CASTORS

BODY

POWER CORD

POWER SWITCH

TOP COVER

AUTO PAPER FEEDING

MANUAL PAPER FEEDING

MANUAL CD FEEDING

Fwd Auto Rev

MACHINE SETUP

2

1. Place shredder in an upright position on a flat, level surface, do not slant.

2. Plug in power cord.

3. Ensure the shredder is unplugged after use.

4. Do not place shredder near airconditioners, wet, hot or dusty places.

5. Do not place shredder near direct sunlight or near direct heat.

OPERATION GUIDE

1. Please make sure the power switch is in "OFF mode before plugging into " power source.

2. The machine is ready to use when switched to “AUTO”.

3. Ensure the following when feeding paper into the shredder:

3.1. Make sure the paper activates the sensor in the middle of the paper in-throat and that the
paper is straight.

3.2. Feed between 1 and 8 sheets of paper, no larger than A4 80g, through at a time.

4. Place the machine in reverse mode if there are any paper jams.
(Full waste bins could cause paper jams)

5. Remove waste when the bin is full. Always switch the
machine off before removing the waste bin.

English

Pressed down -

switched on

Pressed up -

switched off

ü

The S801 Shredder has a an “AUTO-FEEDING” system. This enables the user to place the pages for
shredding into the Auto-Feed tray and walk away. The shredder will automatically feed pages into the
paper throat and stop when all the pages have been shredded. Feed maximum of 60 A4 80gsm pages.

60pg

Auto-feed

SPECIFICATIONS

3

WARNINGS

Dangerous! Don’t put your fingers into the paper in-throat of the shredder. Injury or

loss of limb may occur.

Do not plug the machine in with wet hands as it may cause electrocution or electrical
shock.

English

Noise level

Security level

Cut Size

Cross Cut

Strip Cut

Entry Width

Shred Capacity (80g A4)

Waste Bin Capacity Litres

Waste Capacity A4 Pages

Speed (Meters per min)

Continuous Run Time

Motor

Plug

Dimensions

Carton Dimensions

Nett Weight

Auto Start/Stop

Forward/Reverse

Auto Reverse Overload Function

Shred CD’s and Credit Cards

Staple Friendly

Castors

Use

ü

55dB

S3 Confidential

4 x 30mm

225mm

8 Sheets

22 Litre

280-290 Pages

1.8m/min

5min

145Watt

RSA 3pin

345 x 269 x 555mm

9.16kg

ü

ü

ü

Plastic

General Office

425 x 345 x 628mm

ü

801

ü

4

WARNINGS (Continued)

Do not dismantle or attempt to repair. Contact Parrot Products for repairs.

In case of malfunction, stop operating the shredder immediately. Contact your nearest
supplier or dealer.

Do not damage the power cord or place any heavy objects on the cord as it may
cause a malfunction or an electrical short.

Keep out of reach from small children to prevent injury. This machine is not a toy.

CAUTION

Do not insert ties, necklaces, hair, sleeves etc. into the shredder. In the event of this
happening, turn the power switch to reverse mode and remove the said article from the
in-throat of the machine.

Please do not operate the machine near heating or cooling machines, wet or dusty
places. Do not operate the shredder if it is over-heating. This may cause fire, electrical
shock or malfunction.

The weight of the shredder is concentrated on the upper part of the machine, making it
top heavy. Please place the machine upright on a flat level surface to avoid it falling-over
and causing damage or injury.

Use the correct voltage for the machine to avoid overloading the power
supply.

Ensure the machine is unplugged:
before moving to another location
before cleaning the waste bin
when not in use

l

l

l

As the shredder operates on electricity, please do not spray water into the machine.
This will cause electrical shock or short circuit that may cause injury or damage the
machine.

This shredder is a machine made for shredding
for any other purpose. Never feed films, OHP films, label paper, clothing or plastics into
the shredder. Remove any pins, clips, staples, etc. from the paper before shredding.
These objects may cause malfunctions or damage the shredding blades.

specialized paper, and is not to be utilised

English

5

MAINTENANCE

• When maintaining/cleaning the shredder, switch the power off.

• Use a clean cloth, detergent and hot water.

• Do not use solvents to clean the machine casing as this will cause fading.

• Do not spill any water in the machine head as this may cause electrical shock.

• Clean out waste bin before it is full as it may cause a blockage.

After feeding the
the shredder does
not shred.

paper,

1. Is the power plug safely
and securely inserted
into the socket?

2. Does the Auto Feed
stop when feeding paper?

3. The motor has overheated, so
the protective device is
activated.

4. Is there a paper jam?

1. Re-insert the power
socket.

2. Feed a couple of pages through
the manual feeding slot and place
paper back on Auto Feed tray. *

3. Switch the machine off for 30
minutes to cool down, then try
again.

4. Adjust the switch to reverse
position to remove the jammed
paper.

plug into the

PROBLEM CAUSE

SOLUTION

Shredder too noisy.

Shredder jams whilst
shredding.

1. Shredding capacity is
overloaded.

2. Paper is wider than the
shredder opening.

3. Paper is not placed upright.

1. Check if machine is placed
a flat, level surface.

on

1. Move shredder to a
surface.

flat, level

1. Put less paper when

2. Push REV button and remove
paper, fold it and place in
shredder again.

3. Put the paper in straight.

shredding.

1. Is the sensor (located in
centre of the paper in-throat)
covered by paper scraps or
paper dust?

the

1. Use a brush to clear
scraps or dust from the
electronic eye.

the paper

After the paper
shredding is completed,
the shredder does not
stop shredding.

BRIEF PROBLEM SHOOTING

English

* Auto Feed only works reliably with clean, uniform paper.

• This equipment guarantee applies to end users (“customers”)

• The guarantee applies to the supplied products and all their components but not to their installation or
configuration or to the services provided by the dealer. Manuals and any software supplied on a
separate data medium are excluded from the guarantee.

• The guarantee provides for products that, despite proper care and use, have demonstrably developed
defects due to faulty workmanship and/or materials. To be replaced at our discretion free of charge.
The guarantee does not cover normal wear and tear. Alternatively we reserve the right to replace the
defective product with a successor model.

• Claims under the guarantee cannot be made if the defect or damage was caused by improper care or
use. Improper care or use includes the following:
o Opening the product.
o End user installation.
o Altering the product.
o Repairs or work done by persons not authorised by us.
o Product fitted to another product or device not authorised by us.
o Defects or damage caused by dropping, breaking, lightning or ingress of moisture.

• Any further claims due to damage are excluded arising from the use of our product, provided this was
not due to gross negligence and/or intent on our part. Parrot Products is not liable in any circumstance
for down-time, loss of profit, loss of data or third party penalties.

• Claims under the Guarantee must be made as soon as the defect is noticed.

• An invoice showing the date of purchase must be presented as proof. Each claim under the guarantee
is accepted with express reservation that subsequent investigations confirm the validity of the claim.

• The cost of materials and labour will be borne by us. This guarantee excludes the costs of transport,
postage or freight.

• The guarantee period starts on the day of purchase by the end user and is valid for 12 months. A
successful claim under guarantee does not extend the guarantee period.

GUARANTEE

6

English