Paradox TM40 Quick Install Manual

Printed in Canada | 09/2011

TM40 Quick Install Guide

TM40 Touch Interface
Module
Quick Install Guide

Installation

1. Using a screwdriver, pry the front housing assembly from
the back plate.

2. Mount the back plate to the wall by securing a M3.5 or #6
screw in each of the dedicated mounting holes and tamper
hole. Ensure that the UP arrow on the back plate is in the up
position.

3. Assemble both items by joining the hooks on the back plate
to their respective slots on the front housing assembly.

NOTE: Make sure to connect the unit’s 5-pin connector before
proceeding to the next step.

Front housing
assembly

Hooks on
back plate

TM40-EI01

TM40 Quick Install Guide

Printed in Canada | 09/2011

4. Secure the front housing assembly to the back plate by
snapping it into place.

The installation process is complete.

TM40 to Panel Connections

As shown in the Wiring Diagram, the red, black, green, and yellow
wires on the TM40 must be connected to their corresponding
labeled terminals on the control panel’s PCB. The blue wire is
connected to either a keypad zone or external temperature
sensor.

Wiring Diagram

Technical Specifications

Power Input 9 to 16 Vdc

Consumption 110 mA

Display 16-bit, color LCD; 5.4 x 9.5 cm (2.1 x 3.7 in.)

Resolution 480 x 272 pixels

Dimensions 12.4 x 8.1 x 1.6 cm (4.9 x 3.2 x 0.7 in.)

Weight 0.15 kg (0.33 lbs.)

Humidity 5-90%

Sensors Indoor temperature sensor

Standards Complies with EN 50131 Security Grade 3 Class II

CONTROL PANEL

BLUE

ZONE/TEMP

RED

BLK

GRN

YEL

Kpd 1 or Kpd 2

N.C.COM

AUX-GRN

YEL

AUX

+

Warranty : For complete warranty information on this product, please

refer to the Limited Warranty Statement found on the Web site
www.paradox.com/terms. Your use of the Paradox product signifies your
acceptance of all warranty terms and conditions.
© 2011 Paradox Ltd. All rights reserved. Specifications may change
without prior notice. www.paradox.com