
2.4GHz Expandable Cordless Phone System
Model No. KX-TG2382B
Pulse-or-tone-dialing capability
Operating Instructions
Charge the battery for about 15 hours before initial use.
PLEASE READ BEFORE USE AND SAVE.
Contents:
Location of Controls 2
Connections 4
Battery Installation/Battery Charge 5
Recording a Greeting Message 6
Making/Answering calls with the Handset 7
Caller ID Service 8
Automatic Answering Operation 9
Listening to Messages 9
Important Safety Instructions 10
FCC and Other Information 12

KX
-
TG
2382
G
R
E
E
GREETI
N
G
ING
R
E
C
REC
C
H
E
C
K
CHECK
E
R
A
S
E
ERASE
REPEATREPEAT
SKIPSKIP STOP
MESSAGE PLE PLAYBACKBACK
CHARGECHARGE
IN USE IN USE HOLD HOLD
VOLUMEVOLUME
E
X
PA
N
D
A
B
LE
T
O
3
1
2
3
HANDSEHANDSET LOCT LOCATORTOR INTINTERCOMERCOM
MIC
A
L
L
1
2
3
HANDSEHANDSET LOCT LOCATORTOR INTINTERCOMERCOM
A
L
L
(ERASE) Button
(GREETINGÒREC) Button
(GREETINGÒCHECK) Button
(STOP) Button
(REPEAT) Button
(SKIP) Button
VOLUME Buttons ,
(ANSWER!ON)
Button and Indicator
CHARGE Indicator
HANDSET LOCATOR/INTERCOM
Buttons
(
(ALL), (1)
to
(3))
IN USE/HOLD
Indicator
(MESSAGEÒPLAYBACK)
Button
Charge Contacts
Antenna
Hook
Display
Please read IMPORTANT SAFETY
INSTRUCTIONS on page 10 before use.
Read and understand all instructions.
Location of Controls

–4–
Connections
■ Connect the AC adaptor and the telephone line cord.
• USE ONLY WITH Panasonic AC ADAPTOR PQLV10.
• The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)
Hooks
Raise the
antenna.
Fasten the cords to prevent
them from being disconnected.
AC Adaptor
Telephone Line
Cord
Power Outlet
(AC 120 V, 60 Hz)
Single-Line Telephone Jack
(RJ11C)
Hooks
Hooks
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
• USE ONLY WITH Panasonic AC ADAPTOR PQLV1.
• The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)

–5–
Battery Installation/Battery Charge
■ Recharge
Recharge the battery when:
–"Recharge" is displayed,
–" " flashes on the display, or
– the handset beeps every minute while it is in use.
• Clean the handset and the base unit charge contacts with a soft, dry
cloth once a month. Clean more often if the unit is subject to grease,
dust or high humidity. If not, the battery may not charge properly.
• If the battery is fully charged, you do not have to place the handset on the
base unit or the charger until "Recharge" is displayed and/or " "
flashes. This will maximize the battery life.
• The battery cannot be overcharged.
■ Battery installation
1 Install the battery in the handset.
2 Close the handset cover.
■ Battery charge
To power the handset, charge the battery.
Place the handset on the base unit or the charger for about 15 hours before
initial use.
A nickel metal hydride battery that is recyclable powers the
product you have purchased. Please call 1-800-8-BATTERY
for information on how to recycle this battery.