Panasonic SU-MED640P Operating Instructions Manual

64-CHANNEL INTEGRATED AMPLIFIER

Operating Instructions

P/N: SU-MED640P

Panasonic

Safety Precautions

Before using this unit please read these operating instructions carefully. Take special care to follow the
warnings indicated on the unit itself as well as the safety suggestions listed below. Keep these precau­tions handy for future reference.

The unit may be used only in the operating conditions and positions specified manufacturer.
Unless otherwise agreed the following applies to this unit.

1. Pollution category: II (Indoor use only)

2. Installation over voltage category: II

3. Altitude: max.2,000 m

Placement

Avoid placing the unit in areas of:

- direct sunlight

- high temperature

- high humidity

- excessive vibration

- uneven surfaces (Place the unit on a flat level surface.)
Such conditions might damage the cabinet and/or other component parts and thereby shorten the unit's
service life.

Stacking

Never place heavy items on top of the unit or the AC power cord.

Voltage

- It is very dangerous to use a “high voltage” AC power source such as for an air conditioner. A fire might
be caused by such a connection.

- A DC power source can not be used. Be sure to check the power source carefully.

Power cord protection

- Avoid using AC power cords with cuts, scratches, or poor connectors, as this may result in fire or electric

shock. Excessive bending, pulling or slicing of the cord should also be avoided.

- Do not pull on the cord when you are disconnecting the power, as this could cause an electric shock.

Grasp the plug firmly when you disconnect the power supply.

- Never touch the plug with wet hands or a serious electric shock could result.

Foreign Materials

- Ensure that no foreign objects (e.g. - needles, coins, screwdrivers), accidentally fall into the unit. Other-

wise, a serious electric shock or malfunction could occur.

- Be extremely careful about spilling water or liquid on or into the unit, as a fire or electric shock could

occur (Disconnect the power plug and contact your dealer immediately if this occurs).

- Avoid spraying volatile chemicals (e.g.- insecticides, alcohol, paint thinner) on or into the unit as they

contain flammable gases which can be ignited.

- Insecticides, alcohol, paint thinner and similar chemicals should never be used to clean the unit as they

can cause flaking or cloudiness to the cabinet finish.

3

Service

- Never attempt to repair, disassemble or modify the unit if there seems to be a problem. A serious electric

shock could result if you ignore this precautionary measure.

- If a problem occurs during operation (smoke is detected, etc.) contact your dealer immediately.

- Disconnect the power supply if the unit will not be used for a long time. Otherwise the operation life could

be shortened.

Safety-related symbols used on equipment and documentation:

Environmental conditions

- Indoor use.

- Altitude up to 2000 m.

- Temperature: 5 - 40 C.

- Maximum relative humidity 80% for temperatures up to 31 C decreasing linearly to 50% relative humidity

at 40 C.

- Mains supply voltage fluctuations not to exceed +/- 10% of the nominal voltage.

Maintenance

Clean the cabinet, panel and controls with a soft cloth lightly moistened with mild detergent solution.
Do not use any type of abrasive pad, scouring power or solvent such as alcohol or benzine.

Fuse (F1)

Rating: 125 V, 630 mA

Frame or chassis
TERMINAL