Panasonic SBPF-960-GCP Service manual

T

Specification

ORDER NO. MD0707024CE

Speaker System

SB-PF960GCP

Colour

(K)... Black Type

ype 2 way, 2 speaker system (Bass reflex)

Speaker unit(s) Impedance 7 Ω

1. Woofer 20 cm cone type

2. Tweeter 6 cm cone type

Input power (IEC) 220 W (Max)

Output sound pressure 88 dB/W (1.0 m)

Cross over frequency 4kHz

Frequencyrange 60 Hz to 24 kHz (-16 dB)

69 Hz to 23 kHz (-10 dB)

Dimensions (W x H x D) 250 x 411 x 338 mm

Mass 5.2 kg

Notes :

1. Specifications are subject to change without notice.

Mass and dimensions are approximate.

2. Total harmonic distortion is measured by the digital spectrum
analyzer.

© 2007 Matsushita Electric Industrial Co. Ltd.. All
rights reserved. Unauthorized copying and
distribution is a violation of law.

SB-PF960GCP

1 System Combination

1.1. System Breakdown

Note :

The table below show the breakdown for speaker combinations used in main unit systems.

System SF-AK960GCPK
Music center SA-AK960GCPK

Front speakers

Speaker system SB-AK960GCPK
Surround speakers SB-PS960GCPK

Subwoofer SB-WAK960GCPK
Active subwoofer SB-WAK860GCPK

SB-PF960GCPK

2

2 Assembling and Disassembling

“ATTENTION SERVICER”

Some chassis components may have sharp edges. Be careful when disassembling and servicing.

1. This section describes procedures for checking the operation and replacing the main components.

2. For reassembly after operation checks or replacement, reverse the respective procedures.

Special reassembly procedures are described only when required.

3. Select items from the following index when checks or replacement are required.

4. Refer to the Parts No. on the page of “Parts Locatio n and Replacement Parts List” (Section 5), if necessary.

Below is the list of disassembly sections

• Disassembly of Speaker cabinet

• Disassembly of Tweeter (SP1)

• Disassembly of Woofer (SP2)

SB-PF960GCP

3

SB-PF960GCP

2.1. Disassembly of Speaker
cabinet

Step 4: Upset the speaker unit as shown above.

Step 5: Insert a flathead screwdriver above the steel rule as

arrow shown.

Step 1: Remove 4 screws.

Step 2: Upset the speaker unit as shown shown above.

Step 3: Insert a steel rule into the grooves of the front panel.

Push the steel rule as arrow shown.

Caution:

Do not exert strong force as it may damage the front panel.

Step 6: Apply light force along the bosses to push up the front
panel.

4