Panasonic NRB32SX1XE, NRB32SW1WE Operating Instructions

10.16. Replacement of Refrigerator

10.17. Changing The Doorway Direc-

Lamp

1. Remove the refrigerator lamp cover by pulling forward.

2. Loosen the lamp and replace it.

tion

Warning: Make sure the unit is unplugged.

1. Unscrew the screw fixing the Top Hinge Cover and
remove it.

2. Disconnect the Display Connector.

3. Unscrew the screws fixing the Top Hinge and remove it.

Note : The grounding wire is only for protecting the prod­uct (especially for display) against static electric forming
at production line.

There is no function at daily use.

64

4. Remove the Refrigerator Door.

7. Lie down the appliance to the back. (min: 300mm)

CAUTION:Do not damage the outer condenser.

5. Unscrew the two screws which are fixing the Middle
Hinge and remove the Washer.

6. Remove the Freezer Door.

8. Unscrew the Stationary Foot under the Bottom Hinge.

9. Unscrew the Bottom Hinge fixing screws and remove it.

65

10. Unscrew the Stationary Foot on the left side.

11. Unscrew the side panel fixing screw.

13. Screw the Stationary Foot for the right side.

14. Insert the Flat screwdriver into the gap between the
Spacer and the Bottom Hinge. Then pry off the Spacer.
Unscrew the pin of hinge, rotate the Bottom Hinge 180°.

12. Then use that screw for the right side.

NOTICE

Be careful to screw stronger. Because the screw
hole has blocked with the expanded polyurethane.

15. Screw the pin to the same hole from different direction.
Paste the Spacer to the opposite side of the Bottom
Hinge.

66